Search

Abstract: The aim of this study is to investigate the influence of extractives on the yield and composition of oil obtained from biomass samples (Artemisia ordosica, corn stalk and wheat straw). Direct deoxy-liquefaction experiments of original and extracted biomass were performed at certain temperature in a stainless steel tubular reactor. Benzene–alcohol solvent extraction had significant effect on the product distribution of biomass, especially on the yield and composition of the product oils. The oil yield of original biomass and alkane content in the oil were in the range of 5.44–9.27% and 8.23–23.64%, while decreased to 3.83–4.45% and 1.07–6.03% for the extracted biomass. This study concludes that most of alkanes in the oil mainly derive from the decomposition of triglyceride and hydrocarbon existed in the extractives of biomass. The results might be helpful to study the origin of alkanes and benzene derivatives in the oil obtained from biomass via direct deoxy-liquefaction. [Copyright &y& Elsevier]

Poplar leaves, poplar bark and poplar wood were deoxy-liquefied directly in an air-proof stainless steel reactor at different temperatures. The oils from leaves at 350°C, from bark at 400°C and from wood at 450°C, at which the liquid product yields were the maximum, were analyzed by GC–MS. The oils obtained from three parts of poplar tree were quite different from each other in the relative contents of their compositions. The oil from leaves was rich in hydrocarbons (alkanes: C7–C29; aromatics) and poor in phenolics, while oil from wood was rich in phenolics and poor in hydrocarbons. The oil from bark was moderate. Relative contents of hydrocarbons in the leaves oil were as high as 60.01% but decreased to 29.71% in bark oil and 11.43% in wood oil. GC analysis of gases and FT-IR, GC–MS and elemental analysis of oils were performed in this study. [Copyright &y& Elsevier]

Abstract: The relationships between morphology and proton conduction for Nafion membranes and hydrocarbon-type proton exchange membranes, namely, sulfonated poly(arylene ether ether ketone) (S-PEEK) and sulfonated poly(arylene ether sulfone) (S-PES), were investigated by small-angle X-ray scattering (SAXS) and atomic force microscopy (AFM). The direct simultaneous observation of surface morphology and active regions of proton conduction on membranes by combined high-resolution AFM phase imaging and an electrochemical technique at controlled humidity provided significant morphological information, particularly for the hydrocarbon-type membranes that exhibit few or no features on SAXS profiles. For the Nafion membranes, the active proton paths became denser and congregated with each other at over 60% RH, resulting in the formation of well-connected networks. For the hydrocarbon-type membranes, however, only the relatively small and dispersed proton paths were observed, which showed no significant change even as water content increased. We have demonstrated that the differences in microscopic morphology between the Nafion and hydrocarbon-type membranes are associated with the differences between their macroscopic proton conductivities. [Copyright &y& Elsevier]

Abstract: Co-deoxy-liquefaction of biomass and vegetable oil was investigated under the conditions of different temperatures (350–500°C) and residence time as well as catalyst using HZSM-5. Results suggested low temperature was favorable for the formation of diesel-like products, while high temperature caused more gasoline-like products. By the addition of HZSM-5, at 450°C alkanes content of the obtained oil with low oxygen content of 2.28%, reached a maximum of 56.27%, resulting in the highest HHV of 43.8MJkg−1. High temperature favored cracking activity of HZSM-5 which reduced the char formation and contributed to the removal of carbonyl. Compared to temperature, the effect of residence time on products was relatively less; experiments indicated the optimum residence time was 15min at which obtained oil with the highest yield of 17.78%, had better properties. Preliminary analysis of mechanisms showed biomass provided hydrogen for vegetable oil, facilitating hydrogenation of Cf vegetable oil. [ABSTRACT FROM AUTHOR]