Search

Liquefied wood (LW) prepared in a microwave process was applied as a novel; inexpensive precursor feedstock for incorporation of (R)-3-hydroxyvalerate (3HV) into polyhydroxyalkanoate (PHA) biopolyesters in order to improve the biopolyester's material quality; Cupriavidus necator was applied as microbial production strain. For proof of concept, pre-experiments were carried out on a shake flask scale using different mixtures of glucose and LW as carbon source. The results indicate that LW definitely acts as a 3HV precursor, but, at the same time, displays toxic effects on C. necator at concentrations exceeding 10 g/L. Based on these findings, PHA biosynthesis under controlled conditions was performed using a fed-batch feeding regime on a bioreactor scale. As major outcome, a poly(3HB-co-0.8%-3HV) copolyester was obtained displaying a desired high molar mass of Mw = 5.39 × 105 g/mol at low molar-mass dispersity (ĐM of 1.53), a degree of crystallinity(Xc) of 62.1%, and melting temperature Tm (176.3 °C) slightly lower than values reported for poly([R]-3-hydroxybutyrate) (PHB) homopolyester produced by C. necator; thus, the produced biopolyester is expected to be more suitable for polymer processing purposes. [ABSTRACT FROM AUTHOR]

In this study, we modified melamine-formaldehyde (MF) resin adhesive with liquefied wood (LW) and determined the properties of MF–LW adhesive mixtures. Furthermore, we produced particleboards using prepared MF–LW mixtures and evaluated their mechanical and physical properties. Results showed that with increasing content of LW in the adhesive mixture gel time and peak temperature increased while reaction enthalpy decreased. With increasing substitution of MF resin adhesive with LW the thermal stability of adhesive mixture reduced, namely thermal degradation started at lower temperature and weight loss increased. Properties of particleboards improved with increasing amount of LW in the adhesive mixture up to 20% and then deteriorated. Nevertheless, the properties of particleboard with 30% LW in the adhesive mixture were comparable to the properties of particleboard without LW while they worsen at greater portion of LW. Consequently, MF resin adhesive with 30% LW substitution could be used to produce particleboards with suitable mechanical properties and reduced formaldehyde release content. [ABSTRACT FROM PUBLISHER]

Abstract: The paper reports foremost the results of a successful combustion of an innovative lignocellulosic biofuel in a gas turbine. The fuel was processed through liquefaction of lignocellulosic materials with polyhydroxy alcohols in an acid catalyzed reaction. The liquefaction process features: high efficiency, high liquid yields and inexpensive, easily available process equipment. For the purpose of this analysis the following were developed: an experimental gas turbine with internal combustion chamber, a preheated pressurized fuel supply system with swirl-air fuel injector and a heat exchanger to obtain high primary air temperatures. The paper gives results on the emissions of CO, THC, NOx and soot. For the purpose of benchmarking the turbine was also run on diesel fuel. The paper presents analyses of the underlying phenomena with which it aims to provide guidelines for improvements in the fuel processing and in the experimental equipment. It has been shown that direct utilization of this innovative lignocellulosic biofuel gives promising results. Although the CO and THC emissions are higher compared to the benchmark diesel results it has been shown that both emissions decrease with increased turbine inlet temperature and with the increased fuel preheat temperature, due to a very high viscosity of the fuel. It is additionally shown that NOx emissions are low and comparable to those of the diesel fuel, whereas soot emissions are very low for both fuels. [Copyright &y& Elsevier]