Search

BACKGROUND Chlorhexidine (CHX) is a broad-spectrum antimicrobial agent commonly used in medicine. Application of (CHX) during abutment connection reduced the bacterial load at the implant-abutment interface. We hypothesize this treatment may consequently reduce peri-implant soft tissue inflammation and marginal bone loss. PURPOSE To evaluate the effect of a single application of CHX gel inside the dental implant internal hexagon on peri-implant tissue. METHODS Forty patients were recruited to this randomized, double-blinded, clinical trial. At the time of implant installation, a 4-mm healing abutment was connected to the implant. In the test group, chlorhexidine gel 1% was applied inside the implant hex, whereas control implants did not receive any gel. Clinical and radiographic measurements included soft tissue recession (REC), plaque index (PI), gingival index (GI), plaque index (PI), keratinized mucosa width (KM), probing depth (PD), and a peri-apical parallel x-ray. Peri-implant crevicular fluid (PICF) was collected for cytokine analysis. t-Test was used to compare changes from baseline to 3 months. Mann-Whitney U test and t test were used to compare test and control groups. RESULTS Twenty patients in the test group and 17 in the control group completed the study. One implant in the control group failed to osteointegrate. There were no significant differences between the control and test groups for REC changes, bone loss, and PD. GI was significantly lower in the test group after 1 week (1.79 ± 0.24 vs 0.75 ± 0.18, respectively) and 3 months (1.18 ± 0.21 vs 0.25 ± 0.12, respectively) although PI was equal. At 3 months, interleukin 1-β (IL1-β) was higher in the control group (p

The aim of this prospective cohort observational field trial was to examine 1-year survival and success rates of a recently introduced tapered implant system with switched platform conical abutments and to evaluate patient related outcomes of therapy. Partially edentulous patients aged between 18 and 75 years, with available bone height for dental implants ≥10 mm desiring to restore the missing tooth/teeth with implant supported restoration, were recruited by 7 periodontists in their respective private practices. Dental implants were installed according to standard implant therapy protocol. Three to 6 months postoperatively, after evaluating interim implant success, implants were restored by the referring dentists. Patient, Ramfjord teeth, and implant data, including baseline and 1-year postoperative, were collected. A total of 60 patients were recruited and received 117 implants. Complete 1-year clinical and radiographic data were available for 83 and 65 implants, respectively. Two implants failed during the first year, resulting in a 1-year survival rate of 98.3%. Mean implant probing pocket depth was 2.29 ± 0.84 mm. Mean radiographic bone distance from implant's shoulder at the mesial and distal sites at 1 year was 0.66 ± 0.5 and 0.79 ± 0.64mm, respectively, resulting in a success rate of 95.4%. Patient subjective evaluation of therapy exhibited a median pain experience of 1 and median esthetics, function, and general satisfaction evaluation of 10 on a scale of 1 to 10. The tapered conical connection dental implant system, used in private dental practices, shows good 1-year survival and success rates that are similar to other implant systems on the market.

One-piece dental implants are commonly used for the immediate restoration of missing teeth. In most cases, the clinician has to prepare the abutment intraorally to ensure a proper emergence profile and abutment angulation. However, this procedure might impair primary stability and thus potentially compromise osseointegration. The aim of this study was to determine the effect of abutment preparation on the primary stability of a one-piece implant system (UNO MIS).Implant stability was assessed by resonance frequency analysis with a novel custom-made external fixation device, validated previously, developed specifically for resonance frequency measurements of this implant. Thirty 3 × 13-mm implants were inserted in porcine jawbone with insertion torque of 15 Ncm (group A, 15 implants) or 30 Ncm (group B, 15 implants). Abutments were prepared by reducing the facial aspect of the implant abutment with a high-speed dental turbine (400,000 rpm) equipped with a medium-roughness diamond bur. Implant stability quotients (ISQs) were measured before and after abutment preparation.Mean ISQs measured in group A and group B before abutment preparation were very similar (58.2 ± 1.4 and 57.4 ± 0.9, respectively; P.05). Following abutment preparation, three implants in group A lost primary stability. The mean ISQ value in group A was reduced from 58.2 ± 1.4 to 54.9 ± 7.9 following abutment preparation (P.05). The mean ISQ in group B was not affected by abutment preparation (57.4 ± 0.9 versus 57.3 ± 1.0; P.05).Abutment preparation of a one-piece dental implant inserted with low insertion torque might impair implant primary stability.

Patients with a history of periodontitis might have a higher risk for implant failure as compared with periodontally healthy subjects. The aim of the present study was to look into this risk factor by examining the association between plaque scores, probing depths (PD), and bleeding on probing (BOP) around teeth and immediately restored dental implants up to 1 year after implant surgery.Patients with partial edentulism, diagnosed with and previously treated for generalized chronic periodontitis, received dental implants, abutments, and cemented provisional prostheses up to 72 hours after implant surgery. Plaque scores, PD, and BOP were recorded and evaluated 6 and 12 months postsurgery.Plaque scores deteriorated slightly around teeth and improved around implants. No significant change was observed in the distribution of PD around teeth. The proportion of shallow pockets increased around implants. Improvement in plaque scores was associated with a stable/reduced PD, whereas deterioration in plaque scores was associated with increased PD around implants and teeth.A direct relationship was found between plaque score improvement and stable/reduced PD. Therefore, partially edentulous patients with a history of periodontitis should be encouraged to improve their plaque scores to maintain shallower pockets around implants.

The primary aim is to evaluate clinical, radiographic, and histologic parameters of novel implants with "three roots" design that were inserted into fresh multirooted extraction sockets. A secondary aim is to compare this new implant to standard root-form dental implants.Immediate implantation of novel or standard design 6 × 6-mm implants was performed bilaterally into multirooted sockets in mandibles of mini-pigs. Twelve weeks later, clinical, radiographic, stability, histomorphometric, and microcomputed tomography (micro-CT) analyses were performed.Survival rates were significantly higher in the test implants compared with control (92.8% versus 33.3%, respectively; P0.001). Bone loss was greater in the control compared with the test by sounding (mean 3.42 ± 0.68 versus 1.96 ± 0.34 mm) and radiography (mean 3.35 ± 0.62 versus 2.27 ± 0.33 mm). Histologic and micro-CT analyses demonstrated bone fill in the inner part of the test implants. Moreover, bone-to-implant contact was higher in the test implants (55.50% ± 3.68% versus 42.47% ± 9.89%). Contrary to the clinical, radiographic, and histomorphometric results, resonance frequency analysis measurements were greater in the control group (77.74 ± 3.21 implant stability quotient [ISQ]) compared with the test group (31.09 ± 0.28 ISQ), P = 0.008.The novel design implants resulted in significantly greater survival rate in multirooted extraction sites. Further studies will be required to validate these findings.

The aim of this study was to evaluate the effect of water irrigation on heat dissipation kinetics following abutment preparation of 1-piece dental implants. UNO 1-piece dental implants were mounted on Plexiglas apparatus clamping the implant at the collar. T-type thermocouple was attached to the first thread of the implant and recorded thermal changes at 100 millisecond intervals. Implants were prepared using highspeed dental turbine at 400 000 RPM with a coarse diamond bur. Once temperature reached 47°C, abutment preparation was discontinued. Thirty implants were divided into 2 groups. Group A: Passive cooling without water irrigation. Group B: Cooling with turbine's water spray adjacent to the implant (30 mL/min). The following parameters were measured: T47 (time from peak temperature to 47°C), T50%, T75% (time until the temperature amplitude decayed by 50% and 75%, respectively), dTemp50%/dt decay, and dTemp75%/dt decay (cooling rate measured at 50% and 75% of amplitude decay, respectively). Water spray irrigation significantly reduced T47 (1.37 ± 0.29 seconds vs 19.97 ± 3.06 seconds, P < 0.0001), T50% (3.04 ± 0.34 seconds vs 27.37 ± 2.56 seconds, P < 0.0001), and T75% (5.71 ± 0.57 seconds vs 57.61 ± 5.47 seconds, P < 0.0001). Water spray irrigation also increased cooling capacity ninefold: dTemp50%/dt decay (4.14 ± 0.61°C/s vs 0.48 ± 0.06°C/s, P < 0.0001), and dTemp50%/dt decay (1.70 ± 0.29°C/s vs 0.19 ± 0.03°C/s, P < 0.0001). The continuous use of water spray adjacent to the abutment following the cessation of implant preparation might prove beneficial for rapid cooling of the implant.