Search

Geosynthetic-reinforced and column-supported (GRCS) embankments have proven to be an effective construction technique for fills on soft foundations. The paper introduces a modified unit cell approach to model GRCS embankments supported by deep mixed column walls. The modified unit cells include linear elastic springs at one or both vertical boundaries to simulate lateral displacements of the embankment fill and foundation soil. The finite difference program FLAC is used to compare numerical outcomes using the modified unit cells with those using the typical unit cell arrangement with lateral rigid side boundaries. Numerical results demonstrate good agreement between simulations using small-strain and large-strain modes in some cases and large differences in other cases. Lateral displacements of the embankment fill and foundation soil using the modified unit cells are shown to have large influence on reinforcement loads. Finally the paper demonstrates that calculated reinforcement loads are sensitive to choice of small-strain or large-strain mode when using program FLAC. [ABSTRACT FROM AUTHOR]

The paper describes a numerical model that was developed to simulate the response of three instrumented, full-scale, geosynthetic-reinforced soil walls under working stress conditions. The walls were constructed with a fascia column of solid modular concrete units and clean, uniform sand backfill on a rigid foundation. The soil reinforcement comprised different arrangements of a weak biaxial polypropylene geogrid reinforcement material. The properties of backfill material, the method of construction, the wall geometry, and the boundary conditions were otherwise nominally the same for each structure. The performance of the test walls up to the end of construction was simulated with the finite-difference-based Fast Lagrangian Analysis of Continua (FLAC) program. The paper describes FLAC program implementation, material properties, constitutive models for component materials, and predicted results for the model walls. The results predicted with the use of nonlinear elastic-plastic models for the backfill soil and reinforcement layers are shown to be in good agreement with measured toe boundary forces, vertical foundation pressures, facing displacements, connection loads, and reinforcement strains. Numerical results using a linear elastic-plastic model for the soil also gave good agreement with measured wall displacements and boundary toe forces but gave a poorer prediction of the distribution of strain in the reinforcement layers. [ABSTRACT FROM AUTHOR]