Search

In-situ Neutron Diffraction and Small-Angle Neutron Scattering (SANS) are employed for the first time simultaneously in order to reveal the interaction between the austenite to ferrite phase transformation and the precipitation kinetics during isothermal annealing at 650 and at 700 °C in three steels with different vanadium (V) and carbon (C) concentrations. Austenite-to-ferrite phase transformation is observed in all three steels at both temperatures. The phase transformation is completed during a 10 h annealing treatment in all cases. The phase transformation is faster at 650 than at 700 °C for all alloys. Additions of vanadium and carbon to the steel composition cause a retardation of the phase transformation. The effect of each element is explained through its contribution to the Gibbs free energy dissipation. The austenite-to-ferrite phase transformation is found to initiate the vanadium carbide precipitation. Larger and fewer precipitates are detected at 700 than at 650 °C in all three steels, and a larger number density of precipitates is detected in the steel with higher concentrations of vanadium and carbon. After 10 h of annealing, the precipitated phase does not reach the equilibrium fraction as calculated by ThermoCalc. The external magnetic field applied during the experiments, necessary for the SANS measurements, causes a delay in the onset and time evolution of the austenite-to-ferrite phase transformation and consequently on the precipitation kinetics.

In the present study, cold-rolled low-carbon steel is annealed at three different conditions: 700 oC for 0 s, 800 oC for 0 s and 800 oC for 2 min at the heating rate of ~10 oC/s. Recrystallization behaviour on sample surface is studied using a heated stage Scanning Electron Microscopy and Electron Backscattered Diffraction. For the lower annealing temperature of 700 oC with no dwell, almost no recrystallization is observed and microstructure resembles the as-received deformed material with the exception of occasional sub-micron sized nuclei. For the annealing conditions of 800 oC 0 s and 800 oC 2 min, onset and evolution of recrystallization is observed in-situ as a function of the initial as-cold rolled texture. Slower recovery rate of alpha fibre than gamma fibre is observed and confirmed by lower drop in average geometrically necessary dislocation (GND) density for un-recrystallized alpha fibres (1.1E+14 m-2 for 700 oC 0 s , 1.4E+14 m-2 for 800 oC 0 s and 4.5E+14 m-2 for 800 oC 2 min) than for un-recrystallized gamma fibre grains (3.0E+14 m-2 for 700 oC 0 s , 6.2E+14 m-2 for 800 oC 0 s and 9.8E+14 m-2 for 800 oC 2 min) during annealing. Strong gamma texture in recrystallized matrix is found for annealing conditions of 800 oC 0 s and 800 oC 2 min. From TEM characterisation it was shown that sub-grain boundaries are decorated with fine precipitates (diameter d < 15 nm) of titanium-vanadium carbides (Ti,V)C for the annealing condition of 700 oC 0 s, which suggests that these precipitates play a major overall role in retardation of the recrystallization kinetics.

Nanosteels are used in automotive applications to accomplish resource-efficiency while providing high-tech properties. Quantitative data and further understanding on the precipitation kinetics in Nanosteels can contribute to fulfil this goal. Small-Angle Neutron Scattering measurements are performed on a Fe-C-Mn-V steel, previously heat-treated in a dilatometer at 650°C for several holding times from seconds to 10 hours. The evolution of the precipitate volume fraction, size distribution and number density is calculated by fitting the experimental Small-Angle Neutron Scattering curves. The effect of phase transformation on precipitation kinetics is also discussed. Complementary Transmission Electron Microscopy, Scanning Electron Microscopy and Inductively Coupled Plasma Optical Emission Spectroscopy measurements are performed to support the Small-Angle Neutron Scattering data analysis.

The lowest excited singlet states of 4-(dimethylamino)-4‘-cyanostilbene (DCS), 4-(dimethylamino)-4‘-nitrostilbene (DANS), and 4-di(hydroxy-ethyl)amino-4‘-nitrostilbene (DANS-diol) have been investigated by high-resolution fluorescence excitation and dispersed emission spectroscopy on samples seeded in supersonic expansions. Using ab initio calculations of the harmonic force fields of the electronic ground state as a starting point for the analysis of vibrational modes and frequencies, detailed vibrational assignments of the rich line structure of the S1 ← S0 transition in these three push−pull stilbenes are reported. From the experimental and theoretical analysis, it becomes apparent that the excitation spectra are dominated by low-frequency vibrational modes of the stilbene-like backbone, albeit that a characterization in terms of trans-stilbene vibrational terminology is not very appropriate. The fluorescence excitation and emission spectra show significant Franck−Condon factors for transitions involvin...