Search

The article refers to the proposed test equipment used to monitor the service life of hydrostatic transducers and fluids under constant or dynamic operating pressure loading. The proposed laboratory test equipment enables simultaneous testing of hydrostatic transducers and energy carriers in two hydraulic circuits and is designed to measure the flow characteristics and technical life of hydrostatic transducers with different energy carriers. The benefit of the proposed device is the possibility of simultaneous testing of the transducers as well as the performance of verification measurements of individual circuits, which was preceded by the development of a theoretical design. This includes the calculations necessary to determine the power of the drive, the cooling power as well as the definition of other parameters and elements of the hydraulic system. The design of the device was based on technical characteristics, load characteristics obtained by own measurements, and characteristics of individual hydraulic and electrohydraulic elements. On the basis of the prepared laboratory test equipment, it is possible to significantly shorten the time of operational tests and perform repeated tests under the same operational load with different types of energy carriers. The hydraulic circuit (primary or secondary) can be loaded through a proportional electrohydraulic pressure valve, which is able to simulate the load with the operational pressure curve obtained by measurement, as well as the cyclic stress, the frequency, amplitude, and rate of increase of which can be defined according to the selected methodology. A verification measurement of the flow characteristics of the used transducers was also carried out, which confirmed the correct function and design of the test laboratory equipment. The achieved results can be used in mechanical engineering for the accelerated life test of hydrostatic transducers, which are often used in mobile energy devices working in environmentally sensitive areas. The proposed laboratory test equipment will be used for testing ecological energy carriers, increasing the efficiency of energy conversion in agricultural facilities using biomass.

By simulating the operating conditions, it is possible to verify and evaluate the technical properties of motor vehicle oil filters and the functionality of the designed equipment. Contaminated engine oil from operation was used with MANN W950/26 oil filter and a CNH Industrial 2992242 oil filter in the test circuit. Before use, the level of engine oil contamination in the test circuit was determined by evaluating the physicochemical properties. The laboratory test equipment also allows monitoring the technical life of oil filters, with variously contaminated engine oil, with the possibility of extending engine oil change service intervals depending on changes in the physicochemical properties of engine oil and filter efficiency. These laboratory tests can be performed in parallel in two hydraulic circuits, which can significantly reduce the testing time of the filter capabilities of oil filters, without the risk of engine damage, provided that the tests were performed under operating conditions. The results of the evaluation of the filtration capacity of oil filters can be used in the design of new filter materials, but also with a suitably determined methodology of oil filter replacement and engine oil change interval, it is possible to extend replacement intervals, which has a significant benefit not only from an economic but also ecological point of view. The result of the measurements is the confirmation of the functionality of the device with the possibility of simulating the operating conditions, at different degrees of oil contamination, at different operating temperatures and using different oil filters.

This paper deals with the effect of ecological energy carrier on flow characteristics of a hydraulic pump. A hydraulic oil MOL Farm UTTO Synt was used as an ecological energy carrier. After completing 900 engine hours, the flow efficiency of the hydraulic pump decreased by Δηpr = 1.197 %. Oil samples were taken from the agricultural tractor Zetor Forterra 114 41. These samples were subjected to an IR spectroscopy analysis in an accredited laboratory WearCheck, Hungary. The following oil properties were examined: kinematic viscosity at 40 °C, viscosity index, silicium and ferrum content.

The main aim of the article is to present the design of laboratory test equipment, which is appropriate for monitoring the efficiency of oil filters and the system for evaluating the technical life of engine oils in terms of possible extension of service intervals. The functionality of the designed laboratory test equipment for the filtration of motor oils was verified by a practical experiment with a verification measurement and assessment of the suitability of the hydraulic circuit elements and the designed sensing equipment. The laboratory equipment enables the testing of oil filters with different filtration capacity during simultaneous testing in two separate hydraulic circuits with differently contaminated engine oil, while it enables laboratory measurements to be performed while simulating operating conditions. [ABSTRACT FROM AUTHOR]