Search

Purpose: To characterize the 3D imaging performance and radiation dose for a prototype slot‐beam configuration on an intraoperative O‐arm™ Surgical Imaging System (Medtronic Inc., Littleton, MA) and identify potential improvements in soft‐tissue image quality for surgical interventions. Methods: A slot collimator was integrated with the O‐arm™ system for slot‐beam axial CT. The collimator can be automatically actuated to provide 1.2° slot‐beam longitudinal collimation. Cone‐beam and slot‐beam configurations were investigated with and without an antiscatter grid (12:1 grid ratio, 60 lines/cm). Dose, scatter, image noise, and soft‐tissue contrast resolution were evaluated in quantitative phantoms for head and body configurations over a range of exposure levels (beam energy and mAs), with reconstruction performed via filtered‐backprojection. Qualitative imaging performance across various anatomical sites and imaging tasks was assessed with anthropomorphic head, abdomen, and pelvis phantoms. Results: The dose for a slot‐beam scan varied from 0.02–0.06 mGy/mAs for head protocols to 0.01–0.03 mGy/mAs for body protocols, yielding dose reduction by ∼1/5 to 1/3 compared to cone‐beam, owing to beam collimation and reduced x‐ray scatter. The slot‐beam provided an ∼6–7× reduction in scatter‐to‐primary ratio (SPR) compared to the cone‐beam, yielding SPR ∼20–80% for head and body without the grid and ∼7–30% with the grid. Compared to cone‐beam scans at equivalent dose, slot‐beam images exhibited an ∼2.5× increase in soft‐tissue contrast‐to‐noise ratio (CNR) for both grid and gridless configurations. For slot‐beam scans, a further ∼10–30% improvement in CNR was achieved when the grid was removed. Slot‐beam imaging could benefit certain interventional scenarios in which improved visualization of soft tissues is required within a fairly narrow longitudinal region of interest (±7 mm in z)––for example, checking the completeness of tumor resection, preservation of adjacent anatomy, or detection of complications (e.g., hemorrhage). While preserving existing capabilities for fluoroscopy and cone‐beam CT, slot‐beam scanning could enhance the utility of intraoperative imaging and provide a useful mode for safety and validation checks in image‐guided surgery. Conclusions: The 3D imaging performance and dose of a prototype slot‐beam CT configuration on the O‐arm™ system was investigated. Substantial improvements in soft‐tissue image quality and reduction in radiation dose are evident with the slot‐beam configuration due to reduced x‐ray scatter. [ABSTRACT FROM AUTHOR]

Background: Despite widespread use of femoral-sourced allografts in clinical spinal fusion procedures and the increasing interest in using femoral reamer–irrigator–aspirator (RIA) autograft in clinical bone grafting, few studies have examined the efficacy of femoral grafts compared to iliac crest grafts in spinal fusion. The objective of this study was to directly compare the use of autologous iliac crest with syngeneic femoral and iliac allograft bone in the rat model of lumbar spinal fusion. Methods: Single-level bilateral posterolateral intertransverse process lumbar spinal fusion surgery was performed on Lewis rats divided into three experimental groups: iliac crest autograft, syngeneic iliac crest allograft, and syngeneic femoral allograft bone. Eight weeks postoperatively, fusion was evaluated via microCT analysis, manual palpation, and histology. In vitro analysis of the colony-forming and osteogenic capacity of bone marrow cells derived from rat femurs and hips was also performed to determine whether there was a correlation with the fusion efficacy of these graft sources. Results: Although no differences were observed between groups in CT fusion mass volumes, iliac allografts displayed an increased number of radiographically fused fusion masses and a higher rate of bilateral fusion via manual palpation. Histologically, hip-derived grafts showed better integration with host bone than femur derived ones, likely associated with the higher concentration of osteogenic progenitor cells observed in hip-derived bone marrow. Conclusions: This study demonstrates the feasibility of using syngeneic allograft bone in place of autograft bone within inbred rat fusion models and highlights the need for further study of femoral-derived grafts in fusion. [ABSTRACT FROM AUTHOR]

Study Design: Retrospective cohort study. Objective: The aim was to investigate the accuracy of pedicle screw placement by freehand technique and to compare revision surgery rates among three different imaging verification pathways. Summary of Background Data: Studies comparing different imaging modalities in freehand screw placement surgery are limited. Materials and Methods: A single-institution retrospective chart review identified adult patients who underwent freehand pedicle screw placement in the thoracic, lumbar or sacral levels. Patients were stratified into three cohorts based on the intraoperative imaging modality used to assess the accuracy of screw position: intraoperative X-rays (cohort 1); intraoperative O-arm (cohort 2); or intraoperative computed tomography (CT)-scan (cohort 3). Postoperative CT scans were performed on all patients in cohorts 1 and 2. Postoperative CT scan was not required in cohort 3. Screw accuracy was assessed using the Gertzbein-Robbins grading system. Results: A total of 9179 pedicle screws were placed in the thoracic or lumbosacral spine in 1311 patients. 210 (2.3%) screws were identified as Gertzbein-Robbins grades C-E on intraoperative/postoperative CT scan, 137 thoracic screws, and 73 lumbar screws (P <0.001). Four hundred and nine patients underwent placement of 2754 screws followed by intraoperative X-ray (cohort 1); 793 patients underwent placement of 5587 screws followed by intraoperative O-arm (cohort 2); and 109 patients underwent placement of 838 screws followed by intraoperative CT scan (cohort 3). Postoperative CT scans identified 65 (2.4%) and 127 (2.3%) malpositioned screws in cohorts 1 and 2, respectively. Eleven screws (0.12%) were significantly malpositioned and required a second operation for screw revision. Nine patients (0.69%) required revision operations: eight of these patients were from cohort 1 and one patient was from cohort 2. Conclusion: When compared to intraoperative X-ray, intraoperative O-arm verification decreased the revision surgery rate for malpositioned screws from 0.37% to 0.02%. In addition, our analysis suggests that the use of intraoperative O-arm can obviate the need for postoperative CT scans. [ABSTRACT FROM AUTHOR]

Study Design: Rat posterolateral lumbar fusion model.Objective: The aim of this study was to compare the efficacy of freshly isolated adipose tissue-derived stromal vascular fraction (A-SVF) and bone marrow cells (BMCs) cells in achieving spinal fusion in a rat model.Summary Of Background Data: Adipose tissue-derived stromal cells (ASCs) offer advantages as a clinical cell source compared to bone marrow-derived stromal cells (BMSCs), including larger available tissue volumes and reduced donor site morbidity. While pre-clinical studies have shown that ex vivo expanded ASCs can be successfully used in spinal fusion, the use of A-SVF cells better allows for clinical translation.Methods: A-SVF cells were isolated from the inguinal fat pads, whereas BMCs were isolated from the long bones of syngeneic 6- to 8-week-old Lewis rats and combined with Vitoss (Stryker) bone graft substitute for subsequent transplantation. Posterolateral spinal fusion surgery at L4-L5 was performed on 36 female Lewis rats divided into three experimental groups: Vitoss bone graft substitute only (VO group); Vitoss + 2.5 × 106 A-SVF cells/side; and, Vitoss + 2.5 × 106 BMCs/side. Fusion was assessed 8 weeks post-surgery via manual palpation, micro-computed tomography (μCT) imaging, and histology.Results: μCT imaging analyses revealed that fusion volumes and μCT fusion scores in the A-SVF group were significantly higher than in the VO group; however, they were not significantly different between the A-SVF group and the BMC group. The average manual palpation score was highest in the A-SVF group compared with the BMC and VO groups. Fusion masses arising from cell-seeded implants yielded better bone quality than nonseeded bone graft substitute.Conclusion: In a rat model, A-SVF cells yielded a comparable fusion mass volume and radiographic rate of fusion to BMCs when combined with a clinical-grade bone graft substitute. These results suggest the feasibility of using freshly isolated A-SVF cells in spinal fusion procedures.Level of Evidence: N/A. [ABSTRACT FROM AUTHOR]

Suboptimal placement of pedicle screws may lead to neurovascular complications, pseudarthrosis, postoperative pain and the need for revision surgery. The objective of this study was to investigatethe accuracy of pedicle screw placement by freehand technique and to compare revision surgery rates among three different imaging verification pathways. Retrospective observational study. Adult patients who underwent freehand pedicle screw placement in the thoracic, lumbar or sacral levels in a single-institution between January 1, 2016, and June 30, 2020. The proportion of malpositioned screws defined as grades C-E on the Gertzbein-Robbins grading system and the number of patients requiring an additional revision surgery for screw malposition. Patients were stratified into three cohorts based on the intraoperative imaging modality used to assess the accuracy of screw position: intraoperative x-rays (cohort 1); intraoperative O-arm (cohort 2); or intraoperative computed tomographic (CT) scan (cohort 3). Postoperative CT scans were performed on all patients in cohorts 1 and 2. Postoperative CT scan was not required in cohort 3. A total of 9,179 pedicle screws were placed in the thoracic or lumbosacral spine in 1,311 patients. Of these, 210 (2.3%) screws were identified as Gertzbein-Robbins grades C-E on intra/postoperative CT scan; 137 thoracic screws and 73 lumbar screws (P< 0.001). A total of 409 patients underwent placement of 2,754 screws followed by intraoperative x-ray (cohort 1); 793 patients underwent placement of 5,587 screws followed by intraoperative O-arm (cohort 2); and 109 patients underwent placement of 838 screws followed by intraoperative CT scan (cohort 3). Postoperative CT scans identified 65 (2.4%) and 127 (2.3%) malpositioned screws in cohorts 1 and 2, respectively. Eleven screws (0.12%) were significantly malpositioned and required a second operation for screw revision. Nine patients (0.69%) required revision operations: 8 of these patients were from cohort 1 and one patient was from cohort 2. In cohort 3, 18 of 838 (2.1%) screws were identified as malpositioned by intraoperative CT-scan: 2 of these screws were revised intraoperatively during index procedure. No revision surgeries took place in this cohort. Freehand pedicle screw placement is safe and effective with a 97.7% accuracy rate (Gertzbein-Robbins grades A or B). Nine patients (0.69%) required screw revision. When compared to intraoperative x-Ray, intraoperative o-arm verification decreased the revision surgery rate for malpositioned screws from 0.37% to 0.02%. In addition, our analysis suggests that the use of intraoperative O-arm can obviate the need for postoperative CT scans. This abstract does not discuss or include any applicable devices or drugs. [ABSTRACT FROM AUTHOR]

Background In sacropelvic fixation, the iliac screw technique offers biomechanically strong constructs, but its disadvantages include screw prominence, wound dehiscence, and postoperative pain secondary to the high profile nature. To overcome this drawback, S2-alar-iliac (S2AI) screws were developed as an alternative technique for sacropelvic fixation. This study aimed to compare the S2AI screw technique with the iliac screw technique in terms of postoperative symptomatic screw prominence. Methods A retrospective review of the records of sacropelvic fusion procedures performed at a single institution between October 2010 and January 2015 identified 32 patients with 72 iliac screws and 68 patients with 148 S2AI screws, and clinical and radiographic data were collected. If a patient had wound dehiscence and/or tenderness in the buttock immediately overlying a pelvic screw head postoperatively, it was defined as symptomatic screw prominence. The minimal distance from screw head to skin (MDSS) on postoperative computed tomography scans was measured for each patient to clarify the relationship between symptomatic screw prominence and MDSS. Results Mean follow-up period was 22.0 months. There was significantly more symptomatic pelvic screw prominence in the iliac screw group (11.1% vs. 1.4%, P = 0.002). MDSS ≤23 mm was the strongest predictor of symptomatic pelvic screw prominence, which yielded sensitivity of 100%, specificity of 94.1%, positive predictive value of 47.6%, and negative predictive value of 100%. Conclusions The use of the S2AI screw technique resulted in a reduced rate of symptomatic screw prominence. MDSS ≤23 mm was the strongest predictor of symptomatic screw prominence. [ABSTRACT FROM AUTHOR]

Background Parathyroid hormone (PTH) (1–34) treatment reduces fracture risk in osteoporotic patients. Previously, we demonstrated in a rabbit model that low-dose PTH treatment resulted in increased fusion mass volume. As effects of PTH on bone are dose-dependent, we aimed to evaluate whether increasing dosage of PTH increases both volume and biomechanical stiffness of the resulting fusion masses and/or exhibits synergistic effects with low-dose bone morphogenetic protein 2 (BMP-2). Methods Posterolateral lumbar spinal fusion surgery was performed on 60 New Zealand White rabbits divided into 6 experimental groups: iliac crest autograft alone, autograft plus 20 μg/kg/day PTH, autograft plus 40 μg/kg/day PTH, BMP-2 alone, BMP-2 plus 20 μg/kg/day PTH, and BMP-2 plus 40 μg/kg PTH. Fusion was assessed at postoperative week 6 via manual palpation, volumetric computed tomography analysis, and 4-point bending biomechanical testing. Results All groups treated with BMP-2 fused. Increasing doses of PTH resulted in increased fusion mass volume compared with autograft alone. Autograft plus 40 μg/kg/day PTH yielded fusion mass volumes comparable to BMP-2. When the autograft groups were considered alone, increased mechanical stiffness was observed only in the 20 μg/kg/day group. No significant stiffness differences were observed between BMP-2 groups. Conclusions Treatment with the highest dose of PTH resulted in fusion mass volumes similar to those obtained with BMP-2. When the autograft groups were considered alone, significant increases in mechanical stiffness were observed at a dosage of 20 μg/kg/day, suggesting there may be an optimal dose of PTH in the rabbit model. Effects of BMP-2 on fusion were dominant. [ABSTRACT FROM AUTHOR]