Search

We use common conversion point (CCP) stacking of Ps receiver functions to image the crustal structure and Moho of the Garhwal Himalaya of India. Our seismic array of 21 broadband seismometers spanned the Himalayan thrust wedge at 79–80°E, between the Main Frontal Thrust and the South Tibet Detachment, in 2005–2006. Our CCP image shows the Main Himalayan Thrust (MHT), the detachment at the base of the Himalayan thrust wedge, with a flat-ramp-flat geometry. Seismic impedance contrasts inferred from geologic cross-sections in Garhwal imply a negative impedance contrast (velocity decreasing downward) for the upper flat, located beneath the Lower Himalaya, and a positive impedance contrast (velocity increasing downward) for the ramp, located beneath the surface trace of the Munsiari Thrust (or MCT-I). At the lower flat, located beneath the Higher Himalaya, spatially coincident measurements of very high electrical conductivities require the presence of free fluids, and we infer a negative impedance contrast on the MHT caused by ponding of these fluids beneath the detachment. Our seismic image indicates that the upper flat of the MHT is ∼ 10 km below sea level and dips north at ∼ 2 ° , connecting to a mid-crustal ramp which is ∼ 10 km high and dips at ∼ 16 ° . The lower flat is 20–25 km below sea level and dips at ∼ 4 ° . The Main Central Thrust (MCT) appears as a negative impedance contrast, dipping at ∼ 16 ° . The Moho is nearly horizontal at 35–45 km depth beneath the Sub-Himalaya and Lower Himalaya, deepening to 50 km or more beneath the Higher Himalaya. This depth is 10–25 km shallower than in the NW Indian Himalaya and 5–10 km shallower than in central Nepal, requiring significant along-strike variations in crustal thickness. The observed thickness of subducted Indian crust in Garwhal is 20–28 km.

article i nfo Seismic shear-wave velocities are sensitive to the partial melts that should be present in the Himalayan orogen if low-viscosity channel flow is active at the present day. We analyzed regional earthquakes in the western Himalaya and Tibet recorded on 16 broadband seismometers deployed across the NW Indian Himalaya, from the Indian platform to the Karakoram Range. We used a multiple filter technique to calculate the group velocity dispersion of fundamental-mode Rayleigh waves, and then inverted the dispersion records to obtain separate one-dimensional shear-wave velocity models for five geologic provinces: the Tibetan plateau, Ladakh arc complex, Indus Tsangpo suture zone, Tethyan Himalaya, and Himalayan thrust belt. Our velocity models show a low-velocity layer (LVL) with 7-17% velocity reduction centered at ~30 km depth and apparently continuous from the Tethyan Himalaya to the Tibetan plateau. This LVL shows good spatial correspondence with observations of low resistivity from magnetotelluric studies along the same profile. Of the possible explanations for low velocity and low resistivity in the mid-crust, only the presence of melts or aqueous fluids (or both) satisfactorily explains both sets of observations. Elevated heat flow observed in the NW Himalaya implies that if aqueous fluids are present in the mid-crust, then the mid-crust is well above its solidus. Comparison of our results with laboratory measurements and theoretical models suggests 3-7% melt is present in a channel in the upper-middle crust of the NW Himalaya at the present day, and the physical conditions to enable active channel flow may be present.