Search

A direct method is proposed for the determination of lead in naphtha and petroleum condensate by electrothermal atomic absorption spectrometry (ET AAS) using palladium as a permanent modifier. The procedure includes the dilution of 3 mL of sample (naphtha or petroleum condensate) to a final volume of 10 mL with xylene, and direct injection of 30 µL of this solution into the graphite furnace. The optimization of the instrumental conditions was performed using multivariate techniques. Firstly, a 23 full factorial design was performed for preliminary evaluation of the factors: pyrolysis time, pyrolysis temperature and atomization temperature. This experiment showed that in the studied levels only the factors pyrolysis time and atomization temperature were significant. Then, a 32 full factorial design was performed for the determination of the critical conditions of these variables. The method allows the determination of lead using the standard calibration technique with a calibration curve from 2.6 to 30 µg L−1 (correlation coefficient higher than 0.998). A limit of detection (3σ) of 0.8 µg L−1 and a characteristic mass of 35 pg were obtained in the presence of palladium as modifier. The precision expressed as relative standard deviation (RSD) was 1.5 and 0.8% for lead concentrations of 3.0 and 30 µg L−1 ( n = 10). Recovery studies demonstrate that lead can be determined in naphtha and petroleum condensate using calibration with organic standard solutions. This method was applied for the determination of lead in three petroleum condensate and two naphtha samples. The concentrations found for the petroleum condensate was between 2.7 and 5.7 µg L−1, while the naphtha samples did not contain any detectable lead. [ABSTRACT FROM AUTHOR]

[Display omitted] • This work showed the use of exploratory analysis for evaluation of abiotic stress in Basil. • The plants were subjected to five different concentrations of cadmium, lead and aluminum. • The concentration of phenolic compounds was evaluated as a response to stress. Basil is an edible, aromatic plant, which makes the study of the ecotoxicity of metals in plant metabolism relevant. Given the above, the objective of this study was to evaluate the effects of metals, aluminum, lead, and cadmium, in the synthesis of phenolic compounds and in the dry mass of basil plants (O. basilicum L.) grown in a hydroponic system. The plants were subjected to four different concentrations of cadmium (0.2, 0.6, 1.2, and 1.8 mmol L-1), lead and aluminum (0.04, 0.08, 0.12, and 0.16 mmol L-1), and compared with the control. After desiccation of the plant material, the total dry mass was obtained and then, hydroethanolic extracts (43% distilled water and 57% ethanol) were made for biochemical analyzes, which consisted of the determination of caffeic acid (CA) and rosmarinic acid (RA) by high performance liquid chromatography analysis with a diode detector (HPLC-DAD); total phenolics (TP) and total flavonoids (TF) by spectrophotometry. The data were submitted to analysis of variance and multivariate analysis (principal component analysis-PCA and hierarchical cluster analysis-HCA) was applied for data association. The phenolic compounds showed a high positive correlation with each other, and the total dry mass showed low and negative correlations with the analyzed variables. The results showed that the metals aluminum, lead, and cadmium promoted a stress condition in basil plants, which resulted in the reduction of the dry matter mass and an increase in the synthesis of phenolic compounds, according to the type and concentration of the metal. [ABSTRACT FROM AUTHOR]