Search

In this work, an evaluation of an intense biomass burning event observed over Ny-Ålesund (Spitsbergen, European Arctic) in July 2015 is presented. Data from the multi-wavelengths Raman-lidar KARL, a sun photometer and radiosonde measurements are used to derive some microphysical properties of the biomass burning aerosol as size distribution, refractive index and single scattering albedo at different relative humidities. Predominantly particles in the accumulation mode have been found with a bi-modal distribution and dominance of the smaller mode. Above 80% relative humidity, hygroscopic growth in terms of an increase of particle diameter and a slight decrease of the index of refraction (real and imaginary part) has been found. Values of the single scattering albedo around 0.9 both at 355 nm and 532 nm indicate some absorption by the aerosol. Values of the lidar ratio are around 26 sr for 355 nm and around 50 sr for 532 nm, almost independent of the relative humidity. Further, data from the photometer and surface radiation values from the local baseline surface radiation network (BSRN) have been applied to derive the radiative impact of the biomass burning event purely from observational data by comparison with a clear background day. We found a strong cooling for the visible radiation and a slight warming in the infra-red. The net aerosol forcing, derived by comparison with a clear background day purely from observational data, obtained a value of -95 W/m2 per unit AOD500. [ABSTRACT FROM AUTHOR]

In this work multi wavelength Raman lidar data from Ny-Ålesund, Spitsbergen have been analysed for the spring 2014 Arctic haze season, as part of the iAREA campaign. Typical values and probability distributions for aerosol backscatter, extinction and depolarisation, the lidar ratio and the color ratio for 4 different altitude intervals within the troposphere are given. These quantities and their dependencies are analysed and the frequency of altitude-dependent observed aerosol events are given. A comparison with ground-based size distribution and chemical composition is performed. Hence the aim of this paper is to provide typical and statistically meaningful properties of Arctic aerosol, which may be used in climate models or to constrain the radiative forcing. We have found that the 2014 season was only moderately polluted with Arctic haze and that sea salt and sulphate were the most dominant aerosol species. Moreover the drying of an aerosol layer after cloud disintegration has been observed. Hardly any clear temporal evolution over the 4 week data set on Arctic haze is obvious with the exception of the extinction coefficient and the lidar ratio, which significantly decreased below 2 km altitude by end April. In altitudes between 2 and 5 km the haze season lasted longer and the aerosol properties were generally more homogeneous than closer to the surface. Above 5 km only few particles were found. The variability of the lidar ratio is discussed. It was found that knowledge of the aerosol’s size and shape does not determine the lidar ratio. Contrary to shape and lidar ratio, there is a clear correlation between size and backscatter: larger particles show a higher backscatter coefficient. [ABSTRACT FROM AUTHOR]

A new automated small size lidar system (microlidar or MULID) has been developed and employed to perform aerosol measurements since March 2010 at Ny Å lesund (78.9°N, 11.9°E), Svalbard. The lidar observations have been used to estimate the PBL height by using the gradient method based on abrupt changes in the vertical aerosol profile and monitor its temporal evolution. The scope of the present study is to compare several approaches to estimate the PBL height, by using lidar observations, meteorological measurements by radio soundings, and a zero-order one-dimensional model based on a parameterization of the turbulent kinetic energy budget within the mixing layer, under the assumptions of horizontal homogeneity, and neglecting radiation and latent heat effects. A case study is presented here for a convective PBL, observed in June 2010 in order to verify whether the Gradient Method can be applied to lidar measurements in the Arctic region to obtain the PBL height. The results obtained are in good agreement with the PBL height estimated by the analysis of thermodynamic measurements obtained from radio sounding and with the model. [ABSTRACT FROM AUTHOR]

A closure experiment was conducted over Svalbard by comparing Lidar measurements and optical aerosol properties calculated from aerosol vertical profiles measured using a tethered balloon. Arctic Haze was present together with Icelandic dust. Chemical analysis of filter samples, aerosol size distribution and a full set of meteorological parameters were determined at ground. Moreover, scanning electron microscopy coupled with energy-dispersive X-ray (SEM-EDS) data were at disposal showing the presence of several mineralogical phases (i.e., sheet silicates, gypsum, quartz, rutile, hematite). The closure experiment was set up by calculating the backscattering coefficients from tethered balloon data and comparing them with the corresponding lidar profiles. This was preformed in three subsequent steps aimed at determining the importance of a complete aerosol speciation: (i) a simple, columnar refractive index was obtained by the closest Aerosol Robotic Network (AERONET) station, (ii) the role of water-soluble components, elemental carbon and organic matter (EC/OM) was addressed, (iii) the dust composition was included. When considering the AERONET data, or only the ionic water-soluble components and the EC/OM fraction, results showed an underestimation of the backscattering lidar signal up to 76, 53 and 45% (355, 532 and 1064 nm). Instead, when the dust contribution was included, the underestimation disappeared and the vertically-averaged, backscattering coefficients (1.45 ± 0.30, 0.69 ± 0.15 and 0.34 ± 0.08 Mm−1 sr−1, at 355, 532 and 1064 nm) were found in keeping with the lidar ones (1.60 ± 0.22, 0.75 ± 0.16 and 0.31 ± 0.08 Mm−1 sr−1). Final results were characterized by low RMSE (0.36, 0.08 and 0.04 Mm−1 sr−1) and a high linear correlation (R2 of 0.992, 0.992 and 0.994) with slopes close to one (1.368, 0.931 and 0.977, respectively). This work highlighted the importance of all the aerosol components and of the synergy between single particle and bulk chemical analysis for the optical property characterization in the Arctic. Unlabelled Image • Lidar and tethered balloon-based aerosol vertical profiles were measured concurrently in the Arctic. • Aerosol chemistry and size distribution were measured during the campaign. • SEM-EDS analyses of dust transport were included in the study. • The refractive index was determined from full chemical composition. • Closure between lidar and balloon-based optical profiles was performed with Mie calculations. [ABSTRACT FROM AUTHOR]