Search

Four types of barrier detectors based on a type II InAs/InAsSb superlattice with a wide-gap barrier made of a solid AlInAsSb lattice matched to the GaSb buffer were compared. The tested detectors differed in the type of doping of the active layer and the level and type of doping of the contact layer at the barrier. The epitaxial layers were deposited on GaAs (100) substrates using the molecular beam epitaxy method. The spectral and current–voltage characteristics of the analyzed detectors were compared. The highest current responsivities were observed in the structure with a p-type absorber (p+BpN+). Detectors with an n-type absorber (p+Bnn+, n+Bnn+, and nBnn+) show an increase in the current responsivity with an increase in the reverse bias voltage due to the reduction in the undesirable barrier in the valence band. Arrhenius characteristics for the dark current show that only in nBnn+ detectors, it was possible to limit the generation–recombination current. These detectors at 150 K were characterized by the highest normalized detectivity of approximately 3 × 1011 cm · Hz1/2/W. The obtained results were compared with literature data, showing that the parameters of type II superlattice photodetectors are close to those of HgCdTe photodiodes according to the "Rule 07" and "Rule 22" principles. [ABSTRACT FROM AUTHOR]

The performance of long-wave infrared (LWIR) = 0.22 HgCdTe avalanche photodiodes (APDs) was presented. The dark currentvoltage characteristics at temperatures 200 K, 230 K, and 300 K were measured and numerically simulated. Theoretical modeling was performed by the numerical Apsys platform (Crosslight). The effects of the tunneling currents and impact ionization in HgCdTe APDs were calculated. Dark currents exhibit peculiar features which were observed experimentally. The proper agreement between the theoretical and experimental characteristics allowed the determination that the material parameters of the absorber were reached. The effect of the multiplication layer profile on the detector characteristics was observed but was found to be insignificant. [ABSTRACT FROM AUTHOR]

The detectivity characteristics of interband cascade infrared type-II superlattice detectors for long-wave infrared detection (λcut-off = 8 μm at room temperature) are discussed. We present comparison of two superlattices: InAs/GaSb and InAs/InAsSb, assuming the characteristic parameters—absorption coefficients α and carrier lifetimes τ published in literature. Dependence of the Johnson-noise limited detectivity on the absorber thickness for a different number of stages is reported. Higher detectivity D* value can be achieved by increasing the carrier lifetime. However, for detectors based on type-II InAs/GaSb superlattice increasing the carrier lifetime up to 25 ns leads to a situation in which one stage is preferred, i.e. for detector with a single absorber, we obtain the highest detectivity value. In the case of InAs/InAsSb material, the situation is similar for τ ≥ 80 ns. We have shown that the optimal absorber thickness at which the highest detectivity values are obtained depends not only on the absorption coefficient α and the number of stages NS, but also on the carrier diffusion length L. According to a calculations, cascade detectors based on Ga-free material should have much higher optimal absorber thicknesses than materials based on InAs/GaSb. [ABSTRACT FROM AUTHOR]