Search

The control and improvement of heat transfer in enclosures is very important in several engineering applications. In the current two-dimensional numerical study, the mixed convection and entropy generation of water flowing inside a square vented enclosure that contains four vibrating cylinders with relatively low frequencies fr = 1, 2, 3, 5 Hz in the vertical and horizontal directions are reported. The effects of Reynolds and Richardson numbers, vibration frequency, vibration amplitude, and the direction of the cylinders' vibration on heat transfer and entropy generation are presented for various cases. The horizontal walls of the enclosure are kept adiabatic while the vertical left and right walls are hot and cold, respectively. The linear regression analysis was used to reveal the rate of increase in the Nusselt number with the Reynolds and Richardson numbers number for each cases. Series of analyses show that the existence and the vibration of the cylinders increases heat transfer but the vibration in the horizontal direction is more effective since the top and bottom walls of the enclosure are adiabatic. It is found that the entropy generation due to heat transfer is low at the center of the enclosure. The direct relationship between the heat transfer and both Reynolds and Richardson numbers is reported. In terms of heat transfer, it is found that the critical vibration frequency and amplitude are fr = 4 and A = 0.05L and 0.075L. [ABSTRACT FROM AUTHOR]

This study numerically investigates the free convective heat transfer of a non-Newtonian nanofluid through an F-shaped porous cavity. The thermal conditions of the walls of the cavity are assigned as TC and TH for the cold right wall and the hot left wall, respectively, and the remaining walls of the cavity are assigned as insulated walls. The model for this investigation is designed, implemented, and analyzed by COMSOL Multiphysics. The Galerkin finite element method is used to model and solve the governing equations of the flow and heat transfer process inside the porous media. Physical parameters are presented in the following order: 6 × 10 0.0, ≥ ≥ φ -2 0.4 AR 0.1, 10 10, 1.4 ≥ ≥ ≥≥ -1 Da -3 ≥n ≥ 0.6, and 10 10 ≥ ≥ Ra 6. The goal of this study is to study the influence of geometry configuration (F shape) and the above parameters on the flow structure, isotherms, and heat transfer. These parameters have been taken into account to investigate their effects on this kind of heat transfer mechanism. Results show that the addition of nanoparticles plays a significant role in changing heat transfer rates. In addition, an increase in the aspect ratio (AR) leads to create narrow areas, which promotes the stagnation zones, thus decreasing the distance between cold and hot walls. This, in turn, enhances the flow uniformity. Moreover, it has been generally concluded that the Nusselt number and velocity rates are directly proportional to the AR, Darcy number (Da), and Rayleigh number (Ra), and negatively proportional to the power-law index (n); however, there are some exceptions and unusual behaviors noticed and explained through the paper. [ABSTRACT FROM AUTHOR]

The energy loss through building components resulting in higher energy consumption, thus energy saving has become an essential aspect in design and comfort. This study aims to optimize the thermal insulation of red clay bricks used in the walls of buildings by using a multiscale method. The finite element approach in ABAQUS software has been used to simulate the bricks under different configurations and conditions. Due to cost and time challenges and difficulties in simulation and complex calculations, simplified and applicable equations have been derived to calculate thermal insulation properties. The results show that the paper's brick design has a significant thermal conductivity reduction that could reach more than one-third of the other corresponding studies. The study goes to fill the hollow bricks by the insulation polyurethane foam (PUF) and comparing the results with air hollow bricks. Besides its other advantages, the outcomes reveal that using the PUF has a noticeable desired-influence in thermal insulation when considering the heat transfer by convection and radiation inside the air cavity of bricks. [ABSTRACT FROM AUTHOR]