Search

To support cloud services, Data Centre Networks (DCNs) are constructed to have many servers and network devices, thus increasing the routing complexity and energy consumption of the DCN. The introduction of optical technology in DCNs gives several benefits related to routing control and energy efficiency. This paper presents a novel Packet Classification based Optical interconnect (PCOI) architecture for DCN which simplifies the routing process by classifying the packet at the sender rack and reduces energy consumption by utilizing the passive optical components. This architecture brings some key benefits to optical interconnects in DCNs which include (i) routing simplicity, (ii) reduced energy consumption, (iii) scalability to large port count, (iv) packet loss avoidance, and (v) all-to-one communication support. The packets are classified based on destination rack and are arranged in the input queues. This paper presents the input and output queuing analysis of the PCOI architecture in terms of mathematical analysis, the TCP simulation in NS2, and the physical layer analysis by conducting simulation in OptiSystem. The packet loss in the PCOI has been avoided by adopting the input and output queuing model. The output queue of PCOI architecture represents an M/D/32 queue. The simulation results show that PCOI achieved a significant improvement in terms of throughput and low end-to-end delay. The eye-diagram results show that a good quality optical signal is received at the output, showing a very low Bit Error Rate (BER). [ABSTRACT FROM AUTHOR]

This paper presents an energy-efficient technique to handle redundant traffic (EEHRT) in the zone-based routing for wireless sensor networks. In this technique, multihop routing is performed based on the remaining energy of the nodes. Afterwards, it performs position-based routing without the need for the nodes to know their respective position. The main objective of this paper is to handle the redundant packets generated in zone-based routing using short beacon messages. Nodes of lower zones route the data of the higher zone to base station (BS) with a minimum number of hops and utilize only those nodes on the path which are energy efficient and located closer to BS. Moreover, the source node is acknowledged by the relaying node using a wireless broadcast advantage (WBA) without sending any special ACK packet to the sender, which reduces the control overhead in the routing process. The EEHRT technique improves the routing against RARZ by ensuring only one copy of the packet is propagated at each hop along the routing path to BS. Simulation results show that EEHRT achieved 28% improvement in energy efficiency, 10% and 25% improvements in data throughput against total and distinct packet reception at BS respectively, 35% increase in overall network lifetime, and 100% reduction in redundant packets generation and propagation in the network against RARZ routing. [ABSTRACT FROM AUTHOR]