Search

Abstract Following the experimental study and finite element (FE) model validation described in the companion paper, numerical parametric studies and the evaluation of design provisions for stainless steel channel sections under combined axial compressive load and minor axis bending moment are presented herein. The parametric studies were carried out to generate additional structural performance data over a wider range of cross-section aspect ratios and slendernesses, loading combinations and bending orientations. The test data and numerical results have been carefully analysed to develop a comprehensive understanding of the structural performance of stainless steel channel sections under combined compression and minor axis bending moment, and to assess the accuracy of the existing design provisions in Europe and North America. Comparisons of ultimate loads from the tests and FE simulations with the codified resistance predictions revealed that the current design standards typically under-estimate the capacity of stainless steel channel sections under combined compression and minor axis bending moment; this is attributed primarily to the neglect of material strain hardening and the employment of conservative interaction formulae. Improved design rules featuring more efficient interaction curves, anchored to more precise end points (i.e. cross-section resistances under pure compression and bending moment), are then proposed and presented. The new design proposals are shown to yield both more accurate and more consistent resistance predictions over the existing design provisions. Finally, statistical analyses are presented to confirm the reliability of the new design proposals according to EN 1990. Highlights • Parametric studies were carried out to generate further structural performance data. • Design provisions in EC3 and AISC were assessed against test and FE data. • New proposals were made, leading to substantial improvement in resistance prediction. • The reliability of the new proposals was confirmed according to EN 1990. [ABSTRACT FROM AUTHOR]

This paper reports the second part of the study on the structural behaviour of stainless steel circular hollow sections subjected to combined axial load and bending moment. A series of numerical parametric studies is presented, using the validated finite element (FE) models from the companion paper, with the aim of generating further structural performance data over a wider range of stainless steel grades, cross-section slendernesses and combinations of loading. The considered parameters include the outer cross-section diameter, the ratio of outer cross-section diameter to thickness and the initial loading eccentricity. Both the experimentally and numerically derived section capacities were compared with the strength predictions determined from the current European code, the American specification and the Australian/New Zealand standard, allowing the applicability of each codified method to be assessed. The comparisons revealed that the current design standards generally result in unduly conservative and scattered strength predictions for stainless steel circular hollow sections under combined loading, which can be primarily attributed to the neglect of strain hardening in the determination of cross-section resistances and to the use of linear interaction formulae. To overcome these shortcomings, improved design rules are proposed through extension of the deformation-based continuous strength method (CSM) to the case of circular hollow sections subjected to combined loading. Comparisons between the proposals and the test and FE results indicate a high level of accuracy and consistency in the predictions. The reliability of the proposed approach was confirmed by means of statistical analyses according to EN 1990. [ABSTRACT FROM AUTHOR]