Search

This paper presents a new high-efficiency two-way Doherty Power Amplifier (DPA) with a modified output matching structure for Wideband Code Division Multiple Access (W-CDMA) low-to-medium power base station applications. A blended design is proposed using the symmetrical topology of equal rated power amplifying devices with unequal output impedances for the carrier and peaking amplifier to achieve enhanced efficiency and desired linearity in 1900 MHz band. The proposed output circuit modifications encompass the usage of parasitic capacitor compensation technique for the carrier amplifier, optimum offset line along with the Doherty combiner to achieve high efficiency over 6 to 10 dB extended range of back-off operation. The measured results of the DPA demonstrate a Power Added Efficiency (PAE) of more than 49.9% at +34 dBm W-CDMA signal power, which is between 8 and 8.5 dB back-off from the peak power level of 42.2 dBm. The DPA has a large signal power gain of 13 dB at 1960 MHz. Further, the PAE is 39.5% and linearised Adjacent Channel Power Ratio (ACPR) is −46.2 dBc, both at 10 dB back-off from peak power. In these back-off power levels, this implementation provides significant efficiency improvement using symmetrical devices and with excellent linearity. [ABSTRACT FROM AUTHOR]

In this paper, a nonlinear autoregressive with exogenous inputs (NARX) digital pre-distortion scheme to linearize power amplifiers is proposed. The proposed NARX digital pre-distortion gives better accuracy and spectral leakage suppression compared with other commonly used Volterra-based techniques. The stability criterion of the NARX digital pre-distortion is derived from the frequency domain analysis. Simulation is carried out with a 20 MHz single carrier long-term evolution signal and two-carrier long-term evolution signal and instantaneous to average ratio of 6.2 dB at 0.01% complementary cumulative distribution function (CCDF). The results of simulation analysis show a slight improvement in adjacent channel leakage ratio performance with 30% reduction in the number of floating point operations compared with conventional pre-distortion techniques. Copyright © 2016 John Wiley & Sons, Ltd. [ABSTRACT FROM AUTHOR]

It is well known that HPAs (High Power Amplifiers) are inherently nonlinear devices and many researches have focused on the predistortion for memoryless HPAs. However, memory effects of HPAs can no longer be ignored when communication systems have wider bandwidth. Memoryless predistortion techniques proposed previously seldom have satisfactory effectiveness for typical wideband applications such as OFDM (Orthogonal Frequency Division Multiplexing) systems. In this paper, an improved adaptive predistortion method called 2D LUT (2-dimension look-up table) with different accuracy levels is presented to linearize HPAs with memory effects. Simulation and experimental results show that 2D LUT implements excellent performance in mitigating the signal deterioration caused by memory effects, both rectifies the signal constellation distortion and suppresses the spectrum emission. Large scale matrix computation is also avoidable in these adaptive algorithms, which makes them feasible when a real-time system is necessary. [ABSTRACT FROM AUTHOR]

The nonlinearity inherent in the traveling wave tube (TWT) amplifier distorts amplified signals and results in reduced efficiency and bandwidth, limiting its use in communication and electronic countermeasure applications. Signal predistortion is an effective technique for suppressing nonlinear distortion in TWTs that provides high suppression and requires simple circuits for implementation. While conventional predistortion linearizers are based on third-order intermodulation (MM) injection, this paper proposes using second-order (second-harmonic) signal injection in predistortion circuits. A detailed experimental investigation and comparison of second-order versus third-order signal predistortion is presented. It is observed that both schemes result in suppression of up to 30 dB (55 dBc) for the 31M distortion products. However, experimental results indicate that second-harmonic signal injection performs better than 31M in suppressing higher order products. The paper also investigates spatial evolution of the wave spectrum along the TWT axis with and without injection, and sensitivity of the suppression to injected signals amplitude, phase and the fundamental frequency. [ABSTRACT FROM AUTHOR]

Orthogonal Frequency Division Multiplexing (OFDM) is one of the key modulations for current and novel broadband communications standards. For example, Multi-band Orthogonal Frequency Division Multiplexing (MB-OFDM) is an excellent choice for the ECMA-368 Ultra Wideband (UWB) wireless communication standard. Nevertheless, the high Peak to Average Power Ratio (PAPR) of MB-OFDM UWB signals reduces the power efficiency of the key element in mobile devices, the High Power Amplifier (HPA), due to non-linear distortion, known as the non-linear saturation of the HPA. In order to deal with this limiting problem, a new and efficient pre-distorter scheme using a Neural Networks (NN) is proposed and also implemented on Field Programmable Gate Array (FPGA). This solution based on the pre-distortion concept of HPA non-linearities offers a good trade-off between complexity and performance. Some tests and validation have been conducted on the two types of HPA: Travelling Wave Tube Amplifiers (TWTA) and Solid State Power Amplifiers (SSPA). The results show that the proposed pre-distorter design presents low complexity and low error rate. Indeed, the implemented architecture uses 10% of DSP (Digital Signal Processing) blocks and 1% of LUTs (Look up Table) in case of SSPA, whereas it only uses 1% of LUTs in case of TWTA. In addition, it allows us to conclude that advanced machine learning techniques can be efficiently implemented in hardware with the adequate design. [ABSTRACT FROM AUTHOR]