Search

Background: Walking impairments are a common consequence of neurological disorders and are assessed with clinical scores that suffer from several limitations. Robot-assisted locomotor training is becoming an established clinical practice. Besides training, these devices could be used for assessing walking ability in a controlled environment. Here, we propose an adaptive assist-as-needed (AAN) control for a treadmill-based robotic exoskeleton, the Lokomat, that reduces the support of the device (body weight support and impedance of the robotic joints) based on the ability of the patient to follow a gait pattern displayed on screen. We hypothesize that the converged values of robotic support provide valid and reliable information about individuals' walking ability. Methods: Fifteen participants with spinal cord injury and twelve controls used the AAN software in the Lokomat twice within a week and were assessed using clinical scores (10MWT, TUG). We used a regression method to identify the robotic measure that could provide the most relevant information about walking ability and determined the test–retest reliability. We also checked whether this result could be extrapolated to non-ambulatory and to unimpaired subjects. Results: The AAN controller could be used in patients with different injury severity levels. A linear model based on one variable (robotic knee stiffness at terminal swing) could explain 74% of the variance in the 10MWT and 61% in the TUG in ambulatory patients and showed good relative reliability but poor absolute reliability. Adding the variable 'maximum hip flexor torque' to the model increased the explained variance above 85%. This did not extend to non-ambulatory nor to able-bodied individuals, where variables related to stance phase and to push-off phase seem more relevant. Conclusions: The novel AAN software for the Lokomat can be used to quantify the support required by a patient while performing robotic gait training. The adaptive software might enable more challenging training conditions tuned to the ability of the individuals. While the current implementation is not ready for assessment in clinical practice, we could demonstrate that this approach is safe, and it could be integrated as assist-as-needed training, rather than as assessment. Trial registration: ClinicalTrials.gov Identifier: NCT02425332. [ABSTRACT FROM AUTHOR]

Inertial Measurement Units (IMUs) have gained popularity in gait analysis and human motion tracking, and they provide certain advantages over stationary line-of-sight-dependent Optical Motion Capture (OMC) systems. IMUs appear as an appropriate alternative solution to reduce dependency on bulky, room-based hardware and facilitate the analysis of walking patterns in clinical settings and daily life activities. However, most inertial gait analysis methods are unpractical in clinical settings due to the necessity of precise sensor placement, the need for well-performed calibration movements and poses, and due to distorted magnetometer data in indoor environments as well as nearby ferromagnetic material and electronic devices. To address these limitations, recent literature has proposed methods for self-calibrating magnetometer-free inertial motion tracking, and acceptable performance has been achieved in mechanical joints and in individuals without neurological disorders. However, the performance of such methods has not been validated in clinical settings for individuals with neurological disorders, specifically individuals with incomplete Spinal Cord Injury (iSCI). In the present study, we used recently proposed inertial motion-tracking methods, which avoid magnetometer data and leverage kinematic constraints for anatomical calibration. We used these methods to determine the range of motion of the Flexion/Extension (F/E) hip and Abduction/Adduction (A/A) angles, the F/E knee angles, and the Dorsi/Plantar (D/P) flexion ankle joint angles during walking. Data (IMU and OMC) of five individuals with no neurological disorders (control group) and five participants with iSCI walking for two minutes on a treadmill in a self-paced mode were analyzed. For validation purposes, the OMC system was considered as a reference. The mean absolute difference (MAD) between calculated range of motion of joint angles was 5.00 ° , 5.02 ° , 5.26 ° , and 3.72 ° for hip F/E, hip A/A, knee F/E, and ankle D/P flexion angles, respectively. In addition, relative stance, swing, double support phases, and cadence were calculated and validated. The MAD for the relative gait phases (stance, swing, and double support) was 1.7 %, and the average cadence error was 0.09 steps/min. The MAD values for RoM and relative gait phases can be considered as clinically acceptable. Therefore, we conclude that the proposed methodology is promising, enabling non-restrictive inertial gait analysis in clinical settings. [ABSTRACT FROM AUTHOR]

Background: Many patients with neurological movement disorders fear to fall while performing postural transitions without assistance, which prevents them from participating in daily life. To overcome this limitation, multi-directional Body Weight Support (BWS) systems have been developed allowing them to perform training in a safe environment. In addition to overground walking, these innovative/novel systems can assist patients to train many more gait-related tasks needed for daily life under very realistic conditions. The necessary assistance during the users' movements can be provided via task-dependent support designs. One remaining challenge is the manual switching between task-dependent supports. It is error-prone, cumbersome, distracts therapists and patients, and interrupts the training workflow. Hence, we propose a real-time motion onset recognition model that performs automatic support switching between standing-up and sitting-down transitions and other gait-related tasks (8 classes in total).Methods: To predict the onsets of the gait-related tasks, three Inertial Measurement Units (IMUs) were attached to the sternum and middle of outer thighs of 19 controls without neurological movement disorders and two individuals with incomplete Spinal Cord Injury (iSCI). The data of IMUs obtained from different gait tasks was sent synchronously to a real-time data acquisition system through a custom-made Bluetooth-EtherCAT gateway. In the first step, data was applied offline for training five different classifiers. The best classifier was chosen based on F1-score results of a Leave-One-Participant-Out Cross-Validation (LOPOCV), which is an unbiased way of testing. In a final step, the chosen classifier was tested in real time with an additional control participant to demonstrate feasibility for real-time classification.Results: Testing five different classifiers, the best performance was obtained in a single-layer neural network with 25 neurons. The F1-score of [Formula: see text] and [Formula: see text] are achieved on testing using LOPOCV and test data ([Formula: see text], participants = 20), respectively. Furthermore, the results from the implemented real-time classifier were compared with the offline classifier and revealed nearly identical performance (difference = [Formula: see text]).Conclusions: A neural network classifier was trained for identifying the onset of gait-related tasks in real time. Test data showed convincing performance for offline and real-time classification. This demonstrates the feasibility and potential for implementing real-time onset recognition in rehabilitation devices in future. [ABSTRACT FROM AUTHOR]

Background: The overall goal of this paper was to investigate approaches to controlling active participation in stroke patients during robot-assisted gait therapy. Although active physical participation during gait rehabilitation after stroke was shown to improve therapy outcome, some patients can behave passively during rehabilitation, not maximally benefiting from the gait training. Up to now, there has not been an effective method for forcing patient activity to the desired level that would most benefit stroke patients with a broad variety of cognitive and biomechanical impairments. Methods: Patient activity was quantified in two ways: by heart rate (HR), a physiological parameter that reflected physical effort during body weight supported treadmill training, and by a weighted sum of the interaction torques (WIT) between robot and patient, recorded from hip and knee joints of both legs. We recorded data in three experiments, each with five stroke patients, and controlled HR and WIT to a desired temporal profile. Depending on the patient's cognitive capabilities, two different approaches were taken: either by allowing voluntary patient effort via visual instructions or by forcing the patient to vary physical effort by adapting the treadmill speed. Results: We successfully controlled patient activity quantified by WIT and by HR to a desired level. The setup was thereby individually adaptable to the specific cognitive and biomechanical needs of each patient. Conclusion: Based on the three successful approaches to controlling patient participation, we propose a metric which enables clinicians to select the best strategy for each patient, according to the patient's physical and cognitive capabilities. Our framework will enable therapists to challenge the patient to more activity by automatically controlling the patient effort to a desired level. We expect that the increase in activity will lead to improved rehabilitation outcome. [ABSTRACT FROM AUTHOR]

Visual biofeedback with information about the patients' degree of activity is a valuable adjunct to robot-assisted gait training as means of increasing the motivation and participation of the patients during highly repetitive training sessions. In the driven gait orthosis (DGO) Lokomat, an estimation of the patient's activity level was based on man-machine interaction forces as measured at the hip and knee actuators of the exoskeletal device. In an early approach, theoretical assumptions about the expected man-machine interaction forces, due to the varying behavior of the patients, were formulated for the calculation of quantitative biofeedback. In contrast to this theory-based approach, we have developed a novel method where the biofeedback calculations were based on measured reference man-machine interaction force profiles of healthy subjects when walking with different degrees of activity. To account for intrasubject and intersubject variability, reference force profiles were processed in a model to generate multiple force profiles describing each activity state. To estimate the activity of a subject walking in the DGO, the man-machine interaction force profile was measured, matched to each of the generated force profiles, and the best fitting profile of the different activity states was identified by the smallest Euclidian distance, respectively. By calculating the difference between these Euclidian distances, a quantitative estimate of the patient's degree of activity was obtained. The novel method was evaluated and compared to the conventional approach in a study with 18 healthy subjects. This comparison showed that the novel method was more reliable in detecting different activity states and is, therefore, a promising approach for future biofeedback systems. [ABSTRACT FROM AUTHOR]

Background: Body weight support (BWS) is often provided to incomplete spinal cord injury (iSCI) patients during rehabilitation to enable gait training before full weight-bearing is recovered. Emerging robotic devices enable BWS during overground walking, increasing task-specificity of the locomotor training. However, in contrast to a treadmill setting, there is little information on how unloading is integrated into overground locomotion. We investigated the effect of a transparent multi-directional BWS system on overground walking patterns at different levels of unloading in individuals with chronic iSCI (CiSCI) compared to controls.Methods: Kinematics of 12 CiSCI were analyzed at six different BWS levels from 0 to 50% body weight unloading during overground walking at 2kmh- 1 and compared to speed-matched controls.Results: In controls, temporal parameters, single joint trajectories, and intralimb coordination responded proportionally to the level of unloading, while spatial parameters remained unaffected. In CiSCI, unloading induced similar changes in temporal parameters. CiSCI, however, did not adapt their intralimb coordination or single joint trajectories to the level of unloading.Conclusions: The findings revealed that continuous, dynamic unloading during overground walking results in subtle and proportional gait adjustments corresponding to changes in body load. CiSCI demonstrated diminished responses in specific domains of gait, indicating that their altered neural processing impeded the adjustment to environmental constraints. CiSCI retain their movement patterns under overground unloading, indicating that this is a viable locomotor therapy tool that may also offer a potential window on the diminished neural control of intralimb coordination. [ABSTRACT FROM AUTHOR]

Robot-assisted treadmill training is an established intervention used to improve walking ability in patients with neurological disorders. Although it has been shown that attention to the task is a key factor for successful rehabilitation, the psychological state of patients during robot-assisted gait therapy is often neglected. We presented 17 nondisabled subjects and 10 patients with neurological disorders a virtual-reality task with varying difficulty levels to induce feelings of being bored, excited, and overstressed. We developed an approach to automatically estimate and classify a patient's psychological state, i.e., his or her mental engagement, in real time during gait training. We used psychophysiological measurements to obtain an objective measure of the current psychological state. Automatic classification was performed by a neural network. We found that heart rate, skin conductance responses, and skin temperature can be used as markers for psychological states in the presence of physical effort induced by walking. The classifier achieved a classification error of 1.4% for nondisabled subjects and 2.1% for patients with neurological disorders. Using our new method, we processed the psychological state data in real time. Our method is a first step toward real-time auto-adaptive gait training with potential to improve rehabilitation results by optimally challenging patients at all times during exercise. [ABSTRACT FROM AUTHOR]