Search

To investigate the effects of fat layer on the temperature distribution during microwave atrial fibrillation catheter ablation in the conditions of different ablation time; 3D finite element models (fat layer and no fat layer) were built, and temperature distribution was obtained based on coupled electromagnetic-thermal analysis at 2.45 GHz and 30 W of microwave power. Results shown: in the endocardial ablation, the existence of the fat layer did not affect the shape of the 50 °C contour before 30 s. The increase speed of depth became quite slowly in the model with fat layer after 30 s. When ablation depth needed fixed, there are no significant effect on effectively ablation depth whether fat layer over or not. However, the existence of fat layer makes the temperature lower in the myocardium, and maximum temperature point closer to the myocardium surface. What is more, in the model with fat layer, effective ablation reach lower maximum temperature and the shallower depth of 50 °C contour. But there are larger ablation axial length and transverse width. In this case, doctor should ensure safety of normal cardiac tissue around the target tissue. In the epicardial ablation, the existence of fat layer seriously affects result of the microwave ablation. The epicardial ablation needs more heating time to create lesion. But epicardial ablation can be better controlled in the shape of effective ablation area because of the slowly increase of target variables after the appearing of 50 °C contour. Doctor can choose endocardial or epicardial ablation in different case of clinic requirement. [ABSTRACT FROM AUTHOR]

Hyperthermia technique has received much attention over the last decade being less invasive among the others. Laser therapy is among the most commonly investigated types of ablative hyperthermia for treatment of cancer. In this method an external heat source provided by a laser fiber leads the cancerous tissue to the necrosis stage. For its simulation a cylindrical geometry of a breast tissue containing a tumor is acted upon by a Gaussian form of laser radiation. Then the feasibility of a fat layer injection around the tumor during the therapy is investigated numerically. In order to consider the finite speed of heat transfer, dual phase lag (DPL) model is implemented for prediction of the thermal results. The therapy is addressed with and without the presence of a fat layer around the breast tumor. Results show that the temperature in the tumor increases up to 15 % by the injection of a fat layer. Also, the presence of a fat layer around the tumor shows that the irreversible ablation happens at a faster rate. • DPL model is implemented to analyze the effect of a fat layer around a breast tumor during ablative laser therapy. • The fat injection causes more damage inside the tumor. Therefore, the time of the hyperthermia process could be reduced. • It is shown that the temperature in the tumor increases up to 15% by the injection of a fat layer. • The irreversible ablated volume of tissue increases from 4.5cm3 to 4.81cm3 by injection of the fat layer around the tumor. [ABSTRACT FROM AUTHOR]