Search

This research presents a microfluidically reconfigurable additively manufactured antenna. The proposed configuration demonstrates the applicability of additive manufacturing (AM) for fabricating intricate and lightweight structures. Additionally, it established the feasibility of microfluidic technology for achieving continuous frequency reconfigurability. The proposed antenna utilizes the dielectric fluid for reconfiguration, facilitated by pumping it in and out of microfluidic structures using a syringe pump. The incorporation of dielectric fluid in the channels alters the effective dielectric constant of the substrate and causes perturbations in the electric field distributions around the metallic patch. To validate the proposed idea, a prototype of the microfluidically reconfigurable 3D-printed antenna is designed, fabricated, and tested. The operating frequency is reconfigured from 2.38 to 3.49 GHz with a tuning range of 1.11 GHz, and the radiation pattern remains stable across considered cases. It is observed that measured results are in good agreement with simulated values. The prototype of the antenna design is fabricated using a single machining process, eliminating the need for traditional machining. The proposed antenna's configuration is advantageous for various applications such as IEEE802.11b/g/n, IEEE802.15.1, and IEEE802.16. [ABSTRACT FROM AUTHOR]

This paper describes the 3D-printed open Double Square Loop (DSL) Frequency Selective Surfaces (FSSs) based Radio Frequency energy harvester specifically designed for the purpose of capturing Wi-Fi ambient RF energy. The proposed dual-band energy harvesting circuit is a suitable applicant for low-power green IoT Wireless Sensor Networks. The inclusion of FSS in the receiver improved the antenna's gain by 42% and 74% at 2.4 GHz and 5.2 GHz, respectively, and consequently, enhanced the conversion efficiency. Due to FSS-backed dual-band antenna, the proposed configuration gathers a significant amount of RF ambient energy from the surroundings. The collected RF energy is then converted into DC voltage using a three-stage Villard RF rectifier cum multiplier. The Fused Deposition Modeling (FDM) of 3D printing is employed to create the designed prototype on a biodegradable Polylactic Acid substrate. RF measurements are taken with horn antenna and signal generator to evaluate the proposed design. At 2.4 GHz, the constructed prototype has a conversion efficiency of 67.90% and a corresponding output voltage of 2.36 V, whereas, at 5.2 GHz, it achieves an efficiency of 34.01% with output voltage of 1.67 V, at 0 dBm input power. The proposed configuration has a good correlation between simulated and measured outcomes. [ABSTRACT FROM AUTHOR]