Search

The paper reports the details of numerical models used to predict the performance of two 3.6 m-high well-instrumented wrapped-face walls. The walls were nominally identical except that the reinforcement material in one wall was a steel welded wire mesh and in the other a biaxial polypropylene geogrid. The backfill soil was modelled using both linear and nonlinear elastic-plastic constitutive models. A general hyperbolic (nonlinear) axial load-strain-time model was used for the reinforcement. The numerical results show good agreement with measured performance features for the welded wire mesh wrapped-face wall. Agreement between numerical predictions of facing displacements and maximum reinforcement loads was less accurate for the very flexible geogrid wrapped-face wall. The discrepancies are believed to be related to the unusually flexible wrapped face used in the geogrid wall construction. Numerically predicted and measured maximum reinforcement loads are compared to loads using the AASHTO reinforcement strength-based design approach (Simplified Method) and the Simplified Stiffness Method which is an empirical reinforcement stiffness-based method. The paper provides physical test data that can be used to benchmark other numerical models, highlights lessons learned during the development of the models, and identifies reasonable expectations for numerical model accuracy for models of similar complexity used to simulate the performance of mechanically stabilized earth (MSE) wall structures under operational conditions. [ABSTRACT FROM AUTHOR]

Copyright of Canadian Geotechnical Journal is the property of Canadian Science Publishing and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

Geosynthetic-reinforced and column-supported (GRCS) embankments have proven to be an effective construction technique for fills on soft foundations. The paper introduces a modified unit cell approach to model GRCS embankments supported by deep mixed column walls. The modified unit cells include linear elastic springs at one or both vertical boundaries to simulate lateral displacements of the embankment fill and foundation soil. The finite difference program FLAC is used to compare numerical outcomes using the modified unit cells with those using the typical unit cell arrangement with lateral rigid side boundaries. Numerical results demonstrate good agreement between simulations using small-strain and large-strain modes in some cases and large differences in other cases. Lateral displacements of the embankment fill and foundation soil using the modified unit cells are shown to have large influence on reinforcement loads. Finally the paper demonstrates that calculated reinforcement loads are sensitive to choice of small-strain or large-strain mode when using program FLAC. [ABSTRACT FROM AUTHOR]

Copyright of Canadian Geotechnical Journal is the property of Canadian Science Publishing and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

The choice of structure element to simulate soil reinforcement and soil–structure interaction details for numerical modelling of mechanically stabilized earth (MSE) walls can have a significant influence on numerical outcomes. Program FLAC (finite difference method) offers three different options (beam, cable and strip element) to model the reinforcement and program PLAXIS (finite element method) has two (beam and geogrid element). Both programs use different models and properties to simulate the mechanical behaviour of the interface between dissimilar materials. The paper describes the details of the linear elastic Mohr–Coulomb interface model available in the two software packages to model material interaction and how to select model parameters to give the same numerical outcomes. The numerical results quantitatively demonstrate the conditions that give good agreement between the two programs for the same steel strip reinforced soil–structure problem and the situations where they do not. For example, the paper demonstrates that results can be very different depending on the type of structure element used to model horizontal reinforcement layers that are discontinuous in the plane-strain direction. [ABSTRACT FROM AUTHOR]