Search

The rapid advancement of engineering systems has spurred the search for innovative thermal management solutions. Boiling, as a phase‐change heat transfer method, has shown promise in heat dissipation, but non‐functionalized surfaces struggle with increasing cooling demands. To improve heat dissipation efficiency across different heat loads, functionalized surfaces with tailored wettability have been proposed. Separately, superhydrophilic and superhydrophobic surfaces each offer benefits and drawbacks in boiling applications but combining them on a single "biphilic" surface simultaneously harnesses their advantages. In this study, laser‐functionalized copper surfaces with spatially tailored wettability are developed by combining two‐step laser texturing with a self‐assembled monolayer coating, while focus is placed on the impact of the size and pitch of superhydrophobic spots. The developed functionalized surfaces exhibit exceptional boiling performance with heat transfer coefficients up to 299 kW m−2 K−1, a 434% enhancement over untreated surfaces. Optimal ratios of superhydrophilic and superhydrophobic areas and optimal spot pitch are identified. Additionally, varying behavior at different heat flux levels is observed, emphasizing the importance of considering thermal loads when determining the optimal surface pattern. This advancement in performance, along with the rapid and cost‐effective functionalization process, represents a significant breakthrough for enhanced thermal management applications. [ABSTRACT FROM AUTHOR]

Prior studies have evidenced the potential for enhancing boiling heat transfer through modifications of surface or fluid properties. The deployment of nanofluids in pool boiling systems is challenging due to the deposition of nanoparticles on structured surfaces, which may result in performance deterioration. This study addresses the use of TiO2–water nanofluids (mass concentrations of 0.001 wt.% and 0.1 wt.%) in pool boiling heat transfer and concurrent mitigation of nanoparticle deposition on superhydrophobic laser-textured copper surfaces. Samples, modified through nanosecond laser texturing, were subjected to boiling in an as-prepared superhydrophilic (SHPI) state and in a superhydrophobic state (SHPO) following hydrophobization with a self-assembled monolayer of fluorinated silane. The boiling performance assessment involved five consecutive boiling curve runs under saturated conditions at atmospheric pressure. Results on superhydrophilic surfaces reveal that the use of nanofluids always led to a deterioration of the heat transfer coefficient (up to 90%) compared to pure water due to high nanoparticle deposition. The latter was largely mitigated on superhydrophobic surfaces, yet their performance was still inferior to that of the same surface in water. On the other hand, CHF values of 1209 kW m−2 and 1462 kW m−2 were recorded at 0.1 wt.% concentration on both superhydrophobic and superhydrophilic surfaces, respectively, representing a slight enhancement of 16% and 27% compared to the results obtained on their counterparts investigated in water. [ABSTRACT FROM AUTHOR]