Search

We utilized 251 measurements from a recently developed automated seepage meter (ASM) in streambeds in the Nebraska Sand Hills, USA to investigate the small‐scale spatial variability of groundwater seepage flux (q) and the ability of the ASM to estimate mean q at larger scales. Small‐scale spatial variability of q was analyzed in five dense arrays, each covering an area of 13.5–28.0 m2 (169 total point measurements). Streambed vertical hydraulic conductivity (K) was also measured. Results provided: (a) high‐resolution contour plots of q and K, (b) anisotropic semi‐variograms demonstrating greater correlation scales of q and K along the stream length than across the stream width, and (c) the number of rows of points (perpendicular to streamflow) needed to represent the groundwater flux of areas up to 28.0 m2. The findings suggest that representative streambed measurements are best conducted perpendicular to streamflow to accommodate larger seepage flux heterogeneity in this direction and minimize sampling redundancy. To investigate the ASM's ability to produce accurate mean q at larger scales, seepage meters were deployed in four stream reaches (170–890 m), arranged in three to six transects (three to eight points each) per reach across the channel. In each reach, the mean seepage flux from ASMs was compared to the seepage flux from bromide tracer dilution. Agreement between the two methods indicates the viability of a modest number of seepage meter measurements to determine the overall groundwater flux to the stream and can guide sampling for solutes and environmental tracers. Plain Language Summary: Surface waters can be windows into groundwater aquifers. When conditions are right, groundwater is pushed up through the streambed and into the stream bringing with it natural and artificial solutes that are used as tracers for aquifer evaluation. Therefore, measurements of groundwater seepage fluxes are important. Utilizing a new tool (Solomon et al., 2020, https://doi.org/10.1029/2019WR026983) for point measurements of groundwater flux (over an area of about 10 cm2), this study makes an unprecedented number of direct discharge measurements in the Sand Hills, Nebraska, USA in both (a) small areas (13.5–28.0 m2) of streambed and (b) along a much larger (170–890 m) stream segments. The results indicate that a modest number of discharge measurements in transects perpendicular to streamflow may accurately represent the groundwater flux in both small sections of stream and even in larger stream sections up to 890 m long. This means that if groundwater is discharging into the stream, the average seepage flux from the groundwater aquifer over the entire stream segment can be obtained through sampling a relatively small number of streambed locations. This potentially provides water resource managers valuable information on fluxes of both groundwater contaminants and age‐dating tracers without installing resource‐demanding wells. Key Points: A recently developed seepage meter produced high‐resolution maps of groundwater flux through streambeds in the Nebraska Sand Hills, USAAnisotropic semi‐variograms suggest representative point sampling is best conducted in rows of evenly spaced points across the stream widthGroundwater flux measured at 3–6 channel transects of seepage meters (3–8 points each) estimated total flux in reaches up to 890 m long [ABSTRACT FROM AUTHOR]

We present measurements of the density, hydraulic conductivity, and specific discharge of a widespread firn aquifer in Antarctica, within the Wilkins Ice Shelf. At the field site, the aquifer is 16.2 m thick, starting at 13.4 m from the snow surface and transitioning from water‐saturated firn to ice at 29.6 m. Hydraulic conductivity derived from slug tests show a geometric mean value of 1.4 ± 1.2 × 10−4 m s−1, equivalent to permeability of 2.6 ± 2.2 × 10−11 m2. A borehole dilution test indicates an average specific discharge value of 1.9 ± 2.8 × 10−6 m s−1. Ground‐penetrating radar profiles and a groundwater flow model show the aquifer is draining laterally into a large nearby rift. Our findings indicate that the firn aquifer in the vicinity of the field site is likely not in a steady state and its presence likely contributed to past ice shelf instability. Plain Language Summary: Firn aquifers occur in areas of high melt and snow accumulation when meltwater percolates into firn (compacted snow older than 1 year) pore space and is stored throughout the winter without refreezing. In December 2018, a field team traveled to the Wilkins Ice Shelf on the Antarctic Peninsula and drilled into an aquifer. We used a combination of hydrology and ground‐penetrating radar measurements to show that water is flowing laterally through porous buried snow and draining into a nearby rift. Firn aquifers are important since they allow meltwater to be stored at depth, possibly running off into cracks, crevasses, or rifts and increasing fracture depth, thereby leading to ice shelf destabilization. Key Points: An extensive perennial firn aquifer within the Wilkins Ice Shelf is characterized for its hydrologic propertiesField data and modeling show the aquifer has high permeability and is flowing into a nearby riftPast disintegration events on the Wilkins Ice Shelf with hydrofracture characteristics are likely a result of the aquifer's presence [ABSTRACT FROM AUTHOR]

Firn aquifers have been discovered across regions of the Greenland ice sheet with high snow accumulation and melt rates, but the processes and rates that sustain these aquifers have not been fully quantified or supported by field data. A quantitative description of the hydrology of a firn aquifer upslope from Helheim Glacier that integrates field measurements is presented to constrain melt and recharge rates and timing, temporal variations in temperature and water levels, and liquid‐water residence time. Field measurements include weather data, firn temperatures, water levels, geochemical tracers, and airborne radar data. Field measurements show that once the firn column is temperate (0°C), meltwater from the surface infiltrates to the water table in less than 2 days and raises the water table. Average recharge is 22 cm/year (lower 95% confidence interval is 13 cm/year and upper 95% confidence interval is 33 cm/year). Meltwater within the recently formed aquifer, which flows laterally downslope and likely discharges into crevasses, has a mean residence time of ~6.5 years. Airborne radar data suggest that the aquifer in the study area continues to expand inland, presumably from Arctic warming. These comprehensive field measurements and integrated description of aquifer hydrology provide a comprehensive, quantitative framework for modeling fluid flow through firn, and understanding existing and yet undiscovered firn aquifers, and may help researchers evaluate the role of firn aquifers in climate change impacts. Key Points: Seasonal recharge supplies thermal energy and water to maintain a firn aquiferFirn temperature controls aquifer geometryThe recently formed aquifer has a mean residence time of about 6.5 ± 4 years and has expanded upslope since 2010 [ABSTRACT FROM AUTHOR]

River basin aquifers are common sites for drinking water wells as bank filtration can be a cost effective pretreatment technology. A groundwater vulnerability to pollution depends on a groundwater mean residence time and on a relative contribution of river water versus local precipitation to groundwater. Environmental isotopes of oxygen and hydrogen ( δ 18 O and δ 2 H), tritium ( 3 H) and concentrations of nitrate (NO 3 − ) were used to investigate hydrological pathways, mean residence time and interactions between surface water and groundwater in the Ljubljansko polje aquifer system in Slovenia. δ 18 O and δ 2 H values indicate a spatial variability of the influence of individual groundwater sources inside the aquifer – local precipitation and the Sava River water. Fractions of river water in groundwater depend on the depth of perforated screens in the pumping wells and their distance from the Sava River. It was estimated that groundwater at wells Kleče 11, Hrastje 3, and Hrastje 8 is mostly composed of recently infiltrated local precipitation, while the Sava River is the dominant source of groundwater at the well Jarški prod 1. Groundwater at wells Kleče 8, Kleče 12, and Jarški prod 3 contains on average between 41% and 48% of the Sava River water. The 3 H and 3 H/ 3 He methods indicate short mean residence time of groundwater present at Jarški prod (2–7 years) and Hrastje (7–8 years). A small fraction (<10%) of old groundwater is present at Kleče. Furthermore, infiltration of local precipitation influenced the levels of NO 3 − at Hrastje. These data extend our understanding of groundwater flow in the Ljubljansko polje aquifer system, interactions between the Sava River water/local precipitation and groundwater, and the utility of isotope tracers in evaluating the spatial distribution of groundwater vulnerability to pollution. [ABSTRACT FROM AUTHOR]

Focuses on the applications of total dissolved gas pressure (TGP) probes in ground water studies. Function of dissolved gases in ground water hydrology; Basic operating principle of TGP probes; Details of the process of identifying air contamination with the TGP probe.