Search

The conical rotary compressor represents a solution for gases compression, for relatively small flow, in conditions of a superior energetic efficiency. Although the theoretical solution for the helical conical compressor was elaborated decades ago, a viable technology solution become possible at industrial level only after the development of machine tools with numerically controlled axes. In this paper is proposed a study, analytical and graphical, concerning the geometry of conical rotary compressor’s rotors, modelled by rapid prototyping technology. The propose modelling allow to elaborate various constructive forms for conical compressor’s rotors.

The problematic concerning the generating process uniformity, in the specific case of machining involute gear teeth with a rack shaped cutter provided by a single tooth is one of the notable challenges from gear teeth machining domain. In previous work, it has already been presented a solution of this problem, based on a graphical application in CATIA. The solution involves the modification of enveloping process ongoing, such as the circular feed motion takes place with variable speed. The variation law of feed motion speed that should be followed for smoothing the detached chip area is, obviously, different for each gear-type specific case. This paper is aiming to study the influence of generated tooth features onto this law form. Graphical and numerical applications addressing different cases of teeth numbers for the generated gear are presented and analyzed.

The hob mill is a cutting tool with a wide application for generation in machining of splined shafts. A method for profiling the hob mill for generation of square splines is presented in this paper. The analytical development was done based on a complementary theorem of surface enwrapping — the method of generating trajectories. A numerical application for a standardized spline shaft is presented. Based on the same theorem is presented a graphical application, developed in the CATIA design environment, for profiling the hob mill which generated standardised square splines.

The method of generating the gear tooth with a rack tool is applied on MAAG machine tools. Their specific cutting scheme leads to an irregular energetic loading of the tool cutting edge, during the rolling process. In this paper, we present a new method for analyzing the energetic load along the cutting edges of the rack shaped cutter, based on graphical modelling of the cutting process performed in CATIA. The energetic load smoothing is proposed to be obtained by finding an appropriate variation law for the circular feed communicated to the workpiece by toothing machine kinematical chain, during the rolling motion that permanently respects the rolling condition established between the centrodes attached to both tool and workpiece. A numerical solution in a concrete case of analysis is also included.