Search

Escin is an amphiphilic and weakly acidic drug that oral administration may lead to the irritation of gastric mucosa. The entrapment of escin into chitosan (CH)/xanthan gum (XG)-based polyelectrolyte complexes (PECs) can facilitate controlled drug release which may be beneficial for the reduction of its side effects. This study aimed to investigate the influence of escin content and drying method on the formation, physicochemical, and controlled, pH-dependent drug release properties of CH/XG-based PECs. Measurements of transmittance, conductivity, and rheological characterization confirmed the formation of CH/XG-based PECs with escin entrapped at escin-to-polymers mass ratios 1:1, 1:2, and 1:4. Ambient-dried PECs had higher yield, entrapment efficiency, and escin content in comparison with spray-dried ones. FT-IR spectra confirmed the interactions between CH, XG, and escin, which were stronger in ambient-dried PECs. PXRD and DSC analyses showed the amorphous escin character in all dry PECs, regardless of the drying method. The most promising controlled and pH-dependent in vitro escin release was from the ambient-dried PEC at the escin-to-polymers mass ratio of 1:1. For that reason and due to the highest yield and entrapment efficiency, this carrier has the potential to prevent the irritation of gastric mucosa after oral administration of escin., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2022 Elsevier B.V. All rights reserved.)

The effect of the entrapment procedure of a poorly water soluble drug (ibuprofen) on physicochemical and drug release performances of chitosan/xanthan polyelectrolyte complexes (PECs) was investigated to achieve controlled drug release as the ultimate goal. The formation of PECs for two drug entrapment procedures (before or after the mixing of polymers) at pH 4.6 and 5.6 and three chitosan-to-xanthan mass ratios (1:1, 1:2 and 1:3) was observed by continuous decrease in conductivity during the PECs formation and increased apparent viscosity and hysteresis values. The most extensive crosslinking was observed with ibuprofen added before the PECs formation at pH 4.6 and chitosan-to-xanthan mass ratio 1:1. The PECs prepared at polymers' mass ratios 1:2 and 1:3 had higher yield and drug entrapment efficiency. DSC and FT-IR analysis confirmed ibuprofen entrapment in PECs and the partial disruption of its crystallinity. All ibuprofen release profiles were similar, with 60-70% of drug released after 12 h, mainly by diffusion, but erosion and polymer chain relaxation were also included. Potentially optimal can be considered the PEC prepared at pH 4.6, ibuprofen entrapped before the mixing of polymers at chitosan-to-xanthan mass ratio 1:2, which provided controlled drug release by zero-order kinetics, high yield, and drug entrapment efficiency., Competing Interests: Declaration of competing interest None., (Copyright © 2020 Elsevier B.V. All rights reserved.)