Search

The application of contaminated paper sludge on arable land in southwest Germany caused the occurrence of a broad range of poly- and perfluoroalkyl substances (PFASs) on soil. Recently, the dead-end transformation products (TPs) perfluorooctanoic acid and perfluorooctanesulfonic acid were detected in groundwater and drinking water. The precursors and other transformation products mostly remained unknown. Therefore, HRMS screening by Kendrick mass analysis and assignment of homologous series in combination with suspect screening were applied to identify original PFASs and their TPs in four different soil samples from sites where contaminated paper sludge was applied. In total, twelve compound classes comprising more than 61 PFASs could be fully or tentatively identified. The data reveal that contamination mainly originates from polyfluorinated dialkylated phosphate esters (from 4:2/6:2 to 12:2/14:2), N-ethyl perfluorooctane sulfonamide ethanol–based phosphate diesters (only C8/C8) and transformation products of these precursors. Contamination patterns can be attributed to PFASs used for paper impregnation and can vary slightly from site to site. [ABSTRACT FROM AUTHOR]

The aim of this work was to investigate the occurrence and fate of the antidiabetic metformin (MF) and its transformation products (TPs) in wastewater and surface water samples. New TPs of MF were approached by electrochemical degradation with a boron-doped-diamond electrode (at 1.5 V for 10 min). 2,4-Diamino-1,3,5-triazine (2,4-DAT), methylbiguanide (MBG), 2-amino-4-methylamino-1,3,5-triazine (2,4-AMT) and 4-amino-2-imino-1-methyl-1,2-dihydro-1,3,5-triazine (4,2,1-AIMT) were identified by hydrophilic interaction chromatography (HILIC) with quadrupole time-of-flight mass spectrometry (QTOF-MS) and accurate mass fragmentation. However, the well-known transformation product guanyl urea (GU) could not be formed electrochemically. In samples from wastewater treatment plants (WWTP), 2,4-AMT and 2,4-DAT showed an increasing trend from influents to effluents, which implies formation of the TPs during WWT. MBG is also formed by hydrolysis of MF and therefore didn't show this trend in WWTPs. Compared to GU, the concentrations of other TPs are generally three orders of magnitude lower. MBG and 2,4-DAT were also detected in surface water which was impacted by waste water, while 4,2,1-AIMT could not be detected in any sample. The concentrations of MF were in an expected range for influent (14 to 95 μg/l), effluent (0.7 to 6.5 μg/l), surface water (up to 234 ng/l) and tap water (34 ng/l). GU concentrations, however, were in one of the two investigated WWTP much higher in the influent (between 158 μg/l and 2100 μg/l) than in the effluent (between 26 and 810 μg/l). This is a rather unexpected result which has not been reported yet. Obviously, GU has been already formed in parts of the sewer system from MF or from other biguanide compounds like antidiabetics or disinfection chemicals. Furthermore, lower concentrations of GU in the effluents than in the influents indicate degradation processes of guanyl urea in the waste water treatment. [ABSTRACT FROM AUTHOR]

Non-target screening (NTS) based on high-resolution mass spectrometry (HRMS) is necessary to comprehensively characterize per- and polyfluoroalkyl substances (PFAS) in environmental, biological, and technical samples due to the very limited availability of authentic PFAS reference standards. Since in trace analysis, MS/MS information is not always achievable and only selected PFAS are present in homologous series, further techniques to prioritize measured HRMS data (features) according to their likelihood of being PFAS are highly desired due to the importance of efficient data reduction during NTS. Kaufmann et al. (J AOAC Int, 2022) presented a very promising approach to separate selected PFAS from sample matrix features by plotting the mass defect (MD) normalized to the number of carbons (MD/C) vs. mass normalized to the number of C (m/C). We systematically evaluated the advantages and limitations of this approach by using ~ 490,000 chemical formulas of organic chemicals (~ 210,000 PFAS, ~ 160,000 organic contaminants, and 125,000 natural organic matter compounds) and calculating how efficiently, and especially which, PFAS can be prioritized. While PFAS with high fluorine content (approximately: F/C > 0.8, H/F < 0.8, mass percent of fluorine > 55%) can be separated well, partially fluorinated PFAS with a high hydrogen content are more difficult to prioritize, which we discuss for selected PFAS. In the MD/C-m/C approach, even compounds with highly positive MDs above 0.5 Da and hence incorrectly assigned to negative MDs can still be separated from true negative mass defect features by the normalized mass (m/C). Furthermore, based on the position in the MD/C-m/C plot, we propose the estimation of the fluorine fraction in molecules for selected PFAS classes. The promising MD/C-m/C approach can be widely used in PFAS research and routine analysis. The concept is also applicable to other compound classes like iodinated compounds. [ABSTRACT FROM AUTHOR]

Denatonium, one of the bitterest substances known to man, was recently identified as wastewater borne micropollutant in surface waters. Therefore, photodegradation experiments and electrochemical degradation were performed to identify abiotic and putative biotic transformation products (TPs). Indirect rather than direct photodegradation proved to be important for denatonium removal by solar irradiation and produced seven TPs. Amide hydrolysis, hydroxylation, N-dealkylation, and N-dearylation were revealed as the main mechanisms. Anodic oxidation of denatonium was related to the formation of overall ten products and despite considerable different yields, all TPs from indirect photodegradation were mimicked electrochemically. Among them, lidocaine was the only TP detected after conventional wastewater treatment and in surface waters. The occurrence of lidocaine was however associated with its application as local anesthetic rather than to a degradation of denatonium. The absence of additional products suggests that denatonium degradation is negligible under environmental conditions, supporting the previously described persistent nature of this compound. Advanced water treatment techniques however have the potential to degrade denatonium. About 74% of the initial denatonium load was removed from wastewater during pilot-scale ozonation. The degradation of denatonium was accompanied here with the formation of at least two polar products, which are passing unchanged through a sand filter after ozonation. Both substances have completely unknown (toxicological) properties and this study seems to be the first report about their structures in general, as none of them was found in any of the large compound libraries (e.g. PubChem). Unlabelled Image • Indirect photodegradation and electrochemical oxidation resulted in overall ten TPs. • Five products were identified with a confidence level of 2 or better. • High persistence of denatonium in conventional wastewater treatment and in surface waters observed. • Denatonium removal by ozonation is associated with the formation of polar TPs. [ABSTRACT FROM AUTHOR]

The pharmaceutical torasemide is an important loop diuretic and was 2017 one of the ten most prescribed drugs in Germany. Despite its detection in different compartments of the urban water cycle including drinking water, no studies were so far performed to elucidate its fate in the environment and the occurrence of transformation products (TPs). Therefore, we investigated the phototransformation, microbial degradation, transformation with human liver microsomes and anodic oxidation of torasemide to obtain good coverage of environmentally relevant degradation products. Overall sixteen products were identified, covering the following reaction mechanisms: aromatic and aliphatic hydroxylation, including further oxidation to carboxylic acids and quinone imines, amide cleavage, N-dealkylation, N-dearylation, and sulfonamide hydrolysis to sulfonic acids. Especially the formation of quinone imines could be of concern as they are highly reactive electrophiles. Torasemide itself was observed in all investigated wastewater treatment plant (WWTP) samples and wastewater-impacted surface waters. The maximum detected concentration was about 350 ng L−1. Only three of the sixteen transformation products were generally observed in at least one of the samples and the most frequently detected TPs were the human metabolites hydroxytorasemide (TP 364a) and carboxytorasemide (TP 378a). The complete removal of TP 364a during wastewater treatment was in agreement with the results of microbial degradation experiments. TP 364a was most likely transformed into TP 378a, which was microbially less degraded in lab experiments. Based on estimated concentrations, TP 378a could reach about 1 μg L−1 in the investigated wastewater matrices. Image 1 • Overall sixteen abiotic and biotic products identified for torasemide. • Formation of reactive products proven with trapping experiments using reduced glutathione. • Torasemide and carboxytorasemide detected in all WWTPs and wastewater-impacted surface waters. [ABSTRACT FROM AUTHOR]