Search

Rationale and Objectives: Modern computed tomographic scanners and examination protocols often require high injection rates of iodinated contrast media (CM). The purpose of this study was to investigate the maximum injection pressures (MIPs) with different CM at different temperatures in the most common intravenous cannula (IVC) sizes., Materials and Methods: Three IVC sizes, 22, 20, and 18 gauge, were evaluated. All examinations were performed with a pressure-limited (300 psi) power injector. The MIPs of three different CM (Solutrast 300, Imeron 350, and Imeron 400) were measured at room temperature (20 degrees C) and at 37 degrees C using increasing flow rates (1-9 mL/s). The intactness of the IVCs was checked after injection., Results: Heating the CM led to reductions in injection pressures (P < .001). Using constant flow rates, the difference in MIP between 20-gauge and 22-gauge IVCs was higher than that between 20-gauge and 18-gauge IVCs. By heating the CM, the manufacturer's suggested operating pressure limit was exceeded at higher flow rates, such as with an 18-gauge cannula at 8 mL/s instead of 6 mL/s using warmed iomeprol 400. Even with pressures of up to 159.7 psi, none of the IVCs ruptured., Conclusions: Heating of CM effectively reduces MIPs using power injection in common IVCs. Although the manufacturer's suggested MIP was exceeded at higher flow rates, safe CM injection seems to be possible even in small cannulas using power injection. The compilation of the obtained data is meant to serve as guidance for future decisions on parameters of the power injection of iodinated CM.

Purpose: Modern examination protocols for computed tomography (CT) often require high injection rates of iodinated contrast media (CM). The purpose of this study was to evaluate the maximum achievable flow rates and stability of different peripheral intravenous catheters (IVC) in vitro and to assess the feasibility of higher injection rates through small IVC in vivo., Materials and Methods: For in vitro experiments flow measurements followed by high pressure testing of different types of IVC (22, 20, and 18 gauge [G]) were performed. For the in vitro study 91 patients with already inserted 22 or 20G IVC who had been referred for CT received Iopamidol (300 mg iodine/ml) at flow rates between 2 and 5 ml/sec. Complications were documented., Results: The maximal achievable flow rate of the tested IVC in vitro ranged from 5 to 8 ml/sec. No damage was observed during in vitro testing. The initially targeted in vivo flow rate was dropped in 33 of 91 (36 %) patients because the IVC could not be flushed adequately with saline before CM injection. Extravasation of CM occurred in 2 cases. In the remaining 58 patients the standard CT protocol was performed with flow rates of 3 ml/sec through 22G IVC and 5 ml/sec through 20G IVC, respectively. In this group, the extravasation of CM was observed twice (p > 0.05)., Conclusion: Even with highly viscous CM, high flow rates can be applied in vitro in 22, 20, and 18G IVC without risking material damage. In vivo power injection of iodinated CM through 22G and 20G IVC seems to be safely achievable in the majority of patients with flow rates of up to 3 ml/sec and 5 ml/sec. Extravasation rates do not differ significantly between patients with high-flow or low-flow injections.

Galactography is an important step in the diagnostic workup of abnormal nipple discharge. At times it is impossible to insert the cannula in the secreting duct and galactography cannot be performed. In such cases we tried applying local anaesthetic spray (LA) cutaneously to the nipple followed by a further insertion attempt. LA has enabled us to insert the galactography cannula in all patients so far. We concluded that after previous unsuccessful attempts, the presented technique may relax the duct orifice and therefore permit insertion of the galactography cannula into the secreting duct.