Search

Stability of high indomethacin (IMC) content formulations based on ordered mesoporous silica MCM-41 and SBA-15 materials was studied before and after a 3 month storage in stressed conditions (30°C/56% RH). Overall, the physical stability of the samples was found satisfactory after the storage. However, some issues with the chemical stability were noted, especially with the MCM-41 based samples. The stability issues were evident from the decreased HPLC loading degrees of the drug after stressing as well as from the observed extra peaks in the HPLC chromatograms of the drug in the stressed samples. Drug release from the mesoporous formulations before stressing was rapid at pH 1.2 in comparison to bulk crystalline IMC. The release profiles also remained similar after stressing. Even faster and close to complete IMC release was achieved when the pH was raised from 1.2 to 6.8. To our knowledge, this is the first report of chemical stability issues of drugs in mesoporous silica drug formulations. The present results encourage further study of the factors affecting the chemical stability of drugs in mesoporous silica MCM-41 and SBA-15 formulations in order to realize their potential in oral drug delivery., (Copyright © 2011 Elsevier B.V. All rights reserved.)

Evaporation rates play a key role in evaporation crystallization and the drying of crystal products. Raman analysis was used to study the effect of the evaporation rate on the polymorphs of indomethacin at room temperature. The studied solvents were highly volatile ethanol, acetone, and ethyl acetate. The approach was based on a mass transfer model of evaporation, and experimental flux measurements were used for model evaluation. Evaporation rates from porous carriers were also investigated. The studied mesoporous silicon microparticles can be used in oral dosage forms of poorly soluble active pharmaceutical ingredients. Evaporation rates of dimethyl sulfoxide from a pure solvent, from indomethacin solutions, and from solutions containing microparticles were measured at 100 °C. An evaporation rate model of porous particles was used and the predicted results were compared with the experimental results obtained. [ABSTRACT FROM AUTHOR]