Search

The high‐pressure gas expansion‐induced deformation and dynamic fracture of coal are important parts of coal and gas outburst. To better understand the law of this process, laboratory experiments and numerical simulation are used to study the law of damage. A cavity with different pressures of CH4 or N2 was destroyed by a jack to achieve the rapid expansion of the gas and coal fracture inside. The particle size distribution of the coal particles before and after the experiment was measured, and the breakage ratio and the newly added surface area were calculated. The experimental results indicate that during the gas expansion process, the breakage ratio of coal and the newly added surface area clearly increase with the increase in gas pressure. Finally, a numerical model based on peridynamic theory was developed to simulate crack generation and the propagation of coal induced by the expansion of gases at different pressures. The numerical simulation results show that the higher the initial gas pressure is, the higher the number of failure units. Moreover, only when the gas pressure is large enough will the coal crack in various directions at the same time.

The detection of electromagnetic radiation (EMR) during the fracture of solid materials such as rocks and coal has been widely used in seismic exploration and mine dynamic disaster prediction. As described in this paper, we conduct uniaxial compression tests on coal, cement, and glass materials to determine the characteristic EMR differences among materials. A band-stop filter based on the Fourier transform and the wavelet packet transform method are used to conduct signal denoising and analysis. Basic analyses of the pulse-time characteristics, energy distribution, cumulative energy, and waveform characteristics of EMR are conducted. The research results show that there is a strong corresponding relation between the loading time, loading stress and EMR energy. A large number of EMR events are released in rapid succession during the main rupture of coal and cement, while the EMR events are evenly distributed throughout the whole loading process of glass. For the same material, the maximum EMR amplitude increases with an increasing peak value of the stress. The EMR pulse waveform of coal and cement agrees well with predictions based on the theoretical formula of the electromagnetic dipole oscillation EMR generation mechanism. The paper provides further theoretical basis for understanding the mechanism of EMR, with great significance for improving coal mining safety.

An experiment designed to simulate coal during excavation was conducted. Microseismic signals of coal under vibration conditions during excavation and subsequent waiting time of the coal roadway at different excavation speeds were collected and analyzed. During the excavation and subsequent waiting time, the stress in coal is redistributed, and the concentrated stress is gradually transferred to the deeper section of the coal seam. The Hilbert–Huang transform (HHT) is used to effectively denoise the collected signals. According to the noise-reduced signal, the amplitude and pulse number of the microseismic signals emitted during the excavation process are much larger than those of the waiting time process. During excavation, the energy and event numbers of microseismic signals increase first and then decrease as the excavation speed increases. The faster the excavation speed, the more the energy, and the higher the event numbers of the microseismic signals released during the subsequent waiting time. When the excavation speed is faster, more elastic potential accumulates in the coal seam and the concentration stress is greater. As the concentrated stress moves forward in time without excavation, more coal seams fail, and more microseismic signals are released. The microseismic signal and the stress evolution law can provide a reasonable explanation for the forward movement of the concentrated stress and coal failure during roadway excavation.