Search

Introduction: The measurement of β-hydroxybutyrate (βOHB) concentrations is a corner stone of the diagnosis of diabetic ketoacidosis and other ketonic states. The aim of this study was to perform a validation of a peripheral blood βOHB assay (Randox) on a Roche cobas c502 analyser and to establish a βOHB reference range for the validated assay., Materials and Methods: Precision, linearity and limit of detection and blank (LoD, LoB) were determined according to Clinical and Laboratory Standards Institute (CLSI) EP05-A3, EP 06-A and EP17-A2 guidelines, using commercial control material and residual patient sample pools. As method comparison, for 190 semi-quantitative measurements of urine ketones we determined the corresponding βOHB blood concentration. The reference range was based on the CLSI C28-A3 guideline, using 304 randomly selected serum samples from population based German National Cohort (GNC) study., Results: Coefficients of variation for the validated assay ranged from 1.5% for high concentrations (3.1 mmol/L) to 6.5% for low concentrations (0.1 mmol/L). Detection capacity was LoB = 0.011 mmol/L and LoD = 0.037 mmol/L. Linearity of the assay ranged from 0.10 to 3.95 mmol/L. The agreement between the semi-quantitative urine ketone test and the βOHB blood test was moderate (Kappa = 0.66). The obtained 95% serum reference range was estimated as 0.02 to 0.28 mmol/l βOHB., Conclusions: The Ranbut βOHB assay showed good precision and analytical performance. Our results confirm that βOHB measurement in peripheral blood is indeed a preferable alternative to the semi-quantitative measurement of urine ketones., Competing Interests: Potential conflict of interest: None declared., (Croatian Society of Medical Biochemistry and Laboratory Medicine.)

Objectives: Characterization of an in vitro diagnostic zinc assay (LT-SYS) on a Roche cobas c502 analyzer and evaluation of the influence of pre-analytic factors on zinc concentration measurements., Design and Methods: Imprecision, bias, linearity, limit of blank (LoB), and limit of detection (LoD) were established and method comparisons were performed based on the respective CLSI guidelines. The influence of time elapsed until analysis, the usage of a pneumatic tube delivery system (PTDS) and of special trace element sample tubes was evaluated as well., Results: Estimates of imprecision ranged from 0.9% to 5.0% and bias was low with 1.3% and 1.5% deviation from target value. Linearity was met for the measuring range of 1.15-34.7 μmol/L (7.51-226.9 μg/dL), LoB and LoD were 0.17 μmol/L (1.11 μg/dL) and 0.73 μmol/L (4.77 μg/dL) respectively. The method comparison revealed an average deviation of 8.44% (y=0.542+1.036x). Plasma samples had 7.3% higher zinc values than serum samples on the average. Zinc values of uncentrifuged serum and plasma samples increased 20% in 8 hours, while after centrifugation no significant increase could be detected. Usage of PTDS increased zinc values by 17% and usage of trace element sample tubes showed no advantage over normal ones., Conclusions: The LT-SYS zinc assay showed a fully acceptable performance with good degrees of imprecision and bias, no deviation from linearity and both a very low LoB and LoD. Samples for zinc analysis should be centrifuged timely and transport over PTDS should be avoided., (© 2017 Wiley Periodicals, Inc.)