Search

Electrical machines with high-temperature superconducting (HTS) armature windings can benefit from high power density and efficiency. Furthermore, by using permanent magnets (PM) on the rotor, the cryogenic system can be significantly simplified compared with the fully superconducting (SC) machines or the machines with SC field windings. Compared with the conventional electrical machines, the performance of machines with HTS armature windings can be more sensitive to the design parameters due to the interaction between the operating current and the flux density. In this article, the influence of stator geometry on the machine with HTS armature windings and PM rotor is investigated. By considering the interaction between the operating current and the flux density, an iteration procedure for calculating the operating current of the HTS armature windings is proposed. A 10-MW surface-mounted PM wind power generator with HTS armature windings is studied by the finite element analysis. It is found that machines with different coil angle have different behaviors when changing the tooth width and the dimensions of tooth tips, which is different from conventional electrical machines. A new design and optimization method is then developed. Finally, the optimal design is identified with global optimization. [ABSTRACT FROM AUTHOR]

This paper compares the electromagnetic performance of 10-MW superconducting (SC) generators with three different topologies, i.e., iron-cored stator and rotor topology (ISIRT), iron-cored stator and air-cored rotor topology (ISART), and air-cored stator and rotor topology (ASART). The objective is to provide a powerful insight into the advantages and disadvantages of different topologies, and to establish some design guidelines for selecting an appropriate direct-drive SC generator for offshore wind turbine applications. First, the structures of the three SC generator topologies are introduced. Then, the influence of the SC coil cross-sectional area on torque capability is compared. After that three SC generators with different topologies are optimized, respectively, for further comparison, including the active material cost, weight, harmonics in the electromotive force, torque ripple, field harmonics in the SC coil, and forces on the rotor and stator components, etc. It is found that, with the same SC quantity, the torque capability of the ISIRT is much better than that of the other two topologies. However, the advantage becomes less significant when a larger area of the SC coil is employed. The air-gap flux density waveform of the ASART is much smoother than those of the ISIRT and ISART. The torque ripples of the ISIRT and the ISART are much higher than that of the ASART. The field harmonics (both amplitude and frequency) in the SC coil of the ASART are the lowest. For the ISIRT, most of the force on the rotor is acting on the rotor iron, and thus, the SC coil is more likely to be safe from a mechanical performance point of view and the design of the corresponding supporting structure is simple. However, for the air-cored rotor topologies, nearly all the force is acting on the SC coil. For the air-cored stator, the force mainly acts on the armature winding, whereas for the iron-cored stator, it is mainly on the stator teeth. Due to the excellent mechanical performance of iron, the iron-cored stator is therefore more robust. [ABSTRACT FROM PUBLISHER]

This paper investigates the influence of pole number and stator outer diameter on the performance of superconducting (SC) generators. The SC generator has an iron-cored rotor topology. First, the generator structure is introduced and the optimization procedure is described. Then, the influence of design parameters on performance, in terms of generator volume, weight, SC wire utilization, active material cost, etc., is presented. Some relationships for the optimal combinations for different performance attributes are established. In addition, the influence of SC material price on the determination of optimal stator outer diameter and pole number is discussed. Finally, the influence of SC coil area per pole on performance is also investigated. [ABSTRACT FROM PUBLISHER]