Search

Purpose: The risks of RF‐induced heating of active implantable medical device (AIMD) leads during MR examinations must be well understood and realistically assessed. In this study, we evaluate the potential additional risks of broken and abandoned (cut) leads. Methods: First, we defined a generic AIMD with a metallic implantable pulse generator (IPG) and a 100‐cm long lead containing 1 or 2 wires. Next, we numerically estimated the deposited in vitro lead‐tip power for an intact lead, as well as with wire breaks placed at 10 cm intervals. We studied the effect of the break size (wire gap width), as well as the presence of an intact wire parallel to the broken wire, and experimentally validated the numeric results for the configurations with maximum deposited in vitro lead‐tip power. Finally, we performed a Tier 3 assessment of the deposited in vivo lead‐tip power for the intact and broken lead in 4 high resolution virtual population anatomic models for over 54,000 MR examination scenarios. Results: The enhancement of the deposited lead‐tip power for the broken leads, compared to the intact lead, reached 30‐fold in isoelectric exposure, and 16‐fold in realistic clinical exposures. The presence of a nearby intact wire, or even a nearby broken wire, reduced this enhancement factor to <7‐fold over the intact lead. Conclusion: Broken and abandoned leads can pose increased risk of RF‐induced lead‐tip heating to patients undergoing MR examinations. The potential enhancement of deposited in vivo lead‐tip power depends on location and type of the wire break, lead design, and clinical routing of the lead, and should be carefully considered when performing risk assessment for MR examinations and MR conditional labeling. [ABSTRACT FROM AUTHOR]

Purpose. To characterize and quantify the induced radiofrequency (RF) electric (E)-fields and B1+rms fields in patients undergoing magnetic resonance (MR) examinations; to provide guidance on aspects of RF heating risks for patients with and without implants; and to discuss some strengths and limitations of safety assessments in current ISO, IEC, and ASTM standards to determine the RF heating risks for patients with and without implants. Methods. Induced E-fields and B1+rms fields during 1.5 T and 3 T MR examinations were numerically estimated for high-resolution patient models of the Virtual Population exposed to ten two-port birdcage RF coils from head to feet imaging landmarks over the full polarization space, as well as in surrogate ASTM phantoms. Results. Worst-case B1+rms exposure greater than 3.5 μT (1.5 T) and 2 μT (3 T) must be considered for all MR examinations at the Normal Operating Mode limit. Representative induced E-field and specific absorption rate distributions under different clinical scenarios allow quick estimation of clinical factors of high and reduced exposure. B1 shimming can cause +6 dB enhancements to E-fields along implant trajectories. The distribution and magnitude of induced E-fields in the ASTM phantom differ from clinical exposures and are not always conservative for typical implant locations. Conclusions. Field distributions in patient models are condensed, visualized for quick estimation of risks, and compared to those induced in the ASTM phantom. Induced E-fields in patient models can significantly exceed those in the surrogate ASTM phantom in some cases. In the recent 19ε2 revision of the ASTM F2182 standard, the major shortcomings of previous versions have been addressed by requiring that the relationship between ASTM test conditions and in vivo tangential E-fields be established, e.g. numerically. With this requirement, the principal methods defined in the ASTM standard for passive implants are reconciled with those of the ISO 10974 standard for active implantable medical devices. [ABSTRACT FROM AUTHOR]