Search

A three-dimensional (3D) model of a high-power ultrasonic, composite, unidirectional transducer is proposed in this paper. The proposed 3D Matlab/Simulink model of the composite transducers predicts the thickness and the radial modes of oscillation as well as their mutual couplings. This longitudinal, prestressed, asymmetrical, piezoelectric transducer, which consists of two active piezoelectric layers, front, back and central oscillating metal mass, is realized. Due to its special structure, the central mass is not bounded using a bolt and performs unidirectional piston motion as compression and expansion occur in cycles keeping the axial dimension of the transducer roughly constant because of mutually opposite polarization of active elements. The electromechanical equivalent circuit of the transducer, representing one-dimensional (1D) model, is derived first and is also presented in this paper, while the resonance frequency equation is obtained analytically. Few composite transducers are designed and manufactured. Their resonance frequencies are measured and compared with the analytically obtained results for a large number of electrical connection combinations. In order to demonstrate the capabilities and limitations of the 1D model, comparison with the results from the 3D model are made. Results show that the measured frequencies are in good correspondence with the analytically obtained from 1D model only for the thickness modes and from the 3D model for the thickness and the radial modes of oscillation and their mutual coupling.

In this paper an overview of temperature sensors used for PV module temperature measurement is presented. Issues with contact temperature sensors, in the process of PV module temperature measurement, are explained in detail. Brief overview of related research is given, which includes analysis of measurement process and the presented results. Thorough research is conducted based on few commercially available temperature sensors, which include four contact and a single non-contact sensor. Measurement accuracy of all employed sensors was evaluated using a high-quality thermal imaging camera and the obtained measurement results are also presented. Temperature measurement, PV module, sensors, thermal imaging camera.

The paper provides an overview of coreless open-loop current transducers based on Hall effect sensor CSA-1V. Depending on the implementation method and current range, the presented transducers are divided in the four groups. The transducers are capable to measure AC and DC currents ranging from several tens of miliamperes up to several hundreds of amperes. Methods for resolving issues with the skin effect and stray magnetic fields are also presented including the experimental test results. Some of these methods are novelty and have never been presented in literature.

A low-cost teslameter based on a Hall effect sensor MLX90242 is proposed in this paper. The proposed teslameter is built around a PIC18F4550 microcontroller and it can measure magnetic flux density in the range between -55 mT and 55 mT. Temperature stability of measurements originates from the MLX90242 sensor itself. In order for the proposed transducer to be accurate, it has undergone a calibration procedure using a highly accurate teslameter employed as reference instruments and high-quality variable-field electromagnet. The proposed teslameter can store measurements on a PC via built-in USB communication. [Project of the Serbian Ministry of Education, Science and Technological Development, Grant no. III43014]

Metal-endings are integral part of different ultrasonic sandwich transducers. In this paper a new Matlab/Simulink 3D model of the finite metal rings and discs of various dimensions is realized. With this model, which describes both the thickness and the radial resonant modes, and the coupling between them, mechanical impedance of the sample can be easily computed. Resonance frequency-length curves for rings and disks with various materials and for different selected dimensions are given. Also, comparisons of the different approaches in determining of their resonant frequencies are shown. The proposed Matlab/Simulink model requires simpler implementation than other analytical models. That enabled modifying of 1D theory and simplified modelling and projecting of the ultrasonic sandwich transducers with short-endings. Finally, the computed and experimental results are compared. [Projekat Ministarstva nauke Republike Srbije, br. TR33035, br. III43014 i br. OI172057]