Search

This field study aimed to investigate naturally ventilated bedroom environment and its effects on subjective perception and sleep quality. Totally, 104 healthy subjects living in urban areas of Beijing participated in the study for one night during transition seasons. Bedroom environment parameters, including temperature, relative humidity, and CO2 concentration, were recorded before and during sleep. Objective sleep quality was measured by Fitbit Alta 2, a wrist‐type actigraphy sensor. Subjective assessments were collected by paper‐based questionnaires on sleep quality and environmental perceptions. The results showed that neutral temperature for waking state (before sleep) was estimated to be 23.8°C while for sleep state it was 26.5°C. Furthermore, pre‐sleep thermal sensation vote was found to be positively correlated with deep sleep percentage. Indoor air quality was correlated with sleep quality as indicated by statistically significant correlations between odor intensity assessment, air quality acceptability, average nightly CO2 concentration, and measures of sleep quality. For naturally ventilated bedrooms during transition seasons with a mild outdoor climate, present findings suggest that a bedroom with slightly warm pre‐sleep environment than neutral, and with high ventilation as indicated by low indoor CO2 concentration, could be beneficial for sleep quality of residents. [ABSTRACT FROM AUTHOR]

Previous studies have shown that poorly ventilated classrooms can have negative impact on the health of children and school staff. In most cases, schools in Serbia are ventilated naturally. Considering their high occupancy, classroom air quality test determines the level of air pollution, after which it is possible to implement corrective measures. The research presented in this study, was conducted in four schools which are located in different areas and have different architecture designs. Measurements in these schools have been performed during the winter (heating season) and spring (non-heating season) and the following results were presented: indoor air temperature, relative humidity, and carbon dioxide concentration. These results show that the classroom average concentration of carbon dioxide often exceeds the value of 1500 ppm, during its full occupancy, which indicates inadequate ventilation. Measurement campaigns show that carbon dioxide concentration increased significantly from non-heating to heating season in three of the four schools. Analysis of measurements also determined high correlation between relative humidity and carbon dioxide concentration in all schools in winter season. This fact may constitute a solid basis for the fresh air supply strategy. [ABSTRACT FROM AUTHOR]

As most residents spend more than 90% of their time in buildings, acceptable and reasonable control of both indoor thermal comfort and air quality is imperative to ensure occupants' health status and work productivity. However, current control strategies generally take either thermal comfort or indoor air quality as a single loop, rather than the concurrent control of two. To analyze their mutual influence, this study investigated the performance of three multi-control approaches, i.e., proportional integral derivative (PID) control of thermal comfort and a fixed outdoor air ratio, PID control of thermal comfort and design outdoor air rate, and PID control of thermal comfort and occupancy-based demand-controlled ventilation. As a pilot study, three typical control methods were implemented to a multi-zone building via OpenModelica modeling. The results indicate that indoor air temperature can be well-maintained under three control methods, however, the CO2 concentration under the fixed outdoor air ratio was over 1000 ppm, leading to poor indoor air quality. The control strategy with the design outdoor air rate could not properly ensure the CO2 concentration, due to the over-ventilated or under-ventilated phenomena, subsequently resulting in unnecessary energy waste. The occupancy-based demand controlled ventilation could maintain the CO2 concentration under the set-point with an intermediate power energy utilization. [ABSTRACT FROM AUTHOR]