Search

Evaluation of active tectonism by means of geomorphic indices has provided crucial semi-quantitative data for evaluating seismic hazards in a fault zone in a semiarid area of the Zagros Mountains of Iran where tectonic rates are low-to-moderate and there are few Quaternary dates. Quaternary activity along the seismically active but poorly understood Sabzpushan fault zone (SFZ) has been investigated. The SFZ consists of two dextral strike-slip faults, the Zafarabad and Kafari faults. Geomorphic indices including mountain front sinuosity, valley asymmetry factor, hypsometric integral, valley floor width to valley height ratio and stream length gradient index were used to assess the effects of active reverse faults which control the topographic relief and Quaternary activity. Geomorphometric and field evidence reveal that the Quaternary activity and topographic relief of the study area are controlled by two reverse faults, the North and South Sabzpushan reverse faults, which have formed a pop-up structure in the contractional step-over area between the Zafarabad and Kafari dextral strikeslip faults as a consequence of oblique convergence between the Afro-Arabian and Iranian plates accommodated by the North and South Sabzpushan thrust faults. [ABSTRACT FROM AUTHOR]

Chromitite bodies of various sizes associated with dunite envelopes have been found in the Dehsheikh ultramafic massif, in the southeastern part of the outer Zagros ophiolite belt. The chromitites occur as layered and lenticular bodies, and show both magmatic and deformational textures, including massive, disseminated, banded and nodular types. The Dehsheikh chromitites display a variation in Cr# [100 × Cr / (Cr + Al)] from 69 to 78, which is typical of high-Cr chromitites. The Al 2 O 3 and TiO 2 contents of chromites range from 10.3 wt.% to 16.9 wt.% and 0.12 wt.% to 0.35 wt.%, respectively. The Al 2 O 3 , TiO 2 , and FeO/MgO values calculated for parental melts of Dehsheikh chromitites are within the range of boninitic melts. Chondrite-normalized distribution patterns of platinum-group elements show relative enrichments in Ru, Ir, and Os, and depletions in Rh, Pd, and Pt that are typical of chromitites associated with ophiolites formed by high degrees of mantle partial melting. The presence of Na-rich amphibole inclusions in chromite grains, together with the mineralogical and chemical composition of the chromitites and estimates of their parental melt compositions are used to help establish the tectono-magmatic setting. It is shown that the Dehsheikh massif is an ophiolite formed in a suprasubduction zone setting. We suggest that the composition of the rocks in this section was influenced by hydrous partial melts which might be formed in the subduction zone. Variable melt/rock interaction produced melt channel networks in the dunite which allowed the parental melt of the chromitite to percolate through them. Similar characteristics have been observed in other ophiolite complexes from the outer Zagros Iranian ophiolitic belt; these are believed to be the product of magmatism in a fore-arc environment. [ABSTRACT FROM AUTHOR]

The structure, age and petrogenesis of plutonic basement rocks from the Kuh-e-Sarhangi region, located in the Kashmar-Kerman tectonic zone of Central Iran are described. These intrusive rocks consist of a sub-alkaline, dominantly high-K calc-alkaline acidic suite, characterised by high SiO 2 (72.60–77.17 wt%), and alkalis (up to 8 wt%) and low Mg# (07-35). They are also enriched in Th, U and light rare earth elements, and depleted in Nb, Ta, and Ti, thus showing a geochemical fingerprint compatible with arc magmatism. The U–Pb zircon geochronology constrains magma crystallisation and emplacement during Ediacaran-Cambrian (ca. 575–535 Ma) times, under a tectonic regime dominated by transpressional tectonics as constrained by analysis of field structures. Combined inverse and forward modelling thermobarometry indicates pluton emplacement occurred in a thickened crustal environment, suggesting the Kuh-e-Sarhangi magmatic belt exposes the exhumed roots of a volcanic arc. This magmatism is interpreted as part of the Cadomian, subduction-related magmatism and framed within an oblique convergence scenario during formation of an Andean-type active margin all along the northern (proto-Tethyan) margin of the Gondwana Supercontinent. [ABSTRACT FROM AUTHOR]

The neotectonics of the Zanjan-Kazvin area are dominated by the region-wide E-W trending left lateral strike-slip faults. These faults create restraining and releasing stepovers indicating strain partitioning. Instead of the NW-SE trending long range-parallel continuous thrust faulting suggested in previous studies, this paper demonstrates that there are E-W trending range-crossing left lateral strike-slip faults creating short range-parallel thrust faults in the restraining stepovers. Establishing this strike-slip-induced structural style might contribute to an understanding of the nature of the Elburz (Alborz) Mountains located between the Central Iran and Caspian blocks. [ABSTRACT FROM AUTHOR]

Abstract: We provide descriptions of strike-slip and reverse faulting, active within the late Quaternary, in the vicinity of Kerman city in southeastern Iran. The faults accommodate north-south, right-lateral, shear between central Iran and the Dasht-e-Lut depression. The regions that we describe have been subject to numerous earthquakes in the historical and instrumental periods, and many of the faults that are documented in this paper constitute hazards for local populations, including the city of Kerman itself (population ∼200,000). Faults to the north and east of Kerman are associated with the transfer of slip from the Gowk to the Kuh Banan right-lateral faults across a 40 km-wide restraining bend. Faults south and west of the city are associated with oblique slip on the Mahan and Jorjafk systems. The patterns of faulting observed along the Mahan-Jorjafk system, the Gowk-Kuh Banan system, and also the Rafsanjan-Rayen system further to the south, appear to preserve different stages in the development of these oblique-slip fault systems. We suggest that the faulting evolves through time. Topography is initially generated on oblique slip faults (as is seen on the Jorjafk fault). The shortening component then migrates to reverse faults situated away from the high topography whereas strike-slip continues to be accommodated in the high, mountainous, regions (as is seen, for example, on the Rafsanjan fault). The reverse faults may then link together and eventually evolve into new, through-going, strike-slip faults in a process that appears to be occurring, at present, in the bend between the Gowk and Kuh Banan faults. [ABSTRACT FROM AUTHOR]

Abstract: The Zagros fold-and-thrust belt of SW-Iran is among the youngest continental collision zones on Earth. Collision is thought to have occurred in the late Oligocene–early Miocene, followed by continental shortening. The High Zagros Belt (HZB) presents a Neogene imbricate structure that has affected the thick sedimentary cover of the former Arabian continental passive margin. The HZB of interior Fars marks the innermost part of SE-Zagros, trending NW–SE, that is characterised by higher elevation, lack of seismicity, and no evident active crustal shortening with respect to the outer (SW) parts. This study examines the brittle structures that developed during the mountain building process to decipher the history of polyphase deformation and variations in compressive tectonic fields since the onset of collision. Analytic inversion techniques enabled us to determine and separate different brittle tectonic regimes in terms of stress tensors. Various strike–slip, compressional, and tensional stress regimes are thus identified with different stress fields. Brittle tectonic analyses were carried out to reconstruct possible geometrical relationships between different structures and to establish relative chronologies of corresponding stress fields, considering the folding process. Results indicate that in the studied area, the main fold and thrust structure developed in a general compressional stress regime with an average N032° direction of σ 1 stress axis during the Miocene. Strike–slip structures were generated under three successive strike–slip stress regimes with different σ 1 directions in the early Miocene (N053°), late Miocene–early Pliocene (N026°), and post-Pliocene (N002°), evolving from pre-fold to post-fold faulting. Tensional structures also developed as a function of the evolving stress regimes. Our reconstruction of stress fields suggests an anticlockwise reorientation of the horizontal σ 1 axis since the onset of collision and a significant change in vertical stress from σ 3 to σ 2 since the late stage of folding and thrusting. A late right-lateral reactivation was also observed on some pre-existing belt-parallel brittle structures, especially along the reverse fault systems, consistent with the recent N–S plate convergence. However, this feature was not reflected by large structures in the HZB of interior Fars. The results should not be extrapolated to the entire Zagros belt, where the deformation front has propagated from inner to outer zones during the younger events. [Copyright &y& Elsevier]

Abstract: Iran is one of the most active regions in the world with respect to earthquakes and tectonic motions in the lithosphere. In order to study the impact of the geoid model in detecting plate tectonic boundaries and in the establishment of an accurate height datum for future geodynamic observations, a new combined gravimetric geoid model for Iran (IRG04C) was computed by the method of least squares modification of Stokes formula based on the most recent gravity anomaly database, SRTM high resolution Digital Elevation Model (DEM), GRACE GGM02 Global Geopotential Model and GPS/levelling data. The RMS fit of the new geoid model versus GPS/levelling data is 9cm, which is a 10 times better fit compared to the most recent published gravimetric geoid model in the area. An integrated approach, combining gravity, geoid and seismology data as well as a digital elevation model, was used to find possible correlations between these parameters. Our investigation indicates that all earthquakes with magnitude over 6.0 in the Richter scale are located in areas with a geoid slope exceeding 7.5%. The study shows a significant correlation between the horizontal gradient of the geoid and plate tectonic activities. [Copyright &y& Elsevier]