Search

In order to solve the problem that the voltage source converter based multi-terminal direct current (VSC-MTDC) system cannot provide inertia and participate in frequency modulation after connecting to the AC power grid under the traditional control strategy, an adaptive control strategy based on virtual inertia is proposed. First, the relationship between AC frequency and DC voltage was established by a virtual inertia control, allowing the VSC-MTDC system to provide inertia to the AC side. Second, to address the limited inertia coefficient selection due to DC voltage deviation, an adaptive control was adopted. When the DC voltage deviation is small, the inertia coefficient is increased to obtain a better inertial response; on the contrary, the inertia coefficient is reduced to prevent the DC voltage from exceeding the limit. Finally, to solve the problem of insufficient flexibility of the fixed droop coefficient, this paper introduces the power margin of a VSC-station into the droop coefficient to dynamically adjust the distribution ratio of unbalanced power and reduce the DC voltage deviation. The three-terminal VSC-MTDC system was modelled on the PSCAD/EMTDC simulation platform, and the superiority of the control strategy was highlighted in this paper by comparing it with conventional droop control and a fixed virtual inertia coefficient. [ABSTRACT FROM AUTHOR]

In order to solve the coordinated optimization problem of distributed generation (DG), on‐load tap changer (OLTC) and capacitor banks, a dynamic reactive power optimization (DRPO) method based on fuzzy time clustering is proposed. In the method, fuzzy time clustering algorithm is used to cluster the static optimal switching sequence of OLTC and capacitor banks. The time decoupling of control variables is realized and it meets the constraints of the maximum switching times. Next, the influencing factors of DG reactive power limit are analysed. Considering the control ability of OLTC, capacitor banks and DG in voltage and reactive power optimization, a coordinated optimization method is proposed. Since the adjustment of OLTC tap position directly affects the voltage and reactive power distribution of the whole line, the switching time and tap position of OLTC are determined based on the static optimization results of each time and fuzzy time clustering algorithm. Then, the switching time of capacitor banks is determined by fuzzy time clustering algorithm. At last, the switching capacity of capacitor banks and DG reactive power are jointly optimized to get the final control scheme. The proposed method demonstrated good performance in the modified IEEE33 node system and two actual power grid examples. [ABSTRACT FROM AUTHOR]

HVDC auxiliary emergency power control can improve the transient stability of AC/DC power system. Compared with other control methods, HVDC auxiliary emergency power control has the advantages of quick response, large adjustment capacity and less investment, so it is the primary choice to improve the transient stability. Taking multi-infeed DC (MIDC) transmission system as the research object, based on the definition of the traditional power support factor, considering the influence of the electrical connection of the sending-end power grid on the power support, a new power support factor (NPSF) is defined. Based on the NPSF, multiple DC coordination sharing strategies are implemented when one of the DC faults occurs. Finally, MIDC is built on the PSCAD. Single DC auxiliary power control and multiple DC auxiliary power coordinated control were simulated, respectively. Rationality of the definition of NPSF is verified, and it is concluded that multiple DC joint power control is superior to single DC. [ABSTRACT FROM AUTHOR]

The well-developed unified power flow controller (UPFC) has demonstrated its capability in providing voltage support and improving power system stability. The objective of this paper is to demonstrate the capability of the UPFC in mitigating oscillations in a wind farm integrated power system by employing eigenvalue analysis and dynamic time-domain simulation approaches. For this purpose, a power oscillation damping controller (PODC) of the UPFC is designed for damping oscillations caused by disturbances in a given interconnected power system, including the change in tie-line power, the changes of wind power outputs, and others. Simulations are carried out for two sample power systems, i.e., a four-machine system and an eight-machine system, for demonstration. Numerous eigenvalue analysis and dynamic time-domain simulation results confirm that the UPFC equipped with the designed PODC can effectively suppress oscillations of power systems under various disturbance scenarios. [ABSTRACT FROM AUTHOR]