Search

ANSYS was used in this study to simulate the change in permeability of loaded coal under negative pressure. The ANSYS transient structural module was employed to simulate the coal loading conditions and to calculate the coal volumetric strain and coal porosity change. In the ANSYS Fluent module, the porosity of the porous medium was changed to replace the coal deformation, and the outlet pressure was changed to simulate the change of negative pressure. By using 1stOpt software, the relationships among the negative pressure, effective stress, and permeability of coal were fitted, and the binary nonlinear function of permeability varying with effective stress and negative pressure was obtained, and the correlation coefficient was excellent. Results showed that the coal permeability had a negative exponential relationship with effective stress. Hence, the permeability decreased with the increase of the effective stress. The change in stress loading mode caused a sudden change in porosity and permeability. The coal permeability had an approximately linear relationship with negative pressure. Hence, permeability increased with an increase in negative pressure. However, with the increase of effective stress, the influence of negative pressure on coal permeability was gradually weakened.

Coal and gas outburst is a kind of complex dynamic disaster with short duration and strong explosiveness, and the modes and strength of the outburst are determined by the in situ stress, gas pressure, and physical and mechanical properties of the coal mass. In this paper, the status quo of research on the mechanism of coal and gas outburst in China is described from three aspects: the controlling effect of single factor, the controlling effect of multi-factor, and new understandings of the outburst mechanism in recent years. Firstly, controlling factors of coal and gas outburst are classified for an in-depth analysis of the main factors of the same type of disasters, and the research progress and new understandings of the mechanism of coal and gas outburst are systematically sorted out. Secondly, the influencing factors of the strength coal mass are analyzed, and the related issues of coal mass strength on coal and gas outburst disaster mechanism are discussed. The results show that the stages of incubation, occurrence, development, and stop on coal and gas outburst are affected by the coupling effects of in situ stress field, gas pressure field, and seepage field, and the coal strength becomes an important factor affecting outburst strength under the same in situ stress and gas pressure. Therefore, the scientific and reasonable improvement methods of such similar simulation experiment devices are proposed according to the existing experimental methods and devices, which is of great significance to provide ideas for the continuous transferring to deep mining and preventing coal and gas outburst in China in the future.

Based on gas adsorption theory, high-pressure mercury intrusion (HPMI), low-temperature liquid nitrogen gas adsorption (LT-N2GA), CO2 adsorption, scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR) and small-angle X-ray scattering (SAXS) techniques were used to analyze the pore structures of six coal samples with different metamorphisms in terms of pore volume, specific surface area (SSA), pore size distribution (PSD) and pore shape. Combined with the gas adsorption constant a, the influence and mechanism of the pore structure of different coal ranks on gas adsorption capacity were analyzed. The results show that there are obvious differences in the pore structure of coals with different ranks, which leads to different adsorption capacities. To a large extent, the pore shapes observed by SEM are consistent with the LT-N2GA isotherm analysis. The pore morphology of coal samples with different ranks is very different, indicating the heterogeneity among the coal surfaces. Adsorption analysis revealed that mesopore size distributions are multimodal and that the pore volume is mainly composed of mesopores of 2–15 nm. The adsorption capacity of the coal body micropores depends on the 0.6–0.9 nm and 1.5–2.0 nm aperture sections. The influence of coal rank on gas desorption and diffusion is mainly related to the difference in pore structure. The medium metamorphic coal sample spectra show that the number of peaks in the high-wavenumber segment is small and that it is greater in the high metamorphic coal. The absorption intensity of the C–H stretching vibration peak of naphthenic or aliphatic hydrocarbons varies significantly among the coal samples. Over a small range of angles, as the scattering angle increases, the scattering intensity of each coal sample gradually decreases, and as the degree of metamorphism increases, the scattering intensity gradually increases. That is, the degree of metamorphism of coal samples is directly proportional to the scattering intensity. The influence of coal rank on gas adsorption capacity is mainly related to the difference in pore structure. The gas adsorption capacity shows an asymmetric U-shaped relationship with coal rank. For higher rank coals (Vdaf < 15%), the gas adsorption consistently decreases significantly with increasing Vdaf. In the middle and low rank coal stages (Vdaf > 15%), it increases slowly with the increase of Vdaf. We believe that the results of this study will provide a theoretical basis and practical reference value for effectively evaluating coal-rock gas storage capacity, revealing the law of CBM enrichment and the development and utilization of CBM resources.

Methane gas is mainly present in coal in two forms: free and adsorbed. There are a large number of closed pores inside the coal, which makes it difficult to measure the gas content of the coal. Therefore, studying the nanoscale closed pores of coal is of great importance for gas control. To study the pore structure characteristics of coal with different deformation degrees and to analyze the volume fraction of closed pores in coal, various coal samples were analyzed by the low-temperature liquid nitrogen adsorption method (LT-N2GA), the carbon dioxide adsorption method, and small-angle X-ray scattering (SAXS). The variation of parameters such as the pore size, pore volume, specific surface area, and degree of metamorphism was compared by using different methods to obtain the proportion of the closed pore volume of different coal samples. The results show that with the increase of the degree of coal metamorphism, the total pore volume and specific surface area of coal samples show a decreasing trend first and then an increasing trend, while the average pore diameter of coal samples gradually increases first and then decreases sharply. When the degree of deterioration of coal is low (volatile content > 20%), the closed pores of coal account for more than 48% of the open pores. When the degree of deterioration of coal samples is relatively high (volatile content

Terrorist attacks have become a serious source of risk affecting the security of the international community. Using the Global Terrorism Database (GTD), in order to quantitatively study past terrorist attacks and their temporal and spatial evolution the analytic hierarchy process (AHP) was used to classify the degree of damage from terrorist attacks. The various factors influencing terrorist attacks were extracted and represented in three dimensions. Subsequently, using MATLAB for analysis and processing, the grading standards for terrorist attacks were classified into five levels according to the degree of hazard. Based on this grading standard, the top ten terrorist attacks with the highest degree of hazard in the past two decades were listed. Because the characteristics and habits of a terrorist or group exhibit a certain consistency, the K-means cluster analysis method was used to classify terrorists according to region, type of attack, type of target and type of weapon used by the terrorists. Several attacks that might have been committed by the same terrorist organization or individual at different times and in different locations were classified into one category, and the top five categories were selected according to the degree of sabotage inflicted by the organization or individual. Finally, the spatiotemporal evolution of terrorist attacks in the past three years was analyzed, considering the terrorist attack targets and key areas of terrorist attacks. The Middle East, Southeast Asia, Central Asia, and Africa were predicted to be the regions that will be most seriously affected by future global terrorist events. The terrorist attacks in Southeast Asia are expected to become more severe, and the scope of terrorist attacks in Africa is expected to widen. Civilians are the targets most at risk for terrorist attacks, and the corresponding risk index is considerably higher than it is for other targets. The results of this research can help individuals and the government to enable a better understanding of terrorism, improve awareness to prevent terrorism and enhance emergency management and rescue, and provide a solid and reliable basis and reference for joint counterterrorism in various countries and regions.