Search

We investigated the effect of pre-sintering process on the penetration behavior of Dy in a NdFeB sintered magnet which was grain boundary diffusion treated with Cu/Al mixed Dy source. The pre-sintering of a magnet was performed at 900oC in vacuum and then the pre-sintered body was dipped in the solutions of DyH2, DyH2 + Cu, and DyH2 + Al, respectively. The dipped pre-sintered body were then fully sintered 4 hours at 1060oC followed by a subsequent annealing. The pre-sintering apparently improved the diffusivity of Dy atoms. The penetration of Dy into the magnet extended almost to 2,000 µm from the surface, about four times deeper than that of the normally sintered and diffusion treated one, when the DyH2 + Al solution was used as a Dy source. However, the resulting increase of coercivity was about 4 kOe, somewhat lower than that of the normally treated one, mostly due to excessive oxide formation that hindered to make a continuous Nd-rich grain boundary phase and a core-shell type structure. [ABSTRACT FROM AUTHOR]

Abstract: Nd–Fe–B melt spun ribbons have been hot-compacted and subsequently die-upset together with DyF3 in order to increase coercivity in nanocrystalline hot-deformed magnets. Magnetic measurements reveal enhanced coercivities for low and reduced coercivities for high Dy-fractions. This behaviour is due to a superposition of the formation of (Dy,Nd)2Fe14B and non-magnetic Dy and Nd fluoride and oxide phases. Energy dispersive and wavelength dispersive X-ray elemental maps verified this feature. Heat treatments at 600°C induce a strong F diffusion along the flake boundaries without inducing grain growth. This diffusion is correlated with the changes in magnetic properties. [Copyright &y& Elsevier]