Search

Landfill leachate is a liquid generated due to rainwater percolation through the waste in a landfill or dumping site that may contain high levels of organic matter, both biodegradable and non-biodegradable, which are the major sources of water pollution. Chemical oxygen demand (COD) and Ammoniacal Nitrogen (NH

When the inevitable generation of waste is considered as hazardous to health, damaging ecosystem to our environment, it is important to develop an innovative technologies to remediate pollutant sources for the safety and environmental protection. The development of adsorption technique for the reduction of extremely effective pollutants in this regard. Green mussel and zeolite mixing media were investigated for the reduction of the concentration of organic constituents (COD) and ammoniacal nitrogen from leachate. The leachate treatability was analyzed under various stages of treatment parameter, namely mixing ratio, shaking speed, contact time, and pH. Both adsorbent were sieve values in between 2.00-3.35 mm particle size. The optimum pH, shaking speed, contact time, and mixing ratio were determined. Leachate samples were collected from influent untreated detention pond at Simpang Renggam landfill site in Johor, Malaysia. The result of leachate characterization properties revealed that non-biodegradability leachate with higher concentrations of COD (1829 mg/L), ammoniacal nitrogen (406.68 mg/L) and biodegradability value (0.08) respectively. The optimal reduction condition of COD and ammoniacal nitrogen was obtained at 200 rpm shaken speed, 120 minute shaken time, optimum green mussel and zeolite mix ratio was 2.0:2.0, and pH 7. The isothermic study of adsorption shows that Langmuir is best suited for experimental results in terms of Freundlich model. The mixing media also provided promising results to treating leachate. This would be greatly applicable in conventionally minimizing zeolite use and thereby lowering the operating cost of leachate treatment.

Kitchen wastewater that is discharged to the environment is one of the contributing factors to water pollution in developing countries. Adsorption is one of the emerging technology of biological treatments that is an environmentally friendly for the removal of pollutants. Banana trunk fiber with chitosan as an adsorbent was investigated for minimizing COD and ammonia from the kitchen wastewater. The raw kitchen wastewater sample used in the study was collected from the Arked food court located in Universiti Tun Hussein Onn Malaysia in Johor (Malaysia). The optimum of ratio, pH, shaking speed and contact time for COD and ammonia removal were determined. The result indicated the optimum mix ratio of fiber with chitosan, pH, shaking speed and contact time respectively was 50:50, pH 7, 125 rpm and 120 minutes based on the adsorption of COD (87%) and ammonia (90%) by banana trunk fiber with chitosan. Kinetic study of the results gave a pseudo-second order the R2 was closed to unity which was 0.998. It will significantly be considered for efficient removal of organic and nutrient pollutants present in kitchen wastewater treatment.

The rapid generation rate of solid waste is due to the increasing population and industrialization. Nowadays, solid waste has been a major concerning problem in handling and disposal thus adsorption treatment process has been introduced which is an effective and low-cost method in removing organic and inorganic compounds from leachates such as chemical oxygen demand (COD) and ammoniacal nitrogen (NH

Micro-peat (M-P) was demonstrated in the present study as a potential low cost natural adsorbent for the removal of COD and ammoniacal nitrogen (NH3-N) from landfill leachate. A series of batch experiments were carried out under fixed conditions and the influence of mixture ratio was investigated. The characteristics of leachate were then determined. Results indicated that leachate is non-biodegradable with high concentration of COD (2739.06 mg/L), NH3-N (1765.34 mg/L) and BOD5/COD ratio (0.09). The optimum ratio for activated carbon (AC) and M-P in the removal of COD and NH3-N obtained were at 2.5:1.5 (87%) and 1.0:3.0 (65%) respectively. The low-cost natural adsorbent used in the present investigation is an attractive alternative to the conventional adsorbent (AC). Thus, M-P can be appropriated for use in leachate treatment that could be cost-effective due its local availability and adsorption property.

Pulp and paper production from wood material as their main resources have a total capacity about more than one million tons per year. Malaysia has a high scale of deforestation based on the main resource for pulp and paper-based industry. Malaysia as its rate is accelerating faster than any other tropical countries in the world. This problem also affects the economic losses of some countries that face deforestation. To overcome this, Napier grass as a substitute material from non-wood material had been choose for pulp and papermaking industry. This study through the full fibre analysis and morphological characterization, pulpability at kappa number via soda-AQ pulping and the characteristic. These conclude that Napier grass had a high percentage of pulp yields; with a low screening rejects; good mechanical properties by TAPPI method. Thus, Napier grass has a potential to be substitute material for becoming waste-wealth product especially for Malaysia’s pulp and papermaking industry.

The potential of Empty Fruit Bunch obtained from palm oil tree as a low-cost adsorbent is a sustainable approach in wastewater treatment. The objective this study to investigate the capability of EFB for removal colour from natural rubber wastewater as well as the influence of adsorbent dosage, pH, shaking speed and contact time. The results of the analysis show that all selected factors exhibit significant effect on removal of colour. Maximum removal (87.1%) for colour was achieved at 3.5 g of adsorbent dosage, pH 7, 150 rpm of shaking speed, 120 min of contact time. The Langmuir isotherm (R2= 0.9913) described colour adsorption slightly better than the Freundlich isotherm (R2= 0.9805), suggesting a monolayer adsorption behavior of the adsorption processes

Natural rubber processing wastewater contains high concentration of organic compound, colour, nitrogen, and other contaminants. This study evaluated a chitosan bead as an adsorbent in adsorption process for natural rubber wastewater treatment. The effects of adsorbent dosage, pH, shaking speed and contact time and adsorption isotherm on colour adsorption onto chitosan beads were evaluated using batch experiments. Meanwhile, Langmuir and Freundlich isotherm models were used to validate the experimental data. Maximum removal of 71.5%, for colour was observed for an adsorbent dosage 4.5 g, pH 7, and shaking speed 150 rpm. Equilibrium was achieved in 120 min. The equilibrium data were fitted to Langmuir isotherm model when compared with Freundlich isotherm models.

The optimal conditions for the reduction of COD and NH3-N using cockle shells (CS) from a stabilised landfill effluent were analyzed. The influence of two variables (adsorbent dosage and pH) were analysed through the application of response surface methodology (RSM) and central composite design (CCD). Quadratic models were developed for the removals of COD and NH3-N parameters. The optimum conditions for removal of 65.6% and 53.6% for COD and NH3-N respectively was achieved at pH 6.34, adsorbent dosage of 20.21 g having 0.888 desirability value. The model F-value obtained for NH3-N removal Prob. > F value of 0.0001 with F-value of 104.21 was obtained. Similarly the Prob. > F value of < 0.0001 for COD with F-value of 82.74 was obtained, these P-values confirmed the significance of the model. The predicted response versus the experimental response depicted that the experimental data were relatively close to the predicted data. Thus, the generated models significantly enclosed the correlation between the process variables and the response. GMT Detect languageAfrikaansAlbanianArabicArmenianAzerbaijaniBasqueBelarusianBengaliBosnianBulgarianCatalanCebuanoChichewaChinese (Simplified)Chinese (Traditional)CroatianCzechDanishDutchEnglishEsperantoEstonianFilipinoFinnishFrenchGalicianGeorgianGermanGreekGujaratiHaitian CreoleHausaHebrewHindiHmongHungarianIcelandicIgboIndonesianIrishItalianJapaneseJavaneseKannadaKazakhKhmerKoreanLaoLatinLatvianLithuanianMacedonianMalagasyMalayMalayalamMalteseMaoriMarathiMongolianMyanmar (Burmese)NepaliNorwegianPersianPolishPortuguesePunjabiRomanianRussianSerbianSesothoSinhalaSlovakSlovenianSomaliSpanishSundaneseSwahiliSwedishTajikTamilTeluguThaiTurkishUkrainianUrduUzbekVietnameseWelshYiddishYorubaZulu AfrikaansAlbanianArabicArmenianAzerbaijaniBasqueBelarusianBengaliBosnianBulgarianCatalanCebuanoChichewaChinese (Simplified)Chinese (Traditional)CroatianCzechDanishDutchEnglishEsperantoEstonianFilipinoFinnishFrenchGalicianGeorgianGermanGreekGujaratiHaitian CreoleHausaHebrewHindiHmongHungarianIcelandicIgboIndonesianIrishItalianJapaneseJavaneseKannadaKazakhKhmerKoreanLaoLatinLatvianLithuanianMacedonianMalagasyMalayMalayalamMalteseMaoriMarathiMongolianMyanmar (Burmese)NepaliNorwegianPersianPolishPortuguesePunjabiRomanianRussianSerbianSesothoSinhalaSlovakSlovenianSomaliSpanishSundaneseSwahiliSwedishTajikTamilTeluguThaiTurkishUkrainianUrduUzbekVietnameseWelshYiddishYorubaZulu Text-to-speech function is limited to 200 characters Options : History : Feedback : DonateClose

Leachate is a liquid generated due to rainwater percolation through the wastes in a landfill or dumping site that may contain high levels of organic matter including both biodegradable and non-biodegradable which major source of water pollution. In this research work, landfill leachate has been characterized and found to contain very high COD and color. Adsorption process was performed to find out the performance of different combinations ratio between limestone (LS) and zeolite (ZEO). The removal efficiencies of different ratios were examined for reduction of COD and color. The optimum mixture ratio of adsorbents (LS:ZEO) at 10:30 and 15:25 were found to be more effective in reducing COD and color respectively as compared with the use of individual media. The highest removal percentage were found at approximately 55% of COD and 76% of color with 120 minutes of contact time, 200 rpm in shaking speed at pH7. The Langmuir adsorption isotherm model exhibited a better fit with high correlation R2=0.9991 for COD and R2=0.9827 for (color) respectively, which implies that the adsorption of leachate in this study onto LS-ZEO is homogeneous with monolayer. It was observed that limestone and zeolite mixture provides an alternative medium for removing COD and color at a considerably lower cost.

Plant waste such as Delonix Regia Pods (DRP) have the potential to be used as adsorbents. A study of lignocellulose delonix regia pods was carried to assess ammoniacal nitrogen removal from natural rubber wastewater. Sample wastewater was taken from the rubber processing industry and characterization was carried out. Outcomes from the analysis shows that the ammoniacal nitrogen concentration was 66 mg/L and higher than the recommended wastewater discharge standards. Batch experiments were conducted on the effect of dose, pH, shaking speed and contact time parameters for optimum condition. The results revealed that the optimal dosage, pH, shaking speed and contact time is 4.5 g, pH 8, 150 rpm and 120 minutes with ammoniacal nitrogen removal efficiency of 74.3 % and the adsorption capacity of 1.22 mg/g. Pseudo second order kinetic model was found to fit the data better and the R2 obtained was 0.9992. From the study, it can be concluded that the media can be used for the removal of ammoniacal nitrogen in natural rubber wastewater and subsequently reduce environmental pollution. Hence, it can be sustainable and environmentally friendly.

The agriculture waste material can give benefit to many production industries. The studied crop is corn (Zea Mays)stalk. The objective of this work was to analysis the chemical composition; to study chemical pulping and papermaking properties of corn stalk and; to investigate the fiber morphology of properties of those crops. Firstly, the chemical composition of corn stalk were determined and compared with other non-woods. After that, chemical corn stalk was conducted in this analysis followed the physical and mechanical properties. The result showed that, corn stalk have cellulose (39.0%) and lignin content is the lowest (7.3%) content rather than other composition. In chemical pulping, reached high pulp yields had been produced and the strength properties: tear index, tensile index, burst and fold verified that they were of an acceptable quality for papermaking. This crop morphology was observed by Scanning Electron Microscopic (SEM), which showed a condensed composition of fiber structure. This study can developed a friendly product and promote the green technology, suitable to be used as an alternative pulp in paper making industry.Keywords:Fiber, Corn stalk, Composition, Green technology, Pulp and paper making.

Sanitary landfills are important means of disposing municipal solid waste in developing countries. However, these landfills are associated with the generation of leachate, which if untreated may pose severe public health risk and may damage the ecosystem in the long term. In this study, cockle shells were explored as an adsorbent media for the treatment of a stabilized landfill leachate. The optimum shaking speed, pH, and dosage for chemical oxygen demand (COD) parameter removal were investigated using the adsorbent media of particle sizes ranging from 2.00 mm to 3.35 mm. Leachate characteristics were then determined. Results indicated that leachate is non-biodegradable with high concentrations of COD (1763 mg/L), ammonia nitrogen (573 mg/L), and biochemical oxygen demand/COD (0.09). The optimum conditions for shaking were determined at 150 rpm according to the adsorption of COD by the media. Optimum pH and dosage was 5.5 and 35 g/L, respectively. The adsorption isotherms indicated that Langmuir isotherm is better fitted than Freundlich isotherm.

In this chapter, the performance of combined treatment of municipal landfill leachate is reviewed. Although individual physico-chemical treatments are suitable for the removal of heavy metals and hydrolyzation of some organic compounds, a combination of two physico-chemical treatments or physico-chemical and biological is required for optimum treatment of stabilized landfill leachate. A combination of two physico-chemical treatments can give optimum results in removal of recalcitrant organic compounds from stabilized leachate, as reflected by a significant decrease of the COD values after treatment. On the other hand, a combination of physico-chemical and biological treatments is required to achieve effective removal of NH3-N and COD with a substantial amount of biodegradable organic matter. In many cases, physico-chemical treatments are suitable for pre-treatment of stabilized leachate. The objective of this paper is to highlight various types of integrated leachate treatments as it has been difficult to get optimum efficiency from single approached treatment.