Search

Single-mode organic solid-state lasers with direct emission into an optical waveguide are attractive candidates for cost-efficient coherent light sources employed in photonic lab-on-a-chip biosensors. Here, we present a combination of a dye-doped organic solid-state distributed feedback laser with a highly sensitive optical waveguide Mach-Zehnder interferometer on a silicon nitride photonic platform. This organic-hybrid laser allows for optical pumping with a laser diode in an alignment tolerant manner, which facilitates applications in point-of-care diagnostics. The sensitivity to bulk refractive index changes and the concentration dependent binding of streptavidin on a polyethyleneimine-biotin functionalized surface was studied to demonstrate the practicability of this cost-efficient coherent light source for optical waveguide biosensors., (Copyright © 2021 Elsevier B.V. All rights reserved.)

Gold electrodes have been used in a wide range of electrochemical biosensors because their functionalization process with thiols has been well described and, in general, they offer good chemical stability. However, one of the most commonly used redox-pairs in electrochemical impedance spectroscopy, Hexacyanoferrate (II)/(III), causes corrosion of the gold electrodes and consequently damages the surface modification. This leads to alterations of the sensing signals, and thus, renders the quantitative and sensitive detection of target molecules virtually impossible. To overcome this problem we introduced the in-situ generation of Hexaammineruthenium (II)/(III) as redox-pair during the impedimetric measurement by applying a DC-bias. This DC-bias was chosen in such a way that it supplied Hexaammineruthenium (II) in a suitable concentration at the electrode surface by reducing Hexaammineruthenium (III). We compared the stability of photolithographically fabricated thin-film and screen-printed gold electrodes in Hexacyanoferrate and Hexaammineruthenium solutions. Further, long-time characterization of the electrochemical properties with cyclic voltammetry and electrochemical impedance spectroscopy revealed that Hexaammineruthenium (II)/(III) was an excellent redox-pair for stable impedimetric measurements with gold electrodes. To demonstrate the suitability of Hexaammineruthenium for biosensing we applied it for the impedimetric detection of human-IgG. This biosensor exhibited a linear range from 11.3 ng/mL to 113 μg/mL, which is a suitable range for diagnostic applications., (Copyright © 2018 Elsevier B.V. All rights reserved.)

We report a new method for detecting human IgG (hIgG) in serum on integrated-optical Mach-Zehnder interferometer biosensors realized in a high index contrast polymer material system. In the linear range of the sensor (5-200 nM) we observed excellent signal recoveries (95-110%) in buffer and serum samples, which indicate the absence of matrix effects. Signal enhancement was reached by using secondary anti-human IgG antibodies, which bind to immobilized target IgGs and allow detecting concentrations down to 100 pM. This polymer based optical sensor is fully compatible with cost-efficient mass production technologies, which makes it an attractive alternative to inorganic optical sensors. Graphical abstract of the hIgG measured on polymer based photonic sensors using a direct binding assay and a signal enhancement strategy with secondary antibodies., (© 2015 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.)

The sensitivity of bimodal waveguides for integrated optical biosensors is compared to single mode waveguides and grating-assisted bimodal interferometers are proposed as improved sensor concept. Grating-assisted bimodal interferometers are an elegant and compact sensor concept, which features easy fabrication and overcomes typical weaknesses of classical Mach-Zehnder interferometers. Long period gratings for mode conversion in the proposed sensor concept have been simulated employing the FDTD method. Such gratings give full control over the power distribution in the waveguides modes, which is not possible with other methods. Designs for three typical material systems are given and fabrication tolerances were investigated.

Biotin- and iminobiotin-bonded surfaces obtained by thiol-ene chemistry and subsequent modification with polyamines were characterized with respect to streptavidin-binding capacity and reversibility for photonic biosensing using X-ray photoelectron spectroscopy and Mach-Zehnder-interferometric sensors. The streptavidin-iminobiotin system was exploited for reversible multilayer deposition and determination of affinity constants on each layer.

The process of surface functionalization involving silanization, biotinylation and streptavidin bonding as platform for biospecific ligand immobilization was optimized for thin film polyimide spin-coated silicon wafers, of which the polyimide film serves as a wave guiding layer in evanescent wave photonic biosensors. This type of optical sensors make great demands on the materials involved as well as on the layer properties, such as the optical quality, the layer thickness and the surface roughness. In this work we realized the binding of a 3-mercaptopropyl trimethoxysilane on an oxygen plasma activated polyimide surface followed by subsequent derivatization of the reactive thiol groups with maleimide-PEG(2)-biotin and immobilization of streptavidin. The progress of the functionalization was monitored by using different fluorescence labels for optimization of the chemical derivatization steps. Further, X-ray photoelectron spectroscopy and atomic force microscopy were utilized for the characterization of the modified surface. These established analytical methods allowed to derive information like chemical composition of the surface, surface coverage with immobilized streptavidin, as well as parameters of the surface roughness. The proposed functionalization protocol furnished a surface density of 144 fmol mm(-2) streptavidin with good reproducibility (13.9% RSD, n=10) and without inflicted damage to the surface. This surface modification was applied to polyimide based Mach-Zehnder interferometer sensors to realize a real-time measurement of streptavidin binding validating the functionality of the MZI biosensor. Subsequently, this streptavidin surface was employed to immobilize biotinylated single-stranded DNA and utilized for monitoring of selective DNA hybridization. These proved the usability of polyimide based evanescent photonic devices for biosensing application., (Copyright © 2011 Elsevier B.V. All rights reserved.)