Search

• New correlations for Nu number of ethanol ice slurry in a vertical slit channel. • The effect of flow direction on the values of α coefficients was investigated. • For laminar flow, the melting process has a greater effect of on α coefficient. • For turbulent flow, the convection process has a greater effect on α coefficient. • The upward flow, high ice mass fraction increase the αcoefficients. The article concerns the heat transfer process of ethanol ice slurry during downward and upward flow in a vertical slit channel (3x35.8x700 mm) under constant heat flux density conditions. Experimental studies were conducted for three initial concentrations of ethanol (X vai = 10.5 %, 13.2 %, 15.8 %) and mass fractions of ice of 0 ≤ x s ≤ 30 %. For upward flow, heat transfer coefficients were 6–14 % higher than for downward flow. For laminar flow, a greater effect of the melting process was observed, and for turbulent flow, the convection process had a greater effect on heat transfer coefficients. For laminar flow, the heat transfer coefficients of the ice slurry can be 200 % higher than the corresponding values for the carrier fluid. In turbulent flow, the corresponding increase in heat transfer coefficients did not exceed 15 %. For generalised non-Newtonian flow of ice slurry, criterion relationships were proposed for calculating heat transfer coefficients, taking into account the effect of the concentration of the carrier fluid, mass fractions of ice, its melting process, as well as the nature and direction of the flow. [ABSTRACT FROM AUTHOR]

• Flow resistances of ethanol ice slurry in a vertical slotted channel. • Determination of dynamic plastic viscosity and shear stress of ethanol ice slurry. • Impact of flow direction, settling velocity on flow resistance. • Dimensionless relationships for the determination of Fanning friction factors. • Generalized non-Newtonian fluid flow through a vertical slit channel. The paper presents the results of experimental flow investigations of an ethanol-based ice slurry flowing up and down a vertical slit channel. The impact of flow direction, carrier fluid concentration, ice mass fraction and mean velocity on pressure drop values has been investigated. Stronger mutual interaction between the phases on flow resistances was observed for low carrier fluid concentrations and in the laminar range of ice slurry flow. The measured resistance values for downward flow in the laminar area were 6–10% higher than the pressure drops for upward flow, while in the turbulent flow area they were 1–8% higher. Using the generalized non-Newtonian fluid model, the authors have proposed equations for calculating the friction factors for a vertical slit channel and various flow directions. [ABSTRACT FROM AUTHOR]

The paper presents the results of experimental research of pressure drop and heat transfer coefficients of ice slurry during its flow through tubes of rectangular and slit cross-sections. Moreover, the work discusses the influence of solid particles, type of motion and cross-section on the changes in the pressure drop and heat transfer coefficient. The analysis presented in the paper allows for identification of the criterial relations used to calculate the Fanning factor and the Nusselt number for laminar and turbulent flow, taking into account elements such as phase change, which accompanies the heat transfer process. Ice slurry flow is treated as a generalized flow of a non-Newtonian fluid. [ABSTRACT FROM AUTHOR]

Abstract: In this paper, we present results of the studies of pressure drops during laminar and turbulent flows of ice slurry produced on the basis of 10.6% ethanol solution. The results, obtained at various ice mass fractions, include pressure drops determined in horizontal ducts of circular, rectangular, and slit cross-sections. The critical Reynolds numbers were also determined. By introducing the Kozicki''s generalized definition of the Reynolds number, it was possible to verify the Fanning, Blasius and Dodge–Metzner–Kozicki relations used for determining ice slurry pressure drops during its flow through channels of various cross-sections. [Copyright &y& Elsevier]

Abstract: In this paper we present results of the studies of ice slurry flow in horizontal tubes. The possibility of treating the rheological parameters of ice slurry as being those of Bingham fluid was confirmed. The values of parameters (mass fraction, flow velocity) corresponding to the laminar, intermediate and turbulent flow were determined which permits to optimize the flow in the systems working with this cooling agent. Critical flow velocity and mass fraction of ice values were determined thereby; they correspond to a change in character of an ice slurry flow from a laminar to turbulent motion. Experimental results were compared to the analytical results, based on the Hedström and Tomita algorithms (the laminar and turbulent flow, respectively). The comparison showed a very good agreement between these data. [Copyright &y& Elsevier]

Abstract: In this paper, we analyzed the possibility of the simulations of ice slurry flow based on the known CFD procedures, for both Bingham fluids and mulitiphase flow models (the mixture and Eulerian models). It was shown that in the laminar region, the models selected (the Bingham and mixture model) gave a correct description of momentum transfer. In the turbulent range, corresponding to low values of the Reynolds number, the best agreement between experimental and simulation results (for the single-phase as well as for the multiphase Eulerian model) was obtained when the RNG k–ε turbulence model with the enhanced wall treatment algorithm was selected. [Copyright &y& Elsevier]

Abstract: This paper presents results of studies on heat transfer in ice slurry flows through horizontal tubes. On the basis of the energy equation and experimental results, the authors developed their own dimensionless relationships to determine local values of heat transfer coefficients for turbulent and laminar flows. Appropriate parameters were introduced to these expressions, in order to account for the effects of the following: the rheological properties of ice slurry, phase change, and the multiphase flow character. The second part of this paper discusses the possibility of modeling heat transfer in ice slurry tube flows using the CFD (fluent) methods. Correct description of heat transfer in ice slurry flows in tubes was made possible by assuming a single-phase model for Bingham fluid, and the enthalpy-porosity method for the analysis of melting, as well as by taking into account variations of the heat conductivity in a moving suspension. [Copyright &y& Elsevier]