Search

In order that the supply of electric power remain stable and sustainable, a certain level of power quality must be maintained while securing energy resources and resolving environmental issues. The distributed generation (DG) has become an essential and indispensable element of such distribution systems from both an environmental and an energy security perspective. However, the installation of DGs in distribution systems may cause variations of voltage on distribution feeder because the DG power outputs may change randomly and dramatically. Generally, the sending voltage at substation in distribution systems can be regulated by an under load tap changer (ULTC) designed to maintain customers' receiving voltages within a predetermined range. Voltage regulation performed by ULTC calls for two parameters: the equivalent impedance and the load center voltage. Therefore, in distribution networks with DG interconnections, these parameters should be designed with attention not only to load variations but also to DG outputs. This paper proposes a method for designing ULTC parameters with reference to variations in DG output. The proposed algorithm is tested with IEEE 13-node system and Korean model network. The results demonstrate the validity of the proposed design method for varying DG distribution. [ABSTRACT FROM AUTHOR]

In the last decade, distributed generation, with its various technologies, has increased its presence in the energy mix presenting distribution networks with challenges in terms of evaluating the technical impacts that require a wide range of network operational effects to be qualified and quantified. The inherent time-varying behavior of demand and distributed generation (particularly when renewable sources are used), need to be taken into account since considering critical scenarios of loading and generation may mask the impacts. One means of dealing with such complexity is through the use of indices that indicate the benefit or otherwise of connections at a given location and for a given horizon. This paper presents a multiobjective performance index for distribution networks with time-varying distributed generation which consider a number of technical issues. The approach has been applied to a medium voltage distribution network considering hourly demand and wind speeds. Results show that this proposal has a better response to the natural behavior of loads and generation than solely considering a single operation scenario. [ABSTRACT FROM AUTHOR]

This paper investigates voltage and reactive power control in distribution systems and how the presence of synchronous machine-based distributed generation (DG) affects the control. A proper coordination among the onload tap changer (OLTC), substation switched capacitors and feeder-switched capacitors in order to obtain optimum voltage and reactive power control is proposed. It is assumed that there is no communication link between the OLTC and the capacitors, a normal case in distribution system operation these days. The results indicate that the proposed method decreases the number of OLTC operations, losses, and voltage fluctuations in distribution systems, with and without DG present. The power-flow reversal due to the lJG is shown not to interfere with the effectiveness of the OLTC operation. Further, it is also shown that as long as the available capacitors are enough to compensate the reactive power demand, the DG operation mode does not give a significant effect to the distribution system losses. However, DG operating at a constant voltage is beneficial for a significant reduction of OLTC operation and voltage fluctuation in the distribution system. [ABSTRACT FROM AUTHOR]