Search

This paper proposes a wide band and multiband frequency reconfigurable antenna that can operate in the UWB, GSM, GPS, 4G LTE, WLAN, and WiMAX bands. The antenna is made up of a trapezoidal-shaped monopole radiator, which was inspired by a rectangular monopole antenna. The ground plane is modified by embedding T and L-shaped slots to notch the desired operating frequency. The proposed antenna can switch to six different frequencies using RF PIN diodes, making it suitable for modern wireless applications. A multilayer frequency selective surface (FSS) reflector is presented to improve the gain of the proposed reconfigurable antenna. The low-profile design achieved a significant increase in gain while retaining the UWB antenna's excellent impedance bandwidth. Because of the use of the FSS reflector, the antenna's average peak gain has increased from 6 to 10.4 dBi. The proposed antenna has a wide switching capability, which validates its unique feasibility for high-speed multiple Internet of Things applications via a common embedded platform under various applications.

In this paper, a novel ultra-wide-band antenna backed by a suspended ground for an enhancement of bandwidth and a frequency selective surface (FSS) reflector for the enhancement of gain is proposed in order to meet the specific coverage requirements for broadband applications. The impedance bandwidth of the proposed antenna is 13.4 GHz (1.8–15.2 GHz). To enhance the gain of the antenna, a FSS reflector is employed below the suggested ultra wide-band antenna. A novel FSS, which consists of 5 × 5 array of elements, located at a distance of 1.01 λ (36.14 mm) below the proposed antenna. There is 4–5 dBi improvement in antenna gain after application of the FSS. In order to observe the signal correlation of the proposed antenna, the time domain analysis using similar antennas in face-to-face and side-to-side scenarios has been performed using the EM simulation tool CST-STUDIO. The simulated results of the proposed antenna exhibit good agreement with the experimental results of the prototype model antenna.

In this paper, a broad band A-sandwich radome wall structure based on band-pass FSS (frequency selective surface) is proposed for an airborne radar applications. The FSS structure having two square conducting rings, which are embedded on either side of core layer. The conventional and proposed FSS based radome wall is analyzed with different incidence angles (0°, 10°, 20° and 30°) for both TE and TM polarization. The radome wall structure consist of a low density Nomex honeycomb core layer sandwiched between two high density Quartz skin layers. The structure shows the percentage impedance bandwidth of 40.8 % in the frequency range from 7.8GHz to 11.8GHz with sharp roll-off characteristics. The proposed novel approach involves high frequency unit cell simulation, which is carried out using EM Simulation Tool. To understand the practical behavior of the proposed structure for radome application the conformal analysis has been also carried out, with respect to different radius. The superior EM performance of the proposed broadband novel radome wall structure makes it suitable for the design of airborne radome.