Search

Hot compression experiments of a Ti55511 titanium alloy are conducted to study the phase transformation characteristics and dynamic recrystallization (DRX) behavior. It is found that the fraction of α phase decreases with increasing the strain rate or deformation amount. Meanwhile, the original lamellar α phases easily transform into the spheroidal and bulk α phases at larger deformation amounts or higher strain rates. Most of α phases disappear and the final microstructures are mainly β phases when the temperature is over 800 °C. The DRX degree rises with raising the deformation amount or decreasing the strain rate. However, the DRX behavior becomes weaken with raising the deformation temperature. α phases are evenly distributed around β phases during hot compressive deformation, which not only restrains the growth of β phases but also promotes the DRX process of β phases. In addition, the geometric DRX takes place within α phases, while the continuous DRX occurs within β phases during the hot compression. Image 1 • Phase transformation and dynamic recrystallization (DRX) behavior of a Ti55511 titanium alloy are studied. • The volume fraction of α phase decreases with increasing the strain rate or deformation degree. • Initial lamellar α phases easily transforms into bulk/spheroidal α phases at the larger strains or higher strain rates. • The α phases not only restrains the growth of β phase, but also promotes the DRX process of β phase. • The geometric DRX takes place within α phases, while the continuous DRX occurs within β phases. [ABSTRACT FROM AUTHOR]

Spheroidization and dynamic recrystallization (DRX) mechanisms of a Ti-55511 alloy during hot compression in α+β region is investigated. It is found that the spheroidization of lamellar α phases and DRX of β phases, which are obviously influenced by deformation conditions, are the main softening mechanisms. The spheroidization fraction of lamellar α phases first increases with the raised temperature or strain rate. However, the spheroidization fraction of lamellar α phases begins to drop at about 700 °C as the strain rate is higher than 0.01 s−1, and the maximum spheroidization fraction of lamellar α phase is about 2.3%. This phenomenon is attributed to the Implanting-Mechanism, which is induced by the common or close orientation relationships of the spheroidized and equiaxed α phases, as well as few dislocations between the spheroidized and equiaxed α phases. Contrarily, the lamellar α phases are obstructed from equiaxed α phases by a mass of dislocations. Additionally, the DRX degree of β phases increases with the reduced temperature or the raised strain rate. • Spheroidization and DRX mechanisms of a Ti-55511 alloy during hot compression in α+β region is investigated. • Spheroidization fraction of lamellar α phase first increases then drops with the raised strain rate. • The maximum spheroidization fraction of lamellar α phase is about 2.3% near 700 °C and 0.01 s−1. • Implanting-Mechanism, induced by the close orientation relationships of spheroidized and equiaxed α phases, is proposed. • The DRX extent of β phases increases with the reduced temperature and raised strain rate. [ABSTRACT FROM AUTHOR]