Search

Continuous development of high-performance microelectronic chips requires efficient cooling systems to dissipate large amount of heat produced over a small footprint. Pool boiling is capable of dissipating large heat fluxes while maintaining low wall superheat and is receiving renewed interest. Porous surfaces have been investigated extensively for pool boiling enhancement. This paper presents a review of different manufacturing techniques employed to manufacture porous surfaces in pool boiling application. Different types of surfaces developed using these techniques are reviewed and their pool boiling performance is discussed. [ABSTRACT FROM PUBLISHER]

The effect of flow instabilities on flow boiling heat transfer in microchannels is investigated using water as the working fluid. The experimental test section has six parallel rectangular microchannels, each having a cross-sectional area of 1054 × 197 microns. Flow restrictors are introduced at the inlet of each microchannel to stabilize the flow boiling process and avoid the backflow phenomena. The mass flow rate, inlet temperature of water, and the electric current supplied to the resistive cartridge heater are controlled to provide quantitative heat transfer information. The results are compared with the unrestricted flow configuration. [ABSTRACT FROM AUTHOR]

Heat transfer during flow boiling in minichannels and microchannels is intimately linked to the liquid-vapor phase distribution in the channels. The vapor phase exists as nucleating bubbles, dispersed bubbles, elongated bubbles, an annular core, or all vapor flow completely filling the channel. Similarly, the liquid can exist as bulk liquid, slugs, thin film on the heated wall, or dispersed droplets. A detailed analysis of various structures, supported by high-speed video images, is carried out, and the effects on the associated heat transfer rates are discussed. This information provides insight into the flow boiling mechanisms and guidance for future research in this area. [ABSTRACT FROM AUTHOR]

Flow boiling heat transfer in parallel minichannels and microchannels is one of the solutions proposed for cooling high heat flux .systems. The associated increase in the pressure drop poses a problem that needs to be studied in detail before the small diameter channels can he implemented in practical systems. The pressure drop fluctuations and the flow instability in a network of parallel channels connected by a common header also need to be addressed for the stable operation of flow boiling systems. The current work focuses on studying the flow patterns, pressure drop fluctuations, and flow instabilities in a set of six parallel rectangular minichannels, each with 333 μm in hydraulic diameter. Deionized and degassed water was used for all the experiments. The pressure fluctuations are recorded and signal analysis is performed to find the dominant frequencies and their amplitudes. These pressure fluctuations are then mapped to their corresponding flow patterns observed using a high speed camera. The results help us to relate pressure fluctuations to different flow characteristics and their effect on flow instability. [ABSTRACT FROM AUTHOR]

Flow boiling in mini- and microchannels offer very high heat transfer capabilities and find applications in many emerging technologies, such as electronics cooling and fuel cells. The low flow rate employed in such geometries, coupled with the small flow channels, often results in a laminar flow with all flow as liquid. Since the single-phase flow with all liquid is in the laminar range, the flow boiling correlations developed for conventional tubes with an inner diameter larger than 3 mm and turbulent flow need to be carefully reviewed. In the present work, flow boiling correlation for large diameter tubes developed by Kandlikar [1, 2] is modified for flow boiling in minichannels by using the laminar single-phase heat transfer coefficient for all liquid flow. The correlation is also extended for flow boiling in microchannels using the nucleate boiling as the dominant part of the original correlation. The trends in heat transfer coefficient versus quality are compared in the laminar and deep laminar regions in minichannels and microchannels. Excellent agreement is obtained between predicted values and experimental data. [ABSTRACT FROM AUTHOR]

An introduction to the journal is presented in which the editor discusses various reports within the issue including the use of microchannels in cooling technology, the single-phase flow in microchannels with fibrous or porous structures, and the outcome of ultrasound on subcooled and explosive boiling.