Search

To understand whether quantitative measurement of minimal coronary luminal diameter is a better method than percent diameter narrowing for assessing the functional impairment of myocardial contractility produced by coronary artery stenoses, measurements were made from 37 stenotic segments in 27 patients with coronary artery disease and from corresponding segments in 10 subjects without coronary artery narrowing. An assessment of the reliability of the 2 types of measurements was made by correlating them with the physiologic parameters of both segmental wall motion and global ejection fraction response induced by atrial pacing. Digitally acquired coronary angiograms were used to facilitate quantitative analysis. Measurements by edge detection and videodensitometry correlated closely (r = 0.94). Percent diameter narrowing correlated moderately with the change in ejection fraction (r = -0.41) or with the change in segmental wall motion (r = -0.44). The measurement of minimal lumen diameter correlated with the change in global ejection fraction (r = 0.61) and did so even better with the change in segmental wall motion (r = 0.78, p less than 0.05). A minimal lumen diameter of less than or equal to 1.5 mm identified patients likely to have a functional impairment during atrial pacing as assessed by either global ejection fraction or segmental wall motion defects. We conclude that minimal coronary luminal diameter provides a better method than percent diameter narrowing calculations to measure the anatomic severity of coronary artery narrowing.

In an attempt to improve visualization of the position of the guidewire and dilatation balloon during coronary angioplasty, a method was developed called digital coronary roadmapping. With this method a digitally acquired coronary angiogram is interlaced with the live fluoroscopic image of the guidewire and balloon catheter. The digital coronary angiogram is superimposed at the same magnification and radiologic projection as the live fluoroscopic image onto the video monitor above the catheterization table. The digital roadmap image thus provides immediate feedback to the angiographer to assist in directing the guidewire into the appropriate coronary artery branch and to help in placement of the balloon so that it straddles the site of stenosis.

To assess the ability to detect coronary artery narrowings from computer-acquired angiograms, a panel of 4 observers independently identified and measured focal coronary narrowings from digital subtraction angiograms and compared the results to those obtained from standard 35-mm cine film angiograms. Both cine and digital angiograms were obtained sequentially using selective intracoronary artery injection of standard amounts of iodinated contrast media. Digital images were obtained at 8 frames/s with a 512 X 512 X 8-bit pixel matrix. Modifications in the imaging chain for computer acquisition included a slower pulsed radiographic mode, a progressive scan camera, and initial storage of the images on an 80-megabyte digital hard disk. Postprocessing computer algorithms were used to enhance the unsubtracted digital images; these included single-frame, mask-mode subtraction, vessel boundary edge enhancement, and 4-fold pixel magnification. In 19 patient studies, 32 arteries were reduced more than 25% in diameter according to at least 1 of 4 observers on either the digital or cine film angiograms. There was no significant difference in the mean percent diameter narrowing for all the narrowings between the digital angiograms (53 +/- 31%) and the cineangiograms (52 +/- 31%). In addition, a 2-way analysis of variance yielded no significant difference between the amount of variability in the measurements between the cine film and the digital technique. This similar variability persisted when subsets of patients based on the degrees of stenosis were considered (e.g., only narrowings from 50 to 90% diameter reduction).(ABSTRACT TRUNCATED AT 250 WORDS)

To understand whether quantitative measurement of minimal coronary luminal diameter is a better method than percent diameter narrowing for assessing the functional impairment of myocardial contractility produced by coronary artery stenoses, measurements were made from 37 stenotic segments in 27 patients with coronary artery disease and from corresponding segments in 10 subjects without coronary artery narrowing. An assessment of the reliability of the 2 types of measurements was made by correlating them with the physiologic parameters of both segmental wall motion and global ejection fraction response induced by atrial pacing. Digitally acquired coronary angiograms were used to facilitate quantitative analysis. Measurements by edge detection and videodensitometry correlated closely (r = 0.94). Percent diameter narrowing correlated moderately with the change in ejection fraction (r = -0.41) or with the change in segmental wall motion (r = -0.44). The measurement of minimal lumen diameter correlated with the change in global ejection fraction (r = 0.61) and did so even better with the change in segmental wall motion (r = 0.78, p less than 0.05). A minimal lumen diameter of less than or equal to 1.5 mm identified patients likely to have a functional impairment during atrial pacing as assessed by either global ejection fraction or segmental wall motion defects. We conclude that minimal coronary luminal diameter provides a better method than percent diameter narrowing calculations to measure the anatomic severity of coronary artery narrowing.

Quantitative measurements of coronary stenoses were made from digital coronary angiograms in 19 patients before and after percutaneous transluminal coronary angioplasty (PTCA). Two methods of measurement were compared. Mean stenosis before PTCA was 67 +/- 10% by the edge detection method and 67 +/- 12% by videodensitometry (difference not significant). After PTCA, the mean stenosis was 32 +/- 14% by edge detection and 30 +/- 13% by videodensitometry (difference not significant). In addition, a new method was developed to rapidly calculate the absolute minimum luminal area and diameter by videodensitometry. The minimum luminal diameter before PTCA was 1.0 +/- 0.5 mm and after PTCA increased to 2.4 +/- 0.5 mm (p less than 0.001). The validity of the videodensitometric method was analyzed in a series of Lucite phantom studies, which suggested that when there is an irregular angiographic appearance, the densitometric method may be more accurate than standard edge detection methods. Digital acquisition of coronary angiograms provides a means for rapid application of quantitative analysis during coronary interventional procedures.

In an attempt to improve visualization of the position of the guidewire and dilatation balloon during coronary angioplasty, a method was developed called digital coronary roadmapping. With this method a digitally acquired coronary angiogram is interlaced with the live fluoroscopic image of the guidewire and balloon catheter. The digital coronary angiogram is superimposed at the same magnification and radiologic projection as the live fluoroscopic image onto the video monitor above the catheterization table. The digital roadmap image thus provides immediate feedback to the angiographer to assist in directing the guidewire into the appropriate coronary artery branch and to help in placement of the balloon so that it straddles the site of stenosis.