Search

Toxicity of particulate matter (PM) depends on its sources, size and composition. We identified PM 10 sources and determined their contribution to oxidative potential (OP) as a health proxy for PM exposure in an Alpine valley influenced by cement industry. PM 10 filter sample chemical analysis and equivalent black carbon (eBC) were measured at an urban background site from November 2020 to November 2021. Using an optimized Positive Matrix Factorization (PMF) model, the source chemical fingerprints and contributions to PM 10 were determined. The OP assessed through two assays, ascorbic acid (AA) and dithiothreitol (DTT), was attributed to the PM sources from the PMF model with a multiple linear regression (MLR) model. Ten factors were found at the site, including biomass burning (34, 40 and 38% contribution to annual PM 10 , OP AA and OP DDT , respectively), traffic (14, 19 and 7%), nitrate- and sulphate-rich (together: 16, 5 and 8%), aged sea salt (2, 2 and 0%) and mineral dust (10, 12 and 17%). The introduction of innovative organic tracers allowed the quantification of the PM primary and secondary biogenic fractions (together: 13, 8 and 21%). In addition, two unusual factors due to local features, a chloride-rich factor and a second mineral dust-rich factor (named the cement dust factor) were found, contributing together 10, 14 and 8%. We associate these two factors to different processes in the cement plant. Despite their rather low contribution to PM 10 mass, these sources have one of the highest OPs per µg of source. The results of the study provide vital information about the influence of particular sources on PM 10 and OP in complex environments and are thus useful for PM control strategies and actions., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2024 The Authors. Published by Elsevier Ltd.. All rights reserved.)

The present study highlights the importance of examining the contribution of Saharan dust (SD) sources not only in terms of overall mass contribution but also in terms of composition, size distribution and inhaled dose. The effect of SD intrusions on PM and the respective major and trace metals mass concentrations and size distributions was investigated in a suburban site in Athens, Greece. SD events were associated, on average, with lower boundary layer heights (BLH) compared to the non-Sahara (nSD) dust days. During SD events, PM 1-10 concentrations showed an increasing trend with increasing atmospheric BLH, in contrary to the fine PM (PM 1 ). Generally, increased PM 1 and CO (i.e. anthropogenic origin) levels were observed for BLH lower than around 500 m. The average contribution of SD to PM 10 and PM 2.5 mass concentration was roughly equal to 30.9% and 19.4%, respectively. The mass size distributions of PM and specific major and trace elements (Na, Al, Si, S, Cl, K, Ca, Fe, and Zn) displayed a somewhat different behavior with respect to the mass origin (Algeria-Tunisia vs Libya-Egypt), affecting in turn the regional deposition of inhaled aerosol in the human respiratory tract (HRT). The average PM deposited mass in the upper and lower HRT was 80.1% (Head) and 26.9% (Lung; Tracheobronchial and Pulmonary region) higher for SD days than for nSD days. Higher doses were estimated in the upper and lower HRT for the majority of the elements, when SD intrusions occurred, supporting the increasingly growing interest in exploring the health effects of SD. Only the mass deposition for S, and Na in the lower HRT and Zn in the upper HRT was higher in the case of nSD., (Copyright © 2022 Elsevier Ltd. All rights reserved.)

The study aims to assess the differences between the chemical profiles of the major anthropogenic and natural PM sources in two areas with different levels of urbanization and traffic density within the same urban agglomeration. A traffic site and an urban background site in the Athens Metropolitan Area have been selected for this comparison. For both sites, eight sources were identified, with seven of them being common for the two sites (Mineral Dust, non-Exhaust Emissions, Exhaust Emissions, Heavy Oil Combustion, Sulfates & Organics, Sea Salt and Biomass Burning) and one, site-specific (Nitrates for the traffic site and Aged Sea Salt for the urban background site). The similarity between the source profiles was quantified using two statistical analysis tools, Pearson correlation (PC) and Standardized Identity Distance (SID). According to Pearson coefficients five out of the eight source profiles present high (PC > 0.8) correlation (Mineral Dust, Biomass Burning, Sea Salt, Sulfates and Heavy Oil Combustion), one presented moderate (0.8 > PC > 0.6) correlation (Exhaust) and two low/no (PC < 0.6) correlation (non-Exhaust, Nitrates/Aged Sea Salt). The source profiles that appear to be more correlated are those of sources that are not expected to have high spatial variability because there are either natural/secondary and thus have a regional character or are emitted outside the urban agglomeration and are transported to both sites. According to SID four out of the eight sources have high statistical correlation (SID < 1) in the two sites (Mineral Dust, Sea salt, Sulfates, Heavy Oil Combustion). Biomass Burning was found to be the source that yielded different results from the two methodologies. The careful examination of the source profile of that source revealed the reason for this discrepancy. SID takes all the species of the profile equally into account, while PC might be disproportionally affected by a few numbers of species with very high concentrations. It is suggested, based on the findings of this work, that the combined use of both tools can lead the users to a thorough evaluation of the similarity of source profiles. This work is, to the best of our knowledge, the first time a study is focused on the quantitative comparison of the source profiles for sites inside the same urban agglomeration using statistical indicators., (Copyright © 2020 Elsevier Inc. All rights reserved.)

This work presents the results of a PM2.5 source apportionment study conducted in urban background sites from 16 European and Asian countries. For some Eastern Europe and Central Asia cities this was the first time that quantitative information on pollution source contributions to ambient particulate matter (PM) has been performed. More than 2200 filters were sampled and analyzed by X-Ray Fluorescence (XRF), Particle-Induced X-Ray Emission (PIXE), and Inductively Coupled Plasma Mass Spectrometry (ICP-MS) to measure the concentrations of chemical elements in fine particles. Samples were also analyzed for the contents of black carbon, elemental carbon, organic carbon, and water-soluble ions. The Positive Matrix Factorization receptor model (EPA PMF 5.0) was used to characterize similarities and heterogeneities in PM2.5 sources and respective contributions in the cities that the number of collected samples exceeded 75. At the end source apportionment was performed in 11 out of the 16 participating cities. Nine major sources were identified to have contributed to PM2.5: biomass burning, secondary sulfates, traffic, fuel oil combustion, industry, coal combustion, soil, salt and "other sources". From the averages of sources contributions, considering 11 cities 16% of PM2.5 was attributed to biomass burning, 15% to secondary sulfates, 13% to traffic, 12% to soil, 8.0% to fuel oil combustion, 5.5% to coal combustion, 1.9% to salt, 0.8% to industry emissions, 5.1% to "other sources" and 23% to unaccounted mass. Characteristic seasonal patterns were identified for each PM2.5 source. Biomass burning in all cities, coal combustion in Krakow/POL, and oil combustion in Belgrade/SRB and Banja Luka/BIH increased in Winter due to the impact of domestic heating, whereas in most cities secondary sulfates reached higher levels in Summer as a consequence of the enhanced photochemical activity. During high pollution days the largest sources of fine particles were biomass burning, traffic and secondary sulfates., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2020 The Authors. Published by Elsevier Ltd.. All rights reserved.)

In an attempt to investigate the traffic-impacted vertical aerosols profile and its relationship with potential carcinogenicity and/or mutagenicity, samples of different sized airborne particles were collected in parallel at the 1st and 5th floor of a 19 m high building located next to one of the busiest roads of Athens. The maximum daily concentrations were 65.9, 42.5 and 38.5 μg/m 3 , for PM 10 , PM 2.5 and PM 1 , respectively. The vertical concentration ratio decreased with increasing height verifying the role of the characteristics of the area (1st/5th floor: 1.21, 1.13, 1.09 for PM 10 , PM 2.5 and PM 1 , respectively). Chemically, strengthening the previous hypothesis, the collected particles were mainly carbonaceous (68%-93%) with the maximum budget of the polyaromatic hydrocarbons being recorded near the surface (1st/5th floor: 1.84, 1.07, 1.15 for PM 10 , PM 2.5 and PM 1 , respectively). The detected PM-bound PAHs along with the elements as well as the carbonaceous and ionic constituents were used in a source apportionment study. Exhaust and non-exhaust emissions, a mixed source of biomass burning and high temperature combustion processes (natural gas, gasoline/diesel engines), sea salt, secondary and soil particles were identified as the major contributing sources to the PM pollution of the investigated area. With respect to the health hazards, the calculation of the Benzo[a]Pyrene toxicity equivalency factors underlined the importance of the height of residence in buildings for the level of the exposure (1st/5th floor: B[a]P TEQ : 1.82, 1.12, 1.10, B[a]P MEQ : 1.85, 1.13, 1.09 for PM 10 , PM 2.5 and PM 1 , respectively). Finally, despite its verified significance as a surrogate compound for the mixture of the hydrocarbons (its contribution up to 72%, 79% on the level of the 1st and 5th floor, respectively), the importance of the incorporation of PAH species in addition to B[a]P when assessing PAH toxicity was clearly documented., (Copyright © 2018 Elsevier B.V. All rights reserved.)

The unprecedented growth in aviation during the last years has resulted in a notable increase of local air pollution related to airports. The impacts of aviation on air quality can be extremely high particularly around airports serving remote insular regions with pristine atmospheric environments. Here we report measurements that show how the atmospheric aerosol is affected by the activity at a small airport in a remote region. More specifically, we provide measurements performed at the airport of Mytilene, Greece, a regional yet international airport that serves the entire island of Lesvos; the third largest island of the country. The measurements show that the activity during landing, taxiing and take-off of the aircrafts accounted for up to a 10-fold increase in particulate matter (PM) mass concentration in the vicinity of the airport. The number concentration of particles having diameters from 10 to 500nm also increased from ca. 4×10 2 to 8×10 5 particlescm -3 , while the mean particle diameter decreased to 20nm when aircrafts were present at the airport. Elemental analysis on particle samples collected simultaneously at the airport and at a remote site 3km away, showed that the former were significantly influenced by combustion sources, and specifically from the engines of the aircrafts. Our results show that despite their small size, local airports serving remote insular regions should be considered as important air pollution hotspots, raising concerns for the exposure of the people working and leaving in their vicinities to hazardous pollutants., (Copyright © 2017 Elsevier B.V. All rights reserved.)

The elemental composition of water-soluble and acid-soluble fractions of PM2.5 samples from two different Greek cities (Patras and Megalopolis) was investigated. Patras and Megalopolis represent different environments. Specifically, Patras is an urban environment with proximity to a large port, while Megalopolis is a small city located close to lignite power plants. Both cities can serve as a representative example of European cities with similar characteristics. The concentration of 14 elements (As, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, Fe, Sr, Ti, V and Zn) was determined in each fraction by ICP-MS. Microwave assisted digestion was used to digest the samples using a mixture of HNO3 and HF. For the determination of the water soluble fraction, water was chosen as the simplest and most universal extraction solvent. For the validation of the extraction procedure, the recoveries were tested on two certified reference materials (NIST SRM 1648 Urban Particulate Matter and NIST 1649a Urban Dust). Results showed that Zn has the highest total concentration (273 and 186 ng/m(3)) and Co the lowest (0.48 and 0.23 ng/m(3)) for Patras and Megalopolis samples, respectively. Nickel with 65% for Patras and As with 49% for Megalopolis displayed the highest solubility, whereas Fe (10%) and Ti (2%) the lowest ones, respectively., (Copyright © 2014 Elsevier B.V. All rights reserved.)