Search

This study presents a novel multilayer structure of parallel coupled‐line bandpass filtercentered at 2.42 GHz with a fractional bandwidth value of approximately 19.4%. The designed filter can suppress harmonics with an appropriate frequency response by incorporating different techniques based on the multilayer technique. A combination of different techniques such as radial microstrip stubs and defected ground structure (DGS) and defected microstrip structure techniques are employed to suppress harmonics up to 5f0. These techniques are used in two layers to suppress up to 5f0. In addition, in this study, the effects of different parameters, such as the width of slot‐line DGS, the angle of diagonal line slots in the upper layer, and the air gap between the two layers on the filter performance, are investigated. To verify the correct circuit operation, the designed filter is implemented and tested. The measurement results of the proposed filter are compared with the simulation results. [ABSTRACT FROM AUTHOR]

In this paper, a new microstrip low-pass filter will be presented for achieving high ability to choose wide stopband and suitable operation. This filter is built after design and simulation, and results of measurement will confirm the design accuracy. The results show that the overall performance of the recommended structure is improved in terms of physical dimensions, sharpness of response, and width of stopband, compared to old structures. Cut-off frequency of filter is 1.1 GHz. The stopband is so wide, and the amount of weakness in this band is equal to −20 dB. Roll-off rate parameter of the proposed filter is equal to 240 dB/GHz. This means that changing filter condition moves rapidly from passing to stop state. Size of proposed filter is small and equal to 27 mm × 16 mm. Results of simulation and measurement of the fabricated sample exhibit the same reaction. [ABSTRACT FROM AUTHOR]

The stepped‐impedance combline band pass filter (BPF) with novel input and output networks based on a new proposed J‐inverter, which increases the center frequency tuning range with constant bandwidth (BW), is discussed. The even and odd mode analysis shows that the stepped resonators provide the necessary conditions for the appropriate coupling coefficient to keep the BW constant. In order to create an appropriate quality factor, the new proposed J‐inverter is used. In the frequency response of the stopband region, three transition zeros (TZs) are generated, which two of TZs are controllable. The proposed tunable BPF has been fabricated on RO4003 substrate with a dielectric constant of 3.38 and 0.813 mm thickness. The size of the filter is compact and is only 0.31λg×0.1λg$$ 0.31{\lambda}_{\mathrm{g}}\times 0.1{\lambda}_{\mathrm{g}} $$, where λg$$ {\lambda}_{\mathrm{g}} $$ is the guided wavelength at the lower center frequency. The center frequency is equal to 1.723 GHz and a frequency tuning range from 1.2 GHz to 2.246 GHz with 100 MHz constant 3 dB absolute BW, the insertion loss of 1.4–3.17 dB and return loss of 17.8–25.9 dB is achieved. [ABSTRACT FROM AUTHOR]