Search

Traditional compliance control of a rehabilitation robot is implemented in task space by using impedance or admittance control algorithms. The soft robot actuated by pneumatic muscle actuators (PMAs) is becoming prominent for patients as it enables the compliance being adjusted in each active link, which, however, has not been reported in the literature. This paper proposes a new compliance control method of a soft ankle rehabilitation robot that is driven by four PMAs configured in parallel to enable three degrees of freedom movement of the ankle joint. A new hierarchical compliance control structure, including a low-level compliance adjustment controller in joint space and a high-level admittance controller in task space, is designed. An adaptive compliance control paradigm is further developed by taking into account patient's active contribution and movement ability during a previous period of time, in order to provide robot assistance only when it is necessarily required. Experiments on healthy and impaired human subjects were conducted to verify the adaptive hierarchical compliance control scheme. The results show that the robot hierarchical compliance can be online adjusted according to the participant's assessment. The robot reduces its assistance output when participants contribute more and vice versa, thus providing a potentially feasible solution to the patient-in-loop cooperative training strategy. [ABSTRACT FROM AUTHOR]

This paper describes the design analysis and optimization of a novel 3-degrees of freedom (DOF) wearable parallel robot developed for ankle rehabilitation treatments. To address the challenges arising from the use of a parallel mechanism, flexible actuators, and the constraints imposed by the ankle rehabilitation treatment, a complete robot design analysis is performed. Three design stages of the robot, namely, kinematic design, actuation design, and structural design are identified and investigated, and, in the process, six important performance objectives are identified which are vital to achieve design goals. Initially, the optimization is performed by considering only a single objective. Further analysis revealed that some of these objectives are conflicting, and hence these are required to be simultaneously optimized. To investigate a further improvement in the optimal values of design objectives, a preference-based approach and evolutionary-algorithm-based nondominated sorting algorithm (NSGA II) are adapted to the present design optimization problem. Results from NSGA II are compared with the results obtained from the single objective optimization and preference-based optimization approaches. It is found that NSGA II is able to provide better design solutions and is adequate to optimize all of the objective functions concurrently. Finally, a fuzzy-based ranking method has been devised and implemented in order to select the final design solution from the set of nondominated solutions obtained through NSGA II. The proposed design analysis of parallel robots together with the multiobjective optimization and subsequent fuzzy-based ranking can be generalized with modest efforts for the development of all of the classes of parallel robots. [ABSTRACT FROM AUTHOR]

Abstract: Robot assisted gait training may help in producing rapid improvements in functional gait parameters. This paper presents new experimental results with an intrinsically compliant robotic gait training orthosis. The newly developed robotic orthosis has 6 degrees of freedom (DOFs). A trajectory tracking controller based on the boundary layer augmented sliding control (BASMC) law was implemented to guide the subject’s limbs on physiological gait trajectories. The compliance of the robotic orthosis sagittal plane hip and knee joints was also controlled, independently of the trajectory tracking control. The robotic orthosis and the control scheme were evaluated on three neurologically intact subjects walking on a treadmill. A maximum trajectory tracking error of 10° was recorded at the hip and knee sagittal plane joints. The results showed that subjects can walk in the robotic orthosis with comfort and the BASMC law was able to guide the subject’s limbs on reference physiological trajectories. [Copyright &y& Elsevier]

The novelty of this paper is the adjustable workspace and torque capacity of a compliant ankle rehabilitation robot (CARR). The robot has three rotational degrees of freedom (DOFs) redundantly actuated by four compliant actuators. It suffers from conflicting workspace and actuation torque due to the use of a parallel mechanism and compliant actuators. To address this issue, also considering physical constraints imposed by human users, the CARR is designed with reconfigurability to make a trade-off between workspace and torque capacity for meeting different training requirements. Theoretical analysis indicates that varying kinematic and dynamic performance of the robot can be achieved by reconfiguring the layout of the actuators. Experiments with/without load also demonstrate the validity of the reconfigurable robotic design for practical applications. [ABSTRACT FROM AUTHOR]