Search

Nano Fe-BTC/graphene oxide (GO) composites were successfully synthesized by hydrothermal treatment with a microwave-assisted method. Samples were characterized by X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), N2 adsorption–desorption, Scanning electron microscopy (SEM), Energy-dispersive X-ray spectroscopy (EDS), and Ultraviolet–visible diffuse reflection spectroscopy (UV–Vis DRS). SEM image of Fe-BTC/GO-30 showed the particle size of 30–50 nm on the GO surface. From the UV–Vis diffuse reflectance spectra, it revealed that nano Fe-BTC/GO composite absorbed the wavelengths in the visible light region with a low bandgap energy of 2.2–2.45 eV. Fe-BTC/GO nanocomposites were tested for the photocatalytic degradation of reactive yellow 145 (RY-145) in aqueous solution. Fe-BTC/GO composites exhibited high photocatalytic activity. Thus, at pH of 3 and high initial concentration of 100 mg RY-145/L, removal efficiency reached the value of 98.18% after 60 min. of reaction. In comparison with Fe-BTC/GO synthesized by the solvothermal method, nano Fe-BTC/GO showed much higher RY-145 removal efficiency. Moreover, this Fe-BTC/GO-30 showed high catalytic activity stability and could be reused, opening the high potential application of this promising photo-Fenton catalyst in photocatalytic degradation of organic pollutants from aqueous solution. [ABSTRACT FROM AUTHOR]

Catalytic ozonation is a new method used for removal of NH4OH solution. Therefore, high catalytic performance (activity and selectivity) should be achieved. In this work, we report the synthesis and catalytic performance of Fe2O3-Co3O4 modified dolomite in the catalytic ozonation of NH4OH solution. Dolomite was successfully activated and modified with Fe2O3 and Co3O4. Firstly, dolomite was activated by heating at 800°C for 3 h and followed by KOH treatment. Activated dolomite was modified with Fe2O3 by the atomic implantation method using FeCl3 as Fe source. Fe2O3 modified dolomite was further modified with Co3O4 by precipitation method. The obtained catalysts were characterized by X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), energy-dispersive X-ray spectroscopy (EDS), scanning electron microscopy (SEM), N2 adsorption–desorption (BET), and temperature-programmed reduction (H2-TPR). From SEM image, it was revealed that nano-Fe2O3 and Co3O4 particles with the size of 80–120 nm. Catalytic performance of activated dolomite, Fe2O3 modified dolomite, and Fe2O3-Co3O4 modified dolomite in catalytic ozonation of NH4+ solution was investigated and evaluated. Among 3 tested catalysts, Fe2O3-Co3O4 modified dolomite has the highest NH4+ conversion (96%) and N2 selectivity (77.82%). Selectivity toward N2 over the catalyst was explained on the basis of bond strength M-O in oxides through the standard enthalpy Δ H ° f of oxide. Catalyst with lower Δ H ° f value has higher N2 selectivity and the order is the following: Co3O4 (Δ H ° f of 60 kcal (mole O)) > Fe2O3 (Δ H ° f of 70 kcal (mole O)) > MgO (Δ H ° f of 170 kcal (mole O)). Moreover, high reduction ability of Fe2O3-Co3O4 modified dolomite could improve the N2 selectivity by the reduction of NO3- to N2 gas. [ABSTRACT FROM AUTHOR]