Search

A fully coupling model for the diffusion induced finite elastoplastic bending of bilayer electrodes in lithium-ion batteries is proposed. The effect of the mechanical stress on the lithium diffusion is accounted for by the mechanical part of the chemical potential derived from the Gibbs free energy along with the logarithmic stress and strain. Eight dimensionless parameters, governing the stress-assisted diffusion and the diffusion induced elastoplastic bending, are identified. It is found that the finite plasticity starting from the interface of the bilayer increases the chemical potential gradient and thereby facilitates the lithium diffusion. The full plastic flow makes the abnormal lithium concentration distribution possible, i.e., the concentration at the lithium inlet can be lower than the concentration at the interface (downstream). The increase in the thickness of the active layer during charging is much larger than the eigen-stretch due to lithiation, and this excess thickening is found to be caused by the lithiation induced plastic yield. [ABSTRACT FROM AUTHOR]

Intercalation of lithium ions into the electrodes of lithium ion batteries is affected by the stress of active materials, leading to energy dissipation and stress dependent voltage hysteresis. A reaction-diffusion-stress coupling model is established to investigate the stress effects under galvanostatic and potentiostatic operations. It is found from simulations that the stress hysteresis contributes to the voltage hysteresis and leads to the energy dissipation. In addition, the stress induced voltage hysteresis is small in low rate galvanostatic operations but extraordinarily significant in high rate cases. In potentiostatic operations, the stresses and stress induced overpotentials increase to a peak value very soon after the operation commences and decays all the left time. Therefore, a combined charge-discharge operation is suggested, i.e., first the galvanostatic one and then the potentiostatic one. This combined operation can not only avoid the extreme stress during operations so as to prevent electrodes from failure but also reduce the voltage hysteresis and energy dissipation due to stress effects. [ABSTRACT FROM AUTHOR]

In this study, a nanorod-like FeO/graphene nanocomposite is synthesized by a facile template-free hydrothermal method and a following calcination in air at 300 °C for 2 h. The FeO nanorods with diameter of 15-30 nm and length of 120-300 nm are homogenous distributed on both sides of graphene. The morphologies of intermediates at different hydrothermal reaction times are investigated by transmission electron microscopy (TEM) characterization, and a possible growth mechanism of this one-dimensional structure is proposed. It is shown that the α-FeOOH rodlike precursors are formed through a rolling-broken-growth (RBG) model, then the α-FeOOH is transformed into α-FeO nanorods during calcinations, preserving the same rodlike morphology. Electrochemical characterizations demonstrate that the FeO nanorod/graphene composites exhibit a very large reversible capacity of 1063.2 mAh/g at the charge/discharge rate of 0.1 C. [ABSTRACT FROM AUTHOR]