Search

Satellite navigation spoofing technology has become a hotspot of interference technology research because of its significant threat and high concealment. In a spoofing scenario, suppressive interference is typically used to ensure that the target receiver sensor is in the unlocked and reacquisition state, and then spoofing is implemented. This method has a high feasibility, and the power of the spoofing signal affects the concealment and efficiency of spoofing. Currently, there is limited research involving the GNSS spoofing signal power control. Moreover, there is no systematic complete power control scheme, most of which is limited to qualitative or simulation, and the actual application effect is still unclear. Therefore, a new GNSS spoofing signal power control algorithm under the power constraints of the receiver sensor in the acquisition phase and the subsequent control is proposed. The experimental platform is designed to prove that compared with the conventional spoofing signal high power control algorithm, the new GNSS spoofing signal power control algorithm shortens Doppler frequency fluctuation time by 72.2% and reduces the range by 75.9%. The carrier-to-noise ratio of the received signal is less than the threshold of the receiver sensor, and the range of three-dimensional coordinates of Earth-Centered, Earth-Fixed (ECEF) is significantly reduced during the spoofing signal taking over receiver sensor, this shows that the new design of the GNSS spoofing signal power control algorithm can make spoofing behavior more hidden, and it will make it more difficult for the target receiver sensor to detect spoofing behavior. The designed algorithm can take over the receiver sensor stealthily with the help of suppressing interference and then pull the bias positioning results, which has good feasibility and effectiveness. [ABSTRACT FROM AUTHOR]

When satellite navigation terminal sensors encounter malicious signal spoofing or interference, if attention is not paid to improving their anti-spoofing ability, the performance of the sensors will be seriously affected. The global navigation satellite system (GNSS) spoofing has gradually become a research hotspot of the jammer because of its great harm and high concealment. In the face of more and more sensors coupling GNSS and inertial measurement unit (IMU) to varying degrees and configuring a variety of anti-spoofing techniques to effectively detect spoofing, even if the spoofer intends to gradually pull the positioning results, if the spoofing strategy is unreasonable, the parameters of the coupled filter output and spoofing observation measurement will lose their rationality, which will lead to the spoofing being detected. To solve the above problems, in order to effectively counter the non-cooperative target sensors of assembling loosely coupled GNSS/IMU using GNSS spoofing, based on the analysis of the influence mechanism of spoofing on the positioning of loosely coupled GNSS/IMU, a slowly varying spoofing algorithm to avoid loosely coupled GNSS/IMU with multiple anti-spoofing techniques is proposed in this paper, and a measurement deviation determination method to avoid multiple anti-spoofing techniques is proposed, which can gradually pull the positioning results of the coupled system and successfully avoid the detection of anti-spoofing techniques of innovation sequence monitoring and a rationality check on parameters. Simulation experimental results show that the proposed algorithm gradually changes the positioning of loosely coupled GNSS/IMU, the north and east displacements achieve the purpose of spoofing, and error with expected offset is −0.2 m and 2.3 m, respectively. Down displacement also basically achieves the purpose of spoofing, and error with the expected offset is 13.2 m. At the same time, the spoofer avoids the detection of multiple anti-spoofing techniques, does not trigger the system alarm, and realizes the purpose of spoofing; thus, the effectiveness and high concealment of the spoofing algorithm are verified. [ABSTRACT FROM AUTHOR]